International Harvester Loadstar 1969
Model Loadstar made in 1969 by International Harvester got 4 recalls. There were some recalls concerningparking brake, service brakes, air and service brakes, hydraulic.
Model 1969
Recalls
| Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| PARKING BRAKE - DRIVELINE - AIR | ||||||||||||||||
| 69V102000 | NAVISTAR INTL CORP. | V (Vehicle) | 1947 | 07/23/1969 | MFR | INTERNATIONAL TRUCK & ENGINE CORPORATION | 07/23/1969 | 10/12/1979 | ||||||||
| Defect Summary | ||||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | ||||||||||||||||
| Notes | Possibility air hoses may contact wiper arm.(correct by installing nylonstrap to position air hoses to avoid contact with wiper arm.) | |||||||||||||||
| SERVICE BRAKES, AIR - DRUM - DRUM | ||||||||||||||||
| 69V172000 | NAVISTAR INTL CORP. | V (Vehicle) | 67 | 11/20/1969 | MFR | INTERNATIONAL TRUCK & ENGINE CORPORATION | 11/28/1969 | 10/12/1979 | ||||||||
| Defect Summary | ||||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | ||||||||||||||||
| Notes | Possibility that brake drum to wheel mounting nuts will not withstand required180 to 190 ft.lbs.torque.(correct by inspecting and installing newimproved nuts where necessary.) | |||||||||||||||
| SERVICE BRAKES, AIR - SUPPLY - HOSES, LINES/PIPING, AND FITTINGS | ||||||||||||||||
| 70V043000 | NAVISTAR INTL CORP. | V (Vehicle) | 633 | 04/27/1970 | MFR | INTERNATIONAL TRUCK & ENGINE CORPORATION | 05/05/1970 | 10/12/1979 | ||||||||
| Defect Summary | ||||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | ||||||||||||||||
| Notes | Possibility that interference may exist between air brake slack adjuster andrear spring u-bolt mounting plate when push rod travels less than 2 1/2 inches.(correct by replacing with bendix- westinghouse slack adjuster.) | |||||||||||||||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER | ||||||||||||||||
| 70V139000 | NAVISTAR INTL CORP. | V (Vehicle) | 8784 | 11/09/1970 | ODI | INTERNATIONAL TRUCK & ENGINE CORPORATION | 11/23/1970 | 10/12/1979 | ||||||||
| Defect Summary | ||||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | ||||||||||||||||
| Notes | Possibility that cover on dual hy- draulic brake master cylinder reservoir maybecome distorted due to over torquing of attachment bolt.if condition exists,brake fluid may leak from under cover causing reduced brake efficiency.(correct by replacing with new improved type cover.) | |||||||||||||||