Consumer Complaints


Fail datemilesoccurencesPurchase date
ELECTRICAL SYSTEM
05/02/2001170000005/01/1993
 Distributor failed and caused the vehicle stop on the freeway. when i had the car fixed, the mechanic said all the hondas during this period have the same failure. one year later my 1990 honda civic had the distributor fail also. i am concerned that accidents are occurring because the distributor fails in heavt traffic. it is a manufacture defect. i was told the bearings are low quality and freeze up.
11/04/1996102/01/1993
 Electrical system failed.
ELECTRICAL SYSTEM - ALTERNATOR/GENERATOR/REGULATOR
04/18/1997
 After market part failure of the alternator overcharging, causing the battery to fail. *ak
ELECTRICAL SYSTEM - BATTERY
11/02/200011/01/1992
 While driving on nys thruway, car battery exploded. per ins. co. determined that a diode on the computers circuit board came unsoldered causing the vehicle battery to explode. this electrical breakdown is a manufacturers defect
04/18/1997
 After market part failure of the alternator overcharging, causing the battery to fail. *ak
ELECTRICAL SYSTEM - FUSES AND CIRCUIT BREAKERS
11/02/200011/01/1992
 While driving on nys thruway, car battery exploded. per ins. co. determined that a diode on the computers circuit board came unsoldered causing the vehicle battery to explode. this electrical breakdown is a manufacturers defect
06/03/200009/01/1992
 When hit a pool of water (~ 1 deep), engine stalled and the power brake system died. i was unable to restart the car for ~5 mts and changing the gear f/r and steering do not have any effect. fortunately hand brake helped to slow down. it looks like i had a short circuit problem. need more explanation from the manufacturer on what could have caused it. *ak
ELECTRICAL SYSTEM - IGNITION
08/13/20071420003
 Check engine light,then rough idle,then total death of ignition,stalled. repair station diagnosed it to be a distributor failure. replaced with new one,6 months later it failed and was replaced with rebuilt unit. now about 6 months again,same problem with the rebuilt distributor apparently. haven't taken it to a repair shop yet. *jb
03/17/2004111655108/15/1999
 I have a 1993 honda civic lx. couple of days back when i was driving back from work, my car suddenly stalled at a traffic light. it would not start. with the help of a passer by i got my car pushed in a parking lot. later i had it towed to my garage. my mechanic told me that the igniter had failed. he charged me $700 to replace the igniter and do a tune up. *ak
09/01/20021
 Distributo and related parts failed. *ak
10/03/20021
 Distributor and related pars failed. *ak
02/19/20043
 Distributor and related parts failure. since 2000, i have had to have 3 replacements.this is highly unusual for cars in general. i will report the most recent incident since i just found out about this reporting service today.*ak
05/13/2003100000209/09/1999
 1993 honda civic lx stalled while in motion. the first incident occurred when the odometer read about 100,000 miles back in 2000. the problem was pinpointed to a faulty ignitor which was promptly replaced. luckily no one was injured nor was there an accident. recently in may 13, 2003 the same part failed with the odometer reading 165,000 miles. obviously this is a design flaw. this part and/or distributor prematurely caused such failure. aside from this vehicle, a 1993 honda accord ex coupe also had the similar part replaced before the odometer reached 100,000 miles.*jb
11/29/200198000
 Distributor cap bearing failure resulted in distributor cap / rotor welded together, engine stalled while driving. *nlm
01/03/2003600003
 Car on 3rd distributor bearing and ingnitor failures
07/07/2000102/01/1994
 This is my 2nd honda i purchased new. i take very good care of my car and follow all recommended maintenance procedures. the distributor has failed on both my cars about the same time-mileage wise. i see from many web-sites that this appears to be a consistent problem with honda owners. feel recall may be warranted.*ak
 Distributer locked up, causing vehicle to stall completely out. dealer has not seen vehicle. *ak
08/14/1999102/01/1993
 When the distributor bearing failed the ignition rotor melted from the heat. from a few searches on this site, it appears to be a common honda family of engines problem. some relief in the cost of the distributor would be a nice gesture. $336usd for the dist. base is high. this is a d16z6 vtec engine. the failed bearing appears to be dry of any oil for lubrication, although the distributor/cam gear mating area is wet with eng. oil as would be expected. thanks, jim
06/12/1998303/01/1998
 No summary listed for that vehicle. *ak
07/03/1998111/01/1995
 No summary
07/21/1998104/01/1993
 The bearings in the ignition distributor failed.
ELECTRICAL SYSTEM - WIRING
 When coming to a complete stop vehicle stalls . the dealer has replaced the wiring in the cooling system. the dealer has been notified. *ak
11/04/1996102/01/1993
 Wires rusted behind door.
ELECTRICAL SYSTEM - WIRING - FRONT UNDERHOOD
06/26/1999
 Car caught on fire. called fire department. electrical fire due to a short in wiring harness. consumer contacted dealer. *ak
ELECTRICAL SYSTEM - WIRING - INTERIOR/UNDER DASH
11/23/2004182000
 Vehicle burnedd up. upon starting the vehicle the consumer heard a faint pop, followed by smoke coming from the dimmer. the consumer immediately turn the vehicle off and got out. they let the vehicle stand for a few seconds, went into the church to call 911. by the time they return to the vehicle ,the left side of the dashboard was in flames. the fire originated from underneath the dashboard. the fire was electrical. a fire report was filed. *nm......*ak
09/16/20031680001
 While driving at any speed there was a strong smell of burning plastic inside the vehicle. smoke was coming from the rear windshield wipers and the wires melted. wires under the dashboard and wires near the door speakers were warm to the touch.*ak
03/01/199812/01/1992
 I think the air/heat controls have a short in them - the dealership looked at this in march of 98 and they were not able to pinpoint the problem. the lights come on daily in the air/heat section and then once i move the lever to make the air less cold - the lights in the air/heat area will dim or completely cut off. is there a defect in this part?*ak
07/12/19961
 No summary