International Harvester International Harvester 1965-1997

Model International Harvester made by International Harvester got 1 consumer complain there are 3 recalls as well as 25 service bulletins. Consumer complaints with reference to equipment. . Technical service bulletines regarding digital instrument panel, electrical system and engine and engine cooling. There was one recall concerning steering .

Car model


Model 9999

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
STEERING - LINKAGES
70V009000NAVISTAR INTL CORP. V (Vehicle)443312/15/1969MFRINTERNATIONAL TRUCK & ENGINE CORPORATION01/30/197010/12/1979
Defect Summary
Consequence Summary
Corrective Summary
NotesPossibility of premature wear of king pin upper bearing capppsteering arm)mounting studs.this could result in impaired steering.(correct byinspecting and replacing steer- ing knuckle, steering arm and mounting studs.)
STEERING - LINKAGES - LINK - DRAG - CONNECTION
66V025000NAVISTAR INTL CORP. V (Vehicle)3211/25/1966MFRINTERNATIONAL TRUCK & ENGINE CORPORATION11/25/196610/12/1979
Defect Summary
Consequence Summary
Corrective Summary
NotesPossibility that the steering drag link may have been assembled without the spring safety plug in one or both ends.(inspect and install plugs as required.)
66V019000NAVISTAR INTL CORP. V (Vehicle)10810/31/1966MFRINTERNATIONAL TRUCK & ENGINE CORPORATION10/31/196610/12/1979
Defect Summary
Consequence Summary
Corrective Summary
NotesPossible undersized drag link plug in one or both ends of the drag link.incorrect plug could be forced out of position by impact on front wheels. (inspect and install proper plugs as necessary.)

