Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
POWER TRAIN - AUTOMATIC TRANSMISSION | |||||
TSB-09-AT-013 | 07/01/2009 | 10030984 | Hyundai: automatic transaxle range switch diagnostic trouble codes p0705 (range switch signal problems), p0707 (range switch open circuit), and p0708 (range switch short circuit or multiple inputs). an improperly adjusted or improperly op | 12/29/2009 | |
POWER TRAIN - AUTOMATIC TRANSMISSION - CONTROL MODULE (TCM, PCM) | |||||
TSB-09-AT-018 | 10/01/2009 | 10032908 | Hyundai: ata solenoid diagnostic trouble codes p0740, p0741, p0742, p0743, p0746, p0748, p0750, p0755, p0760, p0765, p0770. incorrect operation of the transaxle solenoids may result in the following symptoms-check engine light illuminated | 06/11/2010 | |
POWER TRAIN - MANUAL TRANSMISSION | |||||
0701003 | 01/01/2007 | 10021300 | Abnormal shift to third gear. *kb | 04/02/2007 |
Investigations
NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
---|---|---|---|---|---|---|
POWER TRAIN - AUTOMATIC TRANSMISSION - LEVER AND LINKAGE - COLUMN SHIFT | ||||||
PE09003 | HYUNDAI MOTOR COMPANY | 01/14/2009 | 04/24/2009 | STOP LAMP SWITCH FAILURE | 09V122000 | |
By letter dated april 15, 2009, hyundai notified the agency that it will conduct a safety recall (nhtsa recall number 09v122) to replace the stop lamp switches on many of its model year 2005-2008 vehicles.see recall 09v122 for a complete list. the agency opened its investigation based on five complaints of stop lamp failure across several 2007 hyundai models. the agency also received early warning (ewr) reports on this issue.most of those failures were traced to the improper operation of the stop lamp switch that controls stop lamp illumination.a malfunctioning stop lamp switch can cause the vehicle's brake lights not to light during braking, or alternatively, it can cause the brake lights to stay lit even when a driver takes the foot off the brake pedal. failure of the stop lamps to illuminate properly creates the hazard of rear end collisions when drivers following the subject vehicle do not recognize that the vehicle is slowing or stopping. hyundai reported one crash incident (a frontal impact), without injury, that was alleged to have been caused by this defect.the agency reviewed the incident and cannot conclude that it is related to this defect. there are other potential problems related to failure of the stop lamp switch: failure of the cruise control to disengage, interference with proper functioning of antilock brakes and electronic stability control, and inability to move the gear shift lever out of park position.based on the above safety recall, this investigation is closed. | ||||||
POWER TRAIN - AUTOMATIC TRANSMISSION - LEVER AND LINKAGE - FLOOR SHIFT | ||||||
PE09003 | HYUNDAI MOTOR COMPANY | 01/14/2009 | 04/24/2009 | STOP LAMP SWITCH FAILURE | 09V122000 | |
By letter dated april 15, 2009, hyundai notified the agency that it will conduct a safety recall (nhtsa recall number 09v122) to replace the stop lamp switches on many of its model year 2005-2008 vehicles.see recall 09v122 for a complete list. the agency opened its investigation based on five complaints of stop lamp failure across several 2007 hyundai models. the agency also received early warning (ewr) reports on this issue.most of those failures were traced to the improper operation of the stop lamp switch that controls stop lamp illumination.a malfunctioning stop lamp switch can cause the vehicle's brake lights not to light during braking, or alternatively, it can cause the brake lights to stay lit even when a driver takes the foot off the brake pedal. failure of the stop lamps to illuminate properly creates the hazard of rear end collisions when drivers following the subject vehicle do not recognize that the vehicle is slowing or stopping. hyundai reported one crash incident (a frontal impact), without injury, that was alleged to have been caused by this defect.the agency reviewed the incident and cannot conclude that it is related to this defect. there are other potential problems related to failure of the stop lamp switch: failure of the cruise control to disengage, interference with proper functioning of antilock brakes and electronic stability control, and inability to move the gear shift lever out of park position.based on the above safety recall, this investigation is closed. | ||||||
POWER TRAIN - MANUAL TRANSMISSION - COLUMN SHIFT ASSEMBLY | ||||||
PE09003 | HYUNDAI MOTOR COMPANY | 01/14/2009 | 04/24/2009 | STOP LAMP SWITCH FAILURE | 09V122000 | |
By letter dated april 15, 2009, hyundai notified the agency that it will conduct a safety recall (nhtsa recall number 09v122) to replace the stop lamp switches on many of its model year 2005-2008 vehicles.see recall 09v122 for a complete list. the agency opened its investigation based on five complaints of stop lamp failure across several 2007 hyundai models. the agency also received early warning (ewr) reports on this issue.most of those failures were traced to the improper operation of the stop lamp switch that controls stop lamp illumination.a malfunctioning stop lamp switch can cause the vehicle's brake lights not to light during braking, or alternatively, it can cause the brake lights to stay lit even when a driver takes the foot off the brake pedal. failure of the stop lamps to illuminate properly creates the hazard of rear end collisions when drivers following the subject vehicle do not recognize that the vehicle is slowing or stopping. hyundai reported one crash incident (a frontal impact), without injury, that was alleged to have been caused by this defect.the agency reviewed the incident and cannot conclude that it is related to this defect. there are other potential problems related to failure of the stop lamp switch: failure of the cruise control to disengage, interference with proper functioning of antilock brakes and electronic stability control, and inability to move the gear shift lever out of park position.based on the above safety recall, this investigation is closed. | ||||||
POWER TRAIN - MANUAL TRANSMISSION - FLOOR SHIFT ASSEMBLY | ||||||
PE09003 | HYUNDAI MOTOR COMPANY | 01/14/2009 | 04/24/2009 | STOP LAMP SWITCH FAILURE | 09V122000 | |
By letter dated april 15, 2009, hyundai notified the agency that it will conduct a safety recall (nhtsa recall number 09v122) to replace the stop lamp switches on many of its model year 2005-2008 vehicles.see recall 09v122 for a complete list. the agency opened its investigation based on five complaints of stop lamp failure across several 2007 hyundai models. the agency also received early warning (ewr) reports on this issue.most of those failures were traced to the improper operation of the stop lamp switch that controls stop lamp illumination.a malfunctioning stop lamp switch can cause the vehicle's brake lights not to light during braking, or alternatively, it can cause the brake lights to stay lit even when a driver takes the foot off the brake pedal. failure of the stop lamps to illuminate properly creates the hazard of rear end collisions when drivers following the subject vehicle do not recognize that the vehicle is slowing or stopping. hyundai reported one crash incident (a frontal impact), without injury, that was alleged to have been caused by this defect.the agency reviewed the incident and cannot conclude that it is related to this defect. there are other potential problems related to failure of the stop lamp switch: failure of the cruise control to disengage, interference with proper functioning of antilock brakes and electronic stability control, and inability to move the gear shift lever out of park position.based on the above safety recall, this investigation is closed. |