International Harvester Co1810 1970

Model Co1810 made in 1970 by International Harvester got 2 recalls. There were some recalls concerningengine and engine cooling, service brakes, hydraulic.

Model 1970

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - MANIFOLD/HEADER/MUFFLER/TAIL PIPE
74V074000NAVISTAR INTL CORP. V (Vehicle)210606/13/1974MFRINTERNATIONAL TRUCK & ENGINE CORPORATION05/17/197410/12/1979
Defect Summary
Consequence Summary
Corrective Summary
NotesPossibility that when the vehicle is in a complete jounce condition, theexhaust cross over pipe clamp may interfere with the steering tie rod.if thiscondition exists it could cause the tie rod to become weakened to a point ofbreakage and result in loss of steering control.(correct by inspecting andrepositioning exhaust clamp on cross over pipe).
SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES
74V115000NAVISTAR INTL CORP. V (Vehicle)68508/05/1974MFRINTERNATIONAL TRUCK & ENGINE CORPORATION07/16/197410/12/1979
Defect Summary
Consequence Summary
Corrective Summary
NotesInternational harvester campaign no g-74505.1970 thru june 1974.possibilitythat the master cylinder mounting bracket which supports brake pedal, linkage,and master cylinder has a bellcrankused to transfer brake pedal force tomaster cylinder push rod, and the pin that supports bell crank may come out ofthe mounting bracket, loosing effectiveness needed to operate master cylinder.this condition would cause loss of service brakes.(correct by inspecting andplacing a cover over bell crank pin to keep it from falling out).