Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ELECTRICAL SYSTEM
IK-080040611/02/201210049399International: on some ambulance, with secure-idle memory, after keys are removed, all accessories, including engine, continues to function (run). to activate push secure-idle button, turn ignition off and remove keys; to deactivate syste01/15/2013
IK-080002602/28/200810032930International: 1939 data link repair. when troubleshooting the j1939 data link and resolving intermittent problems which come and go, or are predominant in damp conditions, the application of an approved dielectric grease to all data link06/14/2010
033907/01/200310003467Incorrect map sensors released to the field. *tt10/21/2003
026309/12/200210000106Use of remote power module (rpm) output for power take off (pto) engagement and / or powering other electrical loads. *tt02/12/2003
024605/14/2002635488Subject regarding electrical system controller (esc) feature set revision v17. *tt10/23/2002
SFN021402/01/2002631541On certain models, when performing a key on engine off standard test (koeo standard test) the engine electronic control module may set diagnostic trouble code 267. *tt05/31/2002
SFN022103/05/2002631207Subject regarding code 08haa, trailer wiring rear of frame on 4200, 4300, 4400, 7300, 7400, 7500, 7600 models. *tt05/21/2002
TSI01080506/01/2001623492Information regarding low coolant level sensor on 4300 and 4400 models. *yh10/29/2001
TSI01080206/01/2001623465Information regarding the audible warning alarm on 4300 and 4400 models. *yh10/29/2001
ELECTRICAL SYSTEM - ALTERNATOR/GENERATOR/REGULATOR
IK-080026603/01/201110040287International truck: there is voltage guage fluctuation or a battery draw. this is likely a wiring problem with the alternator. *rm08/17/2011
IK-080026603/01/201110040287Ready08/17/2011
ELECTRICAL SYSTEM - BATTERY
IK-080009812/11/200810028569International: low battery voltage is the only known cause for bc lock up. this condition will occur if trucks battery voltage is in the 5.0-5.5 voltage range. models and model years unknown. *pe05/08/2009
ELECTRICAL SYSTEM - IGNITION - MODULE
SFN020801/01/2002631540Subject regarding defective ecm modules. *tt05/31/2002
SFN020801/31/2002629123Subject regarding defective ecm modules. *tt03/27/2002
ELECTRICAL SYSTEM - SOFTWARE
IK-180003410/15/201210048580International: if truck fails to drive and not communicate with test equipment, than an issue has occurred with usb port connection, if truck is operational. model estar. no model years listed. *pe12/28/2012
IK-080027904/19/201110040288Ready08/17/2011
IK-080027904/19/201110040288International truck: there is a body controller software revision. *rm08/17/2011
IK-260001501/09/200810032288International bus: international reprogramming harness. this sfn applies to all post 11/97 international engine control modules except 3-box. engine reprogramming harness allows the technician to power the engine ecm and idm without usin03/01/2010
ELECTRICAL SYSTEM - WIRING
IK-080026603/01/201110040287Ready08/17/2011
IK-080026603/01/201110040287International truck: there is voltage guage fluctuation or a battery draw. this is likely a wiring problem with the alternator. *rm08/17/2011
TB-IK-090002303/03/200910030129International bus: bus booster pump running backwards. when replacing the booster pump with one of the part numbers below, verify that the wiring of the new pump to the bus harness is correct. part #2227279c92; 2227281c92; 2227280c92. no08/05/2009
ELECTRICAL SYSTEM - WIRING - INTERIOR/UNDER DASH
SFN022903/26/2002631222Subject regarding electronic gauge cluster (egc) lockup while using intune for 4200, 4300, 4400, 7300, 7400, 7500, 7600, 8500, and 8600 models. *tt05/21/2002
SFN021803/04/2002631205On some 4200 and 4300 models, with the new egc (electronic gauge cluster) version 9.4, the brake fluid warning light stays illuminated continuously. *tt05/21/2002
TSI01080406/01/2001623487Subject regarding instrument cluster digital lcd display on 4300 and 4400 models. *yh10/29/2001