International 4000 2009

Model 4000 made in 2009 by International got 3 recalls as well as 5 service bulletins. Technical service bulletines regarding electrical system and equipment. There were some recalls concerningelectrical system and parking brake.

Model 2009

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
ELECTRICAL SYSTEM
08V258000NAVISTAR, INCfrom 11/21/2000 to 05/21/2008V (Vehicle)5158807/10/2008MFRNAVISTAR, INC06/05/200806/09/2008
Defect SummaryNavistar is recalling 51,588 heavy trucks, commercial buses and school buses manufactured between november 21, 2000 and may 21, 2008, equipped with one or more remote power modules. the potting material that encapsulates the circuit board of the vehicle's remote power module may not sufficiently seal the circuit board from water and contamination intrusion. if the encapsulation is compromised, water and contaminants may cause an internal electrical short, possibly resulting in a fire.
Consequence SummaryA fire could cause personal injury or death.
Corrective SummaryNavistar will notify owners and repair the vehicles free of charge. the recall began on july 10, 2008. owners may contact navistar at 1-280-461-1890.
NotesNavistar recall no. 08505.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.
PARKING BRAKE - CONVENTIONAL - AIR
08V097000INTERNATIONAL TRUCK & ENGINE CORPORATIONfrom 01/15/2008 to 02/13/2008V (Vehicle)57905/09/2008MFRNAVISTAR, INC02/29/200802/29/2008
Defect SummaryInternational is recalling my 2008-2009 4000, 5000, 7000, 8000, 9000 and prostar tractor/trucks equipped with bendix mv-3 dash control valves. the molded valve body has an incorrect core pin in the injection mold causing the valve body to be oversized in the double check valve area. this condition can allow the rubber double check valve to become lodged in the body opening under certain circumstances.
Consequence SummaryIf the double check valve becomes lodged, in the event of a primary reservoir failure, air pressure can leak past the lodged double check valve thereby depleting the secondary reservoir, causing reduced ability for modulating the service emergency brakes increasing the risk of a crash.
Corrective SummaryDealers will replace the bendix mv-3 dash control valves free of charge. the recall began on may 9, 2008. owners may contact international at 1-800-448-7825.
NotesInternational recall no. 08503.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.
SUSPENSION - FRONT - WHEEL BEARING
08V146000INTERNATIONAL TRUCK & ENGINE CORPORATIONfrom 12/03/2007 to 01/25/2008V (Vehicle)33005/23/2008MFRNAVISTAR, INC03/26/200803/28/2008
Defect SummaryInternational is recalling 330 my 2008-2009 4000 series trucks and 3000 re, fbc, and sfc buses. a manufacturing defect in the subassembly of the front axle wheel hubs resulted in the bearings being inadequately lubricated. this condition could cause the front axle bearings to overheat which can result in bearing spalling, seizing, or related damage.
Consequence SummarySuch damage may result in wheel lockup or front wheel separation on the highway with little or no warning to the driver, which could result in a crash.
Corrective SummaryDealers will inspect the front axle bearings and, if necessary, replace and/or properly lubricate the bearings. the recall began on may 23, 2008. owners may contact international at 1-800-448-7825.
NotesInternational recall no. 08504.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ELECTRICAL SYSTEM - WIRING
IK-080029901/11/201210043359International (navistar): chassis side, seats and seat belt sensors are not properly wired and may not function correctly. *pe terrastar, 4000 and 7000 series. no model years listed.03/20/2012
EQUIPMENT
IK-160014902/27/201210043373International (navistar): the adhesive patch, used on one piece sunshade, fails, and the sunshade mounting bracket, used on model day cabs, comes off. *pe03/21/2012
IK-160014904/30/201210043373International (navistar): the adhesive patch, used on one piece sunshade, fails, and the sunshade mounting bracket, used on model day cabs, comes off. *pe updated 5/9/12 *js03/21/2012
SEAT BELTS
IK-080029901/11/201210043359International (navistar): chassis side, seats and seat belt sensors are not properly wired and may not function correctly. *pe terrastar, 4000 and 7000 series. no model years listed.03/20/2012
SEATS
IK-080029901/11/201210043359International (navistar): chassis side, seats and seat belt sensors are not properly wired and may not function correctly. *pe terrastar, 4000 and 7000 series. no model years listed.03/20/2012