International 4400 1999
Model 4400 made in 1999 by International got 1 investigation there is 1 recall as well as 2 service bulletins. Technical service bulletines regarding power train, (pws). The car had one investigation (service brakes, hydraulic). There was one recall concerning service brakes, hydraulic .
Model 1999
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC | ||||||||||||||||
03V062000 | INTERNATIONAL TRUCK & ENGINE CORPORATION | V (Vehicle) | 35074 | 10/29/2004 | ODI | NAVISTAR, INC | 02/25/2003 | 03/05/2003 | ||||||||
Defect Summary | On certain school and transit buses built with bosch zero offset pin slide (zops) hydraulic disc brakes, the zops hydraulic disc brakes may experience calipers sticking in the applied position, which can result in excessive or abnormal heat generation at one or more of the brakes. | |||||||||||||||
Consequence Summary | The combination of the following factors may collectively result in an unreasonable risk to motor vehicle safety: potential fire at a wheel end, high incident rates of stuck calipers, and evacuation and containment concerns relating to multiple passengers. | |||||||||||||||
Corrective Summary | International will notify its customers and repair the buses free of charge. the recall began october 29, 2004. | |||||||||||||||
Notes | International recall no. 03502/04501.customers can also contact the national highway traffic safety administration |
Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
POWER TRAIN - AXLE ASSEMBLY - AXLE SHAFT | |||||
IK-1400020 | 06/04/2012 | 10044295 | International: on certain model trucks built in brazil and south africa the axle shaft fastener is broken and the axle flange gasket is leaking. *pe | 06/06/2012 | |
(PWS) | |||||
IK-0800219 | 06/04/2012 | 10044293 | International/navistar: a new design aps sensors (accelerator position sensor) has been developed to replaced open/closed ivs switches in old sensors. *pe | 06/06/2012 |
Investigations
NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
---|---|---|---|---|---|---|
SERVICE BRAKES, HYDRAULIC | ||||||
EA02034 | NAVISTAR, INC | 12/03/2002 | 02/10/2004 | OVERHEATING FRONT AND REAR BRAKES | 03V062000 | |
This investigation focused on international medium duty trucksand school bus chassis weighing up to 33,000 pounds, equipped with hydraulic brakes and built with the bosch zero offset pin slide (zops)brake system calipers.international used the zops calipers from april 1997 through june 2002.odi was concerned about reports of the brake calipers sticking in the applied position, resulting in excessive heat.as the investigation progressed, odi became aware of wheel end fires, some of which occurred on school buses.during the investigation odi obtained warranty data which was sorted and analyzed by vrtc test engineers and odi to gain an understanding of the magnitude of the problem.after a thorough warranty data analysis, related testing and document reviews, odi met with international, shared the data analysis and shortly afterwards, international agreed to a safety recall.further details are included on pages 2 - 4. |