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
DIGITAL INSTRUMENT PANEL
IK-100001102/20/200810032944International: cf/citystar models ordered with metric clusters built between 9/1/07 -12/11/07 were built with clusters that have kilometers on the speedometer, but show miles in the odometer. do not change the cluster for this issue. no06/16/2010
ELECTRICAL SYSTEM
IK-080002602/28/200810032930International: 1939 data link repair. when troubleshooting the j1939 data link and resolving intermittent problems which come and go, or are predominant in damp conditions, the application of an approved dielectric grease to all data link06/14/2010
ELECTRICAL SYSTEM - ALTERNATOR/GENERATOR/REGULATOR
980301G9790603/01/1998600987Subject regarding delco remy 22si alternator resistor cable. *yc06/16/1998
ENGINE AND ENGINE COOLING
SB-IK120006109/29/200810029004International: low coolant light with international i6 egr and 2007 maxxforce engines (restriction fitting). model and model years unknown. *pe06/10/2009
ENGINE AND ENGINE COOLING - COOLING SYSTEM - RADIATOR ASSEMBLY
G9590805/01/199544041Unknown11/01/1995
ENGINE AND ENGINE COOLING - ENGINE
ESB-81-3406/01/198156219Unknown11/01/1995
ENGINE AND ENGINE COOLING - ENGINE - DIESEL
IK-120043201/12/201010033556International: when turbocharger diagnostics lead to mechanical failure it is possible to separate the turbo housing to inspect internal components. the turbine housing is available as a serviceable component of the turbocharger assembly.08/23/2010
IK-120044001/27/201010033508International: new accelerator pedal sensors for pre-2010 emissions international engines. applies to pre 2010 emissions international engines. two (2) new aps sensors (accelerator position sensor) have been developed and released for us08/18/2010
IK-120009102/20/200810032946International: torque for high pressure rail oil adapters (oil pucks) and parts information. applies to model i-313 dt-466; dt-570 and ht 570 engines. torque spec on high pressure rail oil adapters (oil pucks). when servicing injectors06/16/2010
IK-120003202/11/200810032945International: repairing vt 275 icp leak on the front port plug and/or rear port and case to head tube. d rings should not be serviced separately on either port plugs or rear port and case to head tubes. replace the port plug and/or rear06/16/2010
IK-120019902/06/200810032947International: egr cooler and bracket installation procedure for maxxforce dt, 9 and diesel engines. applies to all international maxxforce dt, 9, and 10 diesel engines. a change has been made to the installation procedure of the exhaust06/16/2010
TSI-08-12-0402/01/200810032924International: change made to installation procedure of the exhaust gas recirculation (egr) cooler and bracket exhaust side. change to tighten the two m12x70 egr cooler bracket mounting bolts after (not before) the egr cooler clamps. no06/14/2010
IK-120040709/22/200910032144International truck: revision to air compressor pulley nut torque value. provides a revision to the printed eges 345 service manual for the international maxxforce 7 diesel engine. no models or model years listed. *pe02/12/2010
EQUIPMENT - ELECTRICAL - AIR CONDITIONER
BCM950003005/01/199544040Unknown11/01/1995
EXTERIOR LIGHTING
IK-220008005/07/200910028871International: smi has determined that the led lighting products manufactured for specialty brand school bus stop arms and light kits may be subject to reduced service life.models be, ce, fe, re bus. model years unknown. *pe06/05/2009
BCM940004611/01/199437875Clearance lights on the 48 and 60 flat top pro sleeper may appear to be improperly mounted. *tw01/13/1995
PARKING BRAKE
IK-040002802/08/200810032929International: to program parameters after changing a wabco fpb ecu (park brake shows na). all hpv with wabco full power brakes. after changing a wabco full power brakes ecu it is necessary to program the parameters into the new ecu for06/14/2010
POWER TRAIN - AXLE ASSEMBLY - AXLE SHAFT - SEAL
IK-020000402/05/200810032951International: mxt front axle pinion seal leak. these axles may have been delivered with a plastic cap covering the breather to prevent paint intrusion (reference figure 2). inspect for the cap as shown. no model or model years listed.06/16/2010
SERVICE BRAKES, HYDRAULIC
G9890103/01/1998601789Subject on bendix ad-9 air dryer upgrade. *yc all models with holset (cummins) type eoveq compressor built between 10/1/96 and 12/31/97.08/24/1998
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
IK-040006401/20/201010033507International: service procedures four piston quadraulic hydraulic disc brake caliper. models include 1000, 3200, 3300, 4100, 4200, 4300, 4400, rxt, be bus, ce bus, hc bus, f650, and f750. no model years listed. *pe08/18/2010
STRUCTURE - BODY
IK-220009201/08/201010033509International: complaints of handrail at entrance door and stepwell heater cover gets hot to the touch. models b3 200; ce 200; ce 300. no model years listed. *pe08/18/2010
SUSPENSION - FRONT - SPRINGS - AIR SUSPENSION SYSTEM
IK-030000102/29/200810032927International: air suspension dump operation with dual solenoid control valves. springfield product 9/5/03 thru present; garland product 9/7/03 thru present; escobedo product 9/7/03 thru present. after the above referenced dates the hpv06/14/2010
UNKNOWN OR OTHER
IK-020000402/05/200810032951International: mxt front axle pinion seal leak. these axles may have been delivered with a plastic cap covering the breather to prevent paint intrusion (reference figure 2). inspect for the cap as shown. no model or model years listed.06/16/2010
IK-220008105/27/200910028870International: the torque on the mounting screws on some bergstrom booster pumps may not have the adequate torque. the coolant leaks at the booster pump. model years unknown. *pe06/05/2009
VEHICLE SPEED CONTROL - ACCELERATOR PEDAL
IK-120044001/27/201010033508International: new accelerator pedal sensors for pre-2010 emissions international engines. applies to pre 2010 emissions international engines. two (2) new aps sensors (accelerator position sensor) have been developed and released for us08/18/2010

Consumer Complaints


Fail datemilesoccurencesPurchase date
EQUIPMENT
06/18/2009
 Tl* the contact was driving a 2008 international harvester vehicle used as a commercial vehicle for ups with a silver eagle dolly model vast-20nu. he was driving and hauling three trailers. the pogo stick on the dolly from the first trailer cut the air brake line to the second and third trailers. he applied the brakes at 8 mph but the vehicle did not stop; it only slowed the vehicle down to 4 mph. as a consequence he crashed into another vehicle. there were no injuries but a police report was taken and a mechanical failure was cited as the cause for the accident. the contact did not have possession of the dolly at the time of the complaint as it was somewhere on another trailer in the country. the contact had pictures available as well. he tried to contact the dolly manufacturing company and was told that they would get back with him; he had yet to hear from anyone. the contact did not have the serial number available at the time of the complaint.