Isuzu Trooper 1992

Model Trooper made in 1992 by Isuzu got 28 consumer complains, 1 investigation there are 2 recalls as well as 3 service bulletins. Consumer complaints with reference, among others things, to electrical system, engine and engine cooling and equipment. Technical service bulletines regarding engine and engine cooling, equipment and seats. The car had one investigation (engine and engine cooling). There were some recalls concerningengine and engine cooling, vehicle speed control. The car has one 3.2l engine.

Model 1992

Engine [L]CylindersTransmissionDriveEstimate MPG (city/highway/combined)Unadjusted MPG (city/highway/combined)FuelFuel costClassRelease date
( 3.2L) 6Lockup/automatic, 4 gears4WD15/18/1616/23/19Regular$ 112518910821
( 3.2L) 6Lockup/automatic, 4 gears4WD15/18/1616/23/19Regular$ 112518910821
( 3.2L) 6Manual, 5 gears4WD15/17/1617/22/19Regular$ 112518910821
( 3.2L) 6Manual, 5 gears4WD16/18/1718/23/20Regular$ 105818910821

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
ENGINE AND ENGINE COOLING - ENGINE
94V132000ISUZU MOTORS LIMITEDfrom 11/01/1991 to 04/01/1994V (Vehicle)12229707/14/1994MFRISUZU MANUFACTURING SERVICES OF AMERICA07/19/199407/26/1994
Defect SummaryConstant expansion and contraction of the cylinder head causes the camshaft seal end plug can become dislodged from the cylinder head. this allows oil to leak from the camshaft.
Consequence SummaryThis can cause engine damage and possible engine fire from oil leaking onto the hot exhaust system.
Corrective SummaryDealers will install camshaft end seal plug retainer plates.
NotesSystem: engine; camshaft.vehicle description: multipurpose passenger vehicles equipped with isuzu 6vdi engines. note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided within a reasonable time and free of charge, or the remedy does not correct the defect or noncompliance, please contact isuzu service center at 1-800-255-6727 or honda service center at 1-800-999-1009. also, contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
VEHICLE SPEED CONTROL - CABLES
04V199000ISUZU MOTORS LIMITEDfrom 02/01/1991 to 09/30/1992V (Vehicle)7290505/24/2004MFRISUZU MANUFACTURING SERVICES OF AMERICA04/22/200404/27/2004
Defect SummaryOn certain sport utility vehicles, the accelerator cable can stick so that the engine speed will not immediately decrease upon release of the accelerator pedal.
Consequence SummaryThis can cause the accelerator throttle cable to delay rpm and vehicle speed reduction for several seconds after the accelerator pedal is released, which in turn, can lead to a crash.
Corrective SummaryDealers will replace the throttle cable rubber boot. owner notification began on may 24, 2004. owners should contact isuzu at 1-800-255-6727.
NotesCustomers can also contact the national highway traffic safety administration

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM
SB940300112/01/199439024Exhaust - booming noise while driving. *tw03/01/1995
EQUIPMENT - ELECTRICAL - AIR CONDITIONER
SB0012S00203/01/2000612590This technical service bulletin outlines the detailed procedures for the air conditioning system conversion / retrofit. *tt06/09/2000
SEATS
SB9914S00704/01/1999606029Information regarding the availability of the child seat tether anchor kit. *tt08/05/1999

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
ENGINE AND ENGINE COOLING
DP92015ISUZU MANUFACTURING SERVICES OF AMERICA07/30/199211/25/1992ENGINE COMPARTMENT FIRES
 Engine compartment fires

