Hyundai Caribbean Sonata

Model Sonata made by Hyundai Caribbean got 5 investigations as well as 1 recall. The car had some investigations: structure and suspension. There was one recall concerning electrical system .

Model 1999

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
ELECTRICAL SYSTEM - WIRING
00V259002HYUNDAI CARIBBEAN-PUERTO RICOfrom 07/01/1998 to 07/04/2000V (Vehicle)142111/18/2000MFRHYUNDAI CARIBBEAN-PUERTO RICO11/08/200011/08/2000
Defect SummaryVehicle description: some sonata vehicles equipped with 2.5 liter v-6 engines and all elantra model vehicles may have experienced intermittent low-speed engine stalling, which could occur if the maf (mass air flow) sensor electrical signal is interrupted as a result of engine vibration transmitted to the maf sensor connector wiring harness.
Consequence SummaryThis condition can cause the engine to stall, increasing the risk of a crash.
Corrective SummaryDealers will re-route the maf sensor connector wiring harness.
NotesOwner notification began november 18, 2000.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact hyundai caribbean at 1-787-251-8715. also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
STRUCTURE
EA08016HYUNDAI CARIBBEAN-PUERTO RICO08/21/200804/20/2009FRONT SUB-FRAME CORROSION09V124000
 In a letter dated april 14, 2009, hyundai-kia america technical center, inc (hyundai) notified nhtsa that hyundaiis conducting a safety recall of model year (my) 1999 through 2004 hyundai sonata vehicles manufactured prior to november 20, 2003 that are registered and operated in the following salt belt states and the district of columbia: connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, and wisconsin.hyundai is recalling the vehicles to remedy a condition where internal corrosion of the front subframe may lead to separation of the lower control arm at the forward mounting point and/or separation of the axle from the transaxle.this could result in a loss of vehicle control and/or vehicle disablement. the subframes will be inspected in the recalled vehicles using a procedure developed by hyundai to measure metal thickness.parts with perforations from corrosion or with metal below the specified thickness will be replaced with redesigned subframes.if the minimum metal thickness is met, drainage holes and rust proofing material will be added to the existing subframe. odi's analysis of complaint data revealed that 98% of the consumer complaints were from vehicles either originally sold or operated in saltbelt states. similarly 99.7% of the warranty claims were from vehicles originally sold or operated in saltbelt states.odi identified 105 reports of lower control arm detachment and/or axle separation from the transaxle through analysis of warranty and complaint information and consumer interviews.one hundred three (103) of the 105 incidents involved vehicles in states covered by the recall.in addition to the subject vehicles, hyundai also noted in the april 14, 2009 letter that my 2001 through 2004 xg300 and xg350 were also being recalled as they were manufactured with subframes similar in design the subject vehicles.based on hyundai's decision to conduct a safety recall this engineering analysis is closed.
STRUCTURE - FRAME AND MEMBERS
EA08016HYUNDAI CARIBBEAN-PUERTO RICO08/21/200804/20/2009FRONT SUB-FRAME CORROSION09V124000
 In a letter dated april 14, 2009, hyundai-kia america technical center, inc (hyundai) notified nhtsa that hyundaiis conducting a safety recall of model year (my) 1999 through 2004 hyundai sonata vehicles manufactured prior to november 20, 2003 that are registered and operated in the following salt belt states and the district of columbia: connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, and wisconsin.hyundai is recalling the vehicles to remedy a condition where internal corrosion of the front subframe may lead to separation of the lower control arm at the forward mounting point and/or separation of the axle from the transaxle.this could result in a loss of vehicle control and/or vehicle disablement. the subframes will be inspected in the recalled vehicles using a procedure developed by hyundai to measure metal thickness.parts with perforations from corrosion or with metal below the specified thickness will be replaced with redesigned subframes.if the minimum metal thickness is met, drainage holes and rust proofing material will be added to the existing subframe. odi's analysis of complaint data revealed that 98% of the consumer complaints were from vehicles either originally sold or operated in saltbelt states. similarly 99.7% of the warranty claims were from vehicles originally sold or operated in saltbelt states.odi identified 105 reports of lower control arm detachment and/or axle separation from the transaxle through analysis of warranty and complaint information and consumer interviews.one hundred three (103) of the 105 incidents involved vehicles in states covered by the recall.in addition to the subject vehicles, hyundai also noted in the april 14, 2009 letter that my 2001 through 2004 xg300 and xg350 were also being recalled as they were manufactured with subframes similar in design the subject vehicles.based on hyundai's decision to conduct a safety recall this engineering analysis is closed.
SUSPENSION
EA08016HYUNDAI CARIBBEAN-PUERTO RICO08/21/200804/20/2009FRONT SUB-FRAME CORROSION09V124000
