Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
ENGINE AND ENGINE COOLING
03V455000NISSAN NORTH AMERICA, INC.from 01/01/2001 to 06/30/2002V (Vehicle)63000012/22/2003MFRNISSAN NORTH AMERICA, INC.11/17/200311/19/2003
Defect SummaryOn certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.
Consequence SummaryThis could cause the service engine soon warning light to come on, create a no start condition, cause reduced engine power, or cause the engine to stop running without warning during vehicle operation, which could result in a crash.
Corrective SummaryDealers will replace the crank position sensors. camshaft position sensor(s), and in some cases, the variable timing control sensor(s). vehicles involved in a previous recall campaign, 01v357, are also included in this new campaign. the replacement sensors used in that campaign are also affected. owner notification began on december 22, 2003. owners should contact nissan at 1-800-647-7261 or infiniti at 1-800-662-6200.
NotesNissan recall no. r3022/infiniti recall no. r3021.customers can also contact the national highway traffic safety administration

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ENGINE AND ENGINE COOLING - ENGINE
0600403/31/200606004A10019293Malfunction indicator lamp with diagnostic trouble code u1000 or u1010 stored in engine control unit. 2002 - 2006 infiniti vehicles with can communication. *ak02/28/2006
0207111/04/200210000409Engine will not start or intermittent no start. electronic key registration procedure system description for vehicle immobilizer system / nissan anti-theft system (ivis/nats). *tt02/26/2003
ITB0203706/04/2002635062Information on vehicles exhibiting noise from the idler pulley area. *tt10/17/2002
ITB0107011/14/2001627164On some vehicles the cable type oil dipstick is difficult to read, or blue smoke is emitted from the tailpipe at cold start. *tt02/05/2002
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE
ITB0102906/01/2001631185Information on engine running rough, engine surging and low engine power with mailfunction indicator lamp on with diagnostic trouble code p0100 (mass airflow sensor - mafs) stored. *tt05/21/2002
ITB0102906/01/2001628717Some vehicles may exhibit a malfunction indicator lamp on with diagnostic trouble code p0100 (mass airflow sensor) stored and exhibit engine running rough, surging and low power. *tt03/19/2002
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE - BELTS AND ASSOCIATED PULLEYS
0306612/03/200310006287Voluntary service campaign idler pulley. *mr04/27/2004
12030312/03/200310005325Idler pulley bracket voluntary service campaign 03-066 announcement to all dealer, sales, parts and service managers. *tt02/20/2004
01130401/13/200410005195Idler pulley bracket kits - parts availability. *tt02/12/2004

Consumer Complaints


Fail datemilesoccurencesPurchase date
ENGINE AND ENGINE COOLING
07/26/2008814871
 In march 2008 my 2002 infiniti q45 would not start, had it towed from fayetteville, nc to infiniti dealer in raleigh, nc. they r/r starter assy to resolve issue at no charge, old part not available. on 5/15/08 my car would not start, had it towed from fayetteville to infiniti dealer in raleigh. they r/r starter assy to resolve issue at no charge, old part not available. on 7/26/08 car would not start again. had it towed from fayetteville to infiniti dealer in raleigh. they said motor burned out due to ignition switch malfunction & r/r starter assy & ignition switch to resolve & charged $1,205.54. i asked about recall i found on nhtsa website regarding engine & engine cooling because it stated this could cause a no start condition. they did not acknowledge this recall and that's why they charged me. i would like some assistance in determining if this recall is causing my car to periodically not start. this seems to occur every 2 months. *tr
04/16/2004160001
 The consumer was informed by the infinity csr that based on their records, the crank position sensor weld recall 03v455000 wasn't performed. prior to contacting the manufacturer, the consumer had taken the vehicle to the dealership to have the recall brepairsperformed and was told when they picked the vehicle that the recall was done.*ak
04/22/2004204/01/2002
 Consumer and the dealership noticed that engine was consuming 2 and a half quarts of oil every 4400 miles. also, vehicle had brake rotors problems. *ak when the second oil consumption test was done for 33000 miles the vehicle used one and a half quarts of oil. heavy blue smoke emits from the exhaust pipe during initial start up. *nm
ENGINE AND ENGINE COOLING - ENGINE
06/01/2002150999904/15/2002
 1 - there is up to a two second delay when quick acceleration is required. at times it feels as if the engine completely stalled. 2 - the vehicle often will not downshift to slow the vehicle on a hill. i could be in 5th gear at around only 1800 rpm, and when i downshift twice, it will not go to 3rd. i often have to downshift up to 6 times for it to respond and switch to third. i need to take my eyes off the road to constantly check if i'm in the gear i select. 3 - the parking/emergency break will not hold the fully loaded vehicle on a hill. if the transmission in park fails, the vehicle will roll. all issues are considered to be normal by the manufacturer. they corrected the problem on their new 2005 version and refuse to do so on my vehicle.