Itasca Cambria 2005
Model Cambria made in 2005 by Itasca got 3 recalls. There were some recalls concerningelectrical system, engine and engine cooling and fuel system, gasoline.
Model 2005
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ELECTRICAL SYSTEM - WIRING | ||||||||||||||||
04V512000 | WINNEBAGO INDUSTRIES, INC. | from 09/23/2002 to 04/14/2004 | V (Vehicle) | 3950 | MFR | WINNEBAGO INDUSTRIES, INC. | 10/20/2004 | 10/28/2004 | ||||||||
Defect Summary | On motor homes built on ford e-series chassis and equipped with gas engines, a diode in the anti-lock braking system (abs) module may experience an electrical short. | |||||||||||||||
Consequence Summary | The electrical short may cause an abs malfunction that would illuminate the abs warning light, or the module may overheat resulting in a burning odor, smoke, and/or fire. this condition may occur while the vehicle is being driven or unattended. | |||||||||||||||
Corrective Summary | Ford motor company is conducting the owner notification and remedy for this campaign. dealers will install a new fuse in the abs circuit and install a heat shield over the abs module. owners should contact ford at 1-800-392-3673 or winnebago at 641-585-3535. | |||||||||||||||
Notes | Customers can also contact the national highway traffic safety administration | |||||||||||||||
ENGINE AND ENGINE COOLING | ||||||||||||||||
04V516000 | WINNEBAGO INDUSTRIES, INC. | from 10/03/2002 to 09/30/2004 | V (Vehicle) | 5125 | MFR | WINNEBAGO INDUSTRIES, INC. | 10/20/2004 | 10/28/2004 | ||||||||
Defect Summary | On motor homes built on ford e-series chassis, the air filter element material process resulted in an air filter paper element that can smolder or burn. this change in filter paper composition combined with the configuration of the air induction system, may allow hot carbon particles to contact the air filter element during certain driving conditions that create hot particles. | |||||||||||||||
Consequence Summary | These hot particles may ignite the air filter element with the potential for air induction system damage or underhood fire. | |||||||||||||||
Corrective Summary | Ford motor company is conducting the owner notification and remedy for this campaign. dealers will inspect and replace the air filter element. owners should contact ford at 1-800-392-3673 or winnebago at 641-585-3535. | |||||||||||||||
Notes | Customers can also contact the national highway traffic safety administration | |||||||||||||||
FUEL SYSTEM, GASOLINE - STORAGE - TANK ASSEMBLY | ||||||||||||||||
05V475000 | WINNEBAGO INDUSTRIES, INC. | from 04/12/2004 to 07/17/2005 | V (Vehicle) | 3613 | 10/14/2005 | MFR | WINNEBAGO INDUSTRIES, INC. | 10/13/2005 | 10/14/2005 | |||||||
Defect Summary | On certain motor homes built on ford chassis, the fasteners holding the fuel tank mounting straps may not have been properly tightened, allowing the possibility for the fuel tank to loosen and fall. | |||||||||||||||
Consequence Summary | If the fuel tank falls, there is the potential for the tank to ignite, resulting in personal injury, vehicle and property damage. | |||||||||||||||
Corrective Summary | Dealers will inspect and properly tighten the fasteners to the fuel tank straps. the recall began on october 15, 2005. owners may contact winnebago at 614-585-6939. | |||||||||||||||
Notes | Customers may contact the national highway traffic safety administration |