Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES
10V072000NISSAN NORTH AMERICA, INC.from 02/09/2007 to 12/14/2009V (Vehicle)17938303/22/2010MFRNISSAN NORTH AMERICA, INC.03/02/201003/02/2010
Defect SummaryNissan is recalling certain model year 2008-2010 titan, armada, and infiniti qx56, and model year 2008-2009 nissan quest vehicles. the brake pedal pivot pin end was not spin-formed to specification during the manufacturing process of the brake pedal assembly. the pivot pin could slide and cause the brake pedal to partially disengage from the brake pedal bracket.
Consequence SummaryThe driver will experience unusual and noticeable looseness in the pedal and a reduction in braking force increasing the risk of a crash.
Corrective SummaryDealers will inspect to see if the pivot pin had been formed properly and will replace the brake pedal assembly if necessary free of charge. the safety recall began on march 22, 2010. owners may contact nissan at 1-800-647-7261.
NotesOwners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov .

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, AIR - ANTILOCK - WHEEL SPEED SENSOR
ITB-10-056-A09/25/201210046600Infiniti: information provided regarding accurate diagnosis of abs/vdc wheel speed sensors on certain vehicles. models 2007-2013 infiniti. *pe10/17/2012
SERVICE BRAKES, HYDRAULIC - ANTILOCK - WHEEL SPEED SENSOR
ITB-10-056-A09/25/201210046600Infiniti: information provided regarding accurate diagnosis of abs/vdc wheel speed sensors on certain vehicles. models 2007-2013 infiniti. *pe10/17/2012

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC
11/12/200915
 Tl* the contact owns an 2010 infiniti qx56. the contact was driving approximately between 30-40 mph. when pressure was applied to the brake pedal there was a delay response. the contact required an increase in stopping distance during braking. the failure was continuous whenever the vehicle was in operation. the vehicle is the process of being taken to authorized dealer for inspection. the failure mileage was 15.