International Harvester 4700 4x2
Model 4700 4x2 made by International Harvester got 2 recalls as well as 1 service bulletin. Technical service bulletines regarding (pws). There were some recalls concerningservice brakes, hydraulic and steering.
Model 2000
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC | ||||||||||||||||
03V062000 | INTERNATIONAL TRUCK & ENGINE CORPORATION | V (Vehicle) | 35074 | 10/29/2004 | ODI | INTERNATIONAL TRUCK & ENGINE CORPORATION | 02/25/2003 | 03/05/2003 | ||||||||
Defect Summary | On certain school and transit buses built with bosch zero offset pin slide (zops) hydraulic disc brakes, the zops hydraulic disc brakes may experience calipers sticking in the applied position, which can result in excessive or abnormal heat generation at one or more of the brakes. | |||||||||||||||
Consequence Summary | The combination of the following factors may collectively result in an unreasonable risk to motor vehicle safety: potential fire at a wheel end, high incident rates of stuck calipers, and evacuation and containment concerns relating to multiple passengers. | |||||||||||||||
Corrective Summary | International will notify its customers and repair the buses free of charge. the recall began october 29, 2004. | |||||||||||||||
Notes | International recall no. 03502/04501.customers can also contact the national highway traffic safety administration | |||||||||||||||
STEERING - HYDRAULIC POWER ASSIST - PUMP | ||||||||||||||||
00V148000 | INTERNATIONAL TRUCK AND ENGINE | from 02/01/2000 to 03/24/2000 | V (Vehicle) | 4534 | 05/31/2000 | ODI | INTERNATIONAL TRUCK & ENGINE CORPORATION | 05/23/2000 | 05/30/2000 | |||||||
Defect Summary | Vehicle description: school/transit buses and medium duty trucks. the castings used on the power steering pumps were not built to match the engineering drawings, resulting in a thin wall in the pump casting or a complete connection of two passages that are supposed to be separated to control fluid flow. the fluid flow may be reduced to less than the minimum required flow rate to provide full power assist to the brake system with low engine speed. | |||||||||||||||
Consequence Summary | An increase in stopping distance at slow engine speeds can result, increasing the possibility of a crash. | |||||||||||||||
Corrective Summary | Dealers will inspect and replace all pumps that have the defective casting numbers. | |||||||||||||||
Notes | Owner notification began may 31, 2000. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1-800-448-7825.also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236). |
Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
(PWS) | |||||
IK-0400088 | 06/04/2012 | 10044291 | International: procedure information to resolve issue of overheating and smoking of low mileage, single wheel end brake. *pe | 06/06/2012 |