International Harvester Co1810 1971
Model Co1810 made in 1971 by International Harvester got 2 recalls. There were some recalls concerningengine and engine cooling, service brakes, hydraulic.
Model 1971
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - MANIFOLD/HEADER/MUFFLER/TAIL PIPE | ||||||||||||||||
74V074000 | NAVISTAR INTL CORP. | V (Vehicle) | 2106 | 06/13/1974 | MFR | INTERNATIONAL TRUCK & ENGINE CORPORATION | 05/17/1974 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possibility that when the vehicle is in a complete jounce condition, theexhaust cross over pipe clamp may interfere with the steering tie rod.if thiscondition exists it could cause the tie rod to become weakened to a point ofbreakage and result in loss of steering control.(correct by inspecting andrepositioning exhaust clamp on cross over pipe). | |||||||||||||||
SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES | ||||||||||||||||
74V115000 | NAVISTAR INTL CORP. | V (Vehicle) | 685 | 08/05/1974 | MFR | INTERNATIONAL TRUCK & ENGINE CORPORATION | 07/16/1974 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | International harvester campaign no g-74505.1970 thru june 1974.possibilitythat the master cylinder mounting bracket which supports brake pedal, linkage,and master cylinder has a bellcrankused to transfer brake pedal force tomaster cylinder push rod, and the pin that supports bell crank may come out ofthe mounting bracket, loosing effectiveness needed to operate master cylinder.this condition would cause loss of service brakes.(correct by inspecting andplacing a cover over bell crank pin to keep it from falling out). |