Consumer Complaints


Fail datemilesoccurencesPurchase date
ELECTRICAL SYSTEM
08/09/20041
 While driving all electrical light appeared on the dashboard and remained on. vehicle stalled. consumer drove the vehicle to the dealer for inspection, and mechanic stated that the vehicle had to be placed on a diagnostic machine for results. consumer informed the mechanic that this problem occurred more than once. mechanic advised consumer that the problem could not be determined at this time.
ENGINE AND ENGINE COOLING - COOLING SYSTEM
05/15/1997101/01/1993
 Present milage given is approximate. it has not been driven in months and i don't remember the reading. our vehicle was in the dealer's shop for warranty work on the airconditioner and waterpump. without telling us, they performed an oil pump relief valve replacement and cam journal plug retainers. up to this point, the motor had never exhibited any oiling problems whatever. prior to repair cold oil pres=100 psi hot=50 psi. upon return of the vehicle, cold oil pres=55 psi, hot=10 psi. within a month the motor would not maintain proper oil pressure causing excessive valve noise due to collapsed hydraulic adjusters. warranty return on the job was declined by the dealer. we have had to drive it in this condition and it has gotten steadily worse to the point that it is not driven at all least it suffer terminal failure.
ENGINE AND ENGINE COOLING - ENGINE
09/15/2008188000
 Tl*the contact owns a 1992 isuzu trooper. the contact noticed oil leaking onto the intake manifold. he noticed the issue when heavy smoke appeared from the engine while driving approximately 55 mph. the dealer stated that the vin was not included in nhtsa campaign id number 94v132000 (engine and engine cooling:engine). the manufacturer initially stated that the vin was not included in the recall, but later stated that the vehicle had previously been repaired according to the recall. the current mileage was 192,031 and failure mileage was approximately 188,000.
09/23/19981
 Took vehicle for 90,000 checkup & had timing chain belt replaced. later, noticed leaks under vehicle. took to mechanic & was informed engine two head gaskets were leaking a lot of oil. problem was not notice at time of check up. *ak
11/24/1997
 Recall # 94v132000, dealer is not able to perform recall work without authorization from manufacturer. authorization required because dealership is showing that recall work has been performed in another state. *ak
11/01/199502/01/1994
 At highway speeds for extended periods, over an hour, significant valve noise results. dealer unable to resolve problem.
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE
101/01/1999
 A valve in the number 1 cylinder of the v6 engine in the trooper burnt out at approximately 60000 miles.
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - MANIFOLD/HEADER/MUFFLER/TAIL PIPE
11/18/1999107/01/1993
 The vehicle's tail pipe separated from the muffler's discharge flange which is turned 90 degrees up, causing the hot ehhaust gases to hit the floor deck on the left side of the vehicle, just behind the back seat. the result was burning the undercoating off, setting fire to the carpet padding and seting fire to a duffel bag containin clothing that was placed over that location. this resulted in flames inside the vehicle, which were put out before any other damage could occur. looking at newer trooper's isuzu continues to use the same muffler with no heat shield above the flange. in a six mile drive the the dealer with the pipe broken enough, heat was generated to stare the matting smoking again. in my mind this is a serious defect in design that could creates a major fire hazard given the failure rate of exhaust components over time. *ak
07/25/1998103/20/1992
 Vehicle's tailpipe separated from upturned flange at rear of muffler, causing melting and burning of undercoat beneath vehicle left rear floor, and also caused melting and charring of carpet and vehicle contents stored above that spot on the floor. the separation was caused by rusting.
EQUIPMENT - ELECTRICAL - AIR CONDITIONER
05/15/1997101/01/1993
 Present milage given is approximate. it has not been driven in months and i don't remember the reading. our vehicle was in the dealer's shop for warranty work on the airconditioner and waterpump. without telling us, they performed an oil pump relief valve replacement and cam journal plug retainers. up to this point, the motor had never exhibited any oiling problems whatever. prior to repair cold oil pres=100 psi hot=50 psi. upon return of the vehicle, cold oil pres=55 psi, hot=10 psi. within a month the motor would not maintain proper oil pressure causing excessive valve noise due to collapsed hydraulic adjusters. warranty return on the job was declined by the dealer. we have had to drive it in this condition and it has gotten steadily worse to the point that it is not driven at all least it suffer terminal failure.
POWER TRAIN
05/01/2000
 While driving on the highway all of a sudden speedometer goes to zero. this is an intermittent problem which causes the speedometer and odometer to stop working. contacted the dealer. there is a speed sensory that is mounted on the transmission that fails. *ak
POWER TRAIN - AUTOMATIC TRANSMISSION
04/01/1998
 Transmission light comes on, loss of pressure. *ak
07/19/19959
 Transmission slipping. *sd
SEAT BELTS - FRONT
08/12/1996
 While driving at 15 mph, vehicle was broadswiped by another vehicle that ran a red light. the driver's seat belt did not stay latch in the buckle assembly when this happend there was no protection to the driver in the collision. *ak
SEAT BELTS - FRONT - BUCKLE ASSEMBLY
07/05/19951
 The front passenger seat belt buckle popped open after belt had been hooked. *ak
SERVICE BRAKES, HYDRAULIC - ANTILOCK
04/06/19956
 Anti-lock brakes failed, causing loss of control.
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
07/30/20051700001
 I had begun hearing a grinding sound coming from the brakes, knew it was time to change the pads. drove vehicle to the parts store to obtain new disc brake pads to perform the repairs. while driving home felt a slight give in the brake pedal when coming to the stop, also there was the grinding present-pads were pad. when i arrived home and began to perform repairs i removed the left rear(drivers side) tire and found that the complete brake pad had been shelled out of the caliper and that all that was stopping the vehicle was the caliper piston. i wouldn't really be too concerned, although i am not sure how it was able to shell the pad completely out(not just the lining but the whole pad,backing and all), but i have a friend who has a 94 trooper and he has experienced the same trouble, just curious if this defect within the trooper of just am isolated coincidence. searched all your data bases(recalls,complaints etc..) and didn't see any similar complaints,so not really sure but thought it might bear investigation. *jb
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
10/21/1996110/27/1992
 Master cylinder failure. *ak
STEERING
06/01/199712/23/1992
 Power steering is producing very littlre hydraulic power to steering unit, resulting in some wea rof the steering gear box. *ak
STEERING - GEAR BOX (OTHER THAN RACK AND PINION)
05/21/1997
 Consumer was traveling about 30 mph when the nut that is attached to the steering gear box came detached, causing the consumer to lose control of the vehicle. *ak
STEERING - LINKAGES
1
 Steering linkage is loose; clicks back and forth when driven on a straight road.
STRUCTURE - FRAME AND MEMBERS
09/09/19941
 During turning maneuvers tires roll, driver states vehicle feels like it is ready to tip over.*ak
SUSPENSION - FRONT
04/12/1994
 While traveling down a gravel road at 25 mph, animal came out onto the road, vehicle swerved to the shoulder to aviod it. when vehicle was steered back onto the road, it rolled over at a very low speed. *ak
04/06/19956
 Vehicle lost control while in 4-wheel drive, causing accident/rollover. *skd
SUSPENSION - REAR
02/17/1995
 Breakage in the rear suspension causing the vehicle to loss control. tt
VEHICLE SPEED CONTROL - ACCELERATOR PEDAL
02/11/1999
 Accelerator petal sticks to floor. rapid acceleration then occurs. problem was defective rubber boot at the end of cable linkage located in the engine compartment. rubber boot deterioated and was gripping center cable. this would prevent the gas petal from returning to normal or idle position. this occured several times, especially when the engine was cold and driven immediately. the rubber boot was removed and cable cleaned, problem fixed.
03/04/1995
 Consumer was driving and mat got caught on the gas pedal accelerate and cause an accident . tt