Harley-davidson Classic Cruiser 98060-00v
Model Classic Cruiser 98060-00v made by Harley-davidson got 5 consumer complains as well as 1 recall. Consumer complaints with reference to equipment. . There was one recall concerning equipment .
Model 9999
Recalls
| Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| EQUIPMENT - MOTORCYCLE - HELMETS | ||||||||||||||||
| 03E048000 | KBC AMERICA | from 07/01/2001 to 05/31/2002 | E (Equipment) | 39995 | 02/06/2004 | OVSC | KBC AMERICA | 10/01/2003 | 10/14/2003 | 571 | 218 | |||||
| Defect Summary | Harley-davidson classic cruiser half helmet h-d part no. 08060-00v and h-d part no. 98061-00v and midnight flame half helmet h-d part no. 97226-02vx and h-d part no. 97727-02vx. certain classic cruiser, midnight flame, and variants of this helmet style, the phantom flame and the titanium flame, helmets may not comply with some of the impact attenuation and penetration performance test requirements of federal motor vehicle safety standard no. 218, motorcycle helmets. these helmets were manufactured from july 1, 2001, through may 31, 2002. | |||||||||||||||
| Consequence Summary | In the event of a crash, the wearer of the helmet may not be adequately protect and could suffer serious injuries or possibly death. | |||||||||||||||
| Corrective Summary | Kbc will notify customers and provide a replacement helmet which complies to fmvss no. 218 free of charge. | |||||||||||||||
| Notes | Also, customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236). | |||||||||||||||
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| EQUIPMENT | |||
| 06/19/2010 | |||
| While driving a 2007 harley davidson night train. i stopped at a red light on highway 12 in burbank, wa. when the light turned green, and i gave throttle, the drive belt and the drive train where it attaches to the rear hug pulled out. with 3 bolts sheered off laying on the ground. luckily with help i was able to wheel it off to the shoulder without any body getting hurt. | |||
| 05/28/2004 | 2 | ||
| I purchased and installed a harley davidson driver backrest. i followed all directions on the installation. the problem is the back rest does not firmly and securely stay in the base. on 5-28-2004, for the second time, while i was driving the motorcycle, i hit a bump and the back rest suddenly came out of its base, causing me to momentarily loose my balance and almost control of the motorcycle. i have removed the back rest from the motorcycle. the problem as i see it, comes from the tongue and groove locking clasp on the base of the backrest. it is partially made of plastic or a very thin piece of metal and will not secure properly. *la | |||
| EQUIPMENT - ELECTRICAL | |||
| 09/21/2008 | 1 | ||
| Harley-davidson uses the same part on many of their motorcycles which has proven to be defective. this part is the rear brake light switch which is supposed to activate the rear brake light when the rider applies pressure to the rear brake pedal. this part has had to be replaced on hundreds of their products (in some cases more than once as the replacement part has also failed) dating bake several years yet they continue to use it without upgrading it. this is a critical safety issue and we, the owners who have had to pay to replace it, would like an investigation by you as to the possibility of a recall on this issue which we can only hope will lead to a redesign of this part so as to alleviate its ongoing failure. i have no record of actual accidents which have occurred as a result of this parts failure however i do know that we motorcyclists face enough hazards on the road and the failure of our brake light should not be one of them especially when the track record of the part which is supposed to make it happen is faulty. *tr | |||
| EQUIPMENT - MECHANICAL | |||
| 06/19/2010 | |||
| While driving a 2007 harley davidson night train. i stopped at a red light on highway 12 in burbank, wa. when the light turned green, and i gave throttle, the drive belt and the drive train where it attaches to the rear hug pulled out. with 3 bolts sheered off laying on the ground. luckily with help i was able to wheel it off to the shoulder without any body getting hurt. | |||
| 09/11/2004 | 4 | ||
| Harley davidison vrod/ screaming eagle straight exhaust pipes. heat shields are falling off while driving. welds are breaking from vibration. 4 incidents in mississippi alone. we are asking for a recall of these pipes. hd is failing to acknowledge defect in manufacturing.*ak | |||
Car dealers selling
| State | City | Zip | Name | Phone |
|---|---|---|---|---|
| TX | HOUSTON | MANCUSO HARLEY DAVIDISON |