 In a letter dated april 14, 2009, hyundai-kia america technical center, inc (hyundai) notified nhtsa that hyundaiis conducting a safety recall of model year (my) 1999 through 2004 hyundai sonata vehicles manufactured prior to november 20, 2003 that are registered and operated in the following salt belt states and the district of columbia: connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, and wisconsin.hyundai is recalling the vehicles to remedy a condition where internal corrosion of the front subframe may lead to separation of the lower control arm at the forward mounting point and/or separation of the axle from the transaxle.this could result in a loss of vehicle control and/or vehicle disablement. the subframes will be inspected in the recalled vehicles using a procedure developed by hyundai to measure metal thickness.parts with perforations from corrosion or with metal below the specified thickness will be replaced with redesigned subframes.if the minimum metal thickness is met, drainage holes and rust proofing material will be added to the existing subframe. odi's analysis of complaint data revealed that 98% of the consumer complaints were from vehicles either originally sold or operated in saltbelt states. similarly 99.7% of the warranty claims were from vehicles originally sold or operated in saltbelt states.odi identified 105 reports of lower control arm detachment and/or axle separation from the transaxle through analysis of warranty and complaint information and consumer interviews.one hundred three (103) of the 105 incidents involved vehicles in states covered by the recall.in addition to the subject vehicles, hyundai also noted in the april 14, 2009 letter that my 2001 through 2004 xg300 and xg350 were also being recalled as they were manufactured with subframes similar in design the subject vehicles.based on hyundai's decision to conduct a safety recall this engineering analysis is closed.
SUSPENSION - FRONT
EA08016HYUNDAI CARIBBEAN-PUERTO RICO08/21/200804/20/2009FRONT SUB-FRAME CORROSION09V124000
 In a letter dated april 14, 2009, hyundai-kia america technical center, inc (hyundai) notified nhtsa that hyundaiis conducting a safety recall of model year (my) 1999 through 2004 hyundai sonata vehicles manufactured prior to november 20, 2003 that are registered and operated in the following salt belt states and the district of columbia: connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, and wisconsin.hyundai is recalling the vehicles to remedy a condition where internal corrosion of the front subframe may lead to separation of the lower control arm at the forward mounting point and/or separation of the axle from the transaxle.this could result in a loss of vehicle control and/or vehicle disablement. the subframes will be inspected in the recalled vehicles using a procedure developed by hyundai to measure metal thickness.parts with perforations from corrosion or with metal below the specified thickness will be replaced with redesigned subframes.if the minimum metal thickness is met, drainage holes and rust proofing material will be added to the existing subframe. odi's analysis of complaint data revealed that 98% of the consumer complaints were from vehicles either originally sold or operated in saltbelt states. similarly 99.7% of the warranty claims were from vehicles originally sold or operated in saltbelt states.odi identified 105 reports of lower control arm detachment and/or axle separation from the transaxle through analysis of warranty and complaint information and consumer interviews.one hundred three (103) of the 105 incidents involved vehicles in states covered by the recall.in addition to the subject vehicles, hyundai also noted in the april 14, 2009 letter that my 2001 through 2004 xg300 and xg350 were also being recalled as they were manufactured with subframes similar in design the subject vehicles.based on hyundai's decision to conduct a safety recall this engineering analysis is closed.
SUSPENSION - FRONT - CONTROL ARM
EA08016HYUNDAI CARIBBEAN-PUERTO RICO08/21/200804/20/2009FRONT SUB-FRAME CORROSION09V124000
 In a letter dated april 14, 2009, hyundai-kia america technical center, inc (hyundai) notified nhtsa that hyundaiis conducting a safety recall of model year (my) 1999 through 2004 hyundai sonata vehicles manufactured prior to november 20, 2003 that are registered and operated in the following salt belt states and the district of columbia: connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, and wisconsin.hyundai is recalling the vehicles to remedy a condition where internal corrosion of the front subframe may lead to separation of the lower control arm at the forward mounting point and/or separation of the axle from the transaxle.this could result in a loss of vehicle control and/or vehicle disablement. the subframes will be inspected in the recalled vehicles using a procedure developed by hyundai to measure metal thickness.parts with perforations from corrosion or with metal below the specified thickness will be replaced with redesigned subframes.if the minimum metal thickness is met, drainage holes and rust proofing material will be added to the existing subframe. odi's analysis of complaint data revealed that 98% of the consumer complaints were from vehicles either originally sold or operated in saltbelt states. similarly 99.7% of the warranty claims were from vehicles originally sold or operated in saltbelt states.odi identified 105 reports of lower control arm detachment and/or axle separation from the transaxle through analysis of warranty and complaint information and consumer interviews.one hundred three (103) of the 105 incidents involved vehicles in states covered by the recall.in addition to the subject vehicles, hyundai also noted in the april 14, 2009 letter that my 2001 through 2004 xg300 and xg350 were also being recalled as they were manufactured with subframes similar in design the subject vehicles.based on hyundai's decision to conduct a safety recall this engineering analysis is closed.