Jeep Grand Cherokee 1992
Model Grand Cherokee made in 1992 by Jeep got 7 consumer complains there are 7 investigations as well as 1 service bulletin. Consumer complaints with reference, among others things, to air bags, engine and engine cooling and power train. Technical service bulletines regarding seats. The car had some investigations: power train, seat belts and service brakes, hydraulic.
Model 1992
Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| SEATS | |||||
| 2300800B | 11/24/2000 | 230800A | 615688 | Subject regarding child seat tether anchors. *tt | 01/28/2001 |
Investigations
| NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
|---|---|---|---|---|---|---|
| POWER TRAIN | ||||||
| DP02005 | CHRYSLER GROUP LLC | 04/25/2002 | 09/10/2002 | SUDDEN ACCELERATION | ||
| Sudden vehicle acceleration is allegedly caused by a defect in the design and assembly of the connector interface between the main wiring harness and the powertrain control module | ||||||
| SEAT BELTS | ||||||
| PE96008 | CHRYSLER GROUP LLC | 01/25/1996 | 06/28/1996 | SAFETY BLT LATCH OPERATION | ||
| There is no summary currently available | ||||||
| SERVICE BRAKES, HYDRAULIC | ||||||
| EA99014 | CHRYSLER GROUP LLC | 06/28/1999 | 03/28/2000 | BRAKE ROTER DISC/HUD SEPARATION | 99V340000 | |
| Daimlerchrysler conducted a safety recall, 98v-005, on january 5, 1998 involving approximately 225,000 1993 grand cherokee, 1990-91 cherokee, wrangler and comanche, and 1989-91 eagle premier and dodge monaco.the front disc brake rotors of these vehicles may experience severe corrosion if operated for an extensive period in the salt belt states.owners in connecticut, illinois, indiana, maine, massachusetts, maryland, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, wisconsin, and the district of columbia will receive replacement rotors that are coated with a different corrosion protection coating, inorganic 531.chrysler began owner notification onmarch 9, 1998.the purpose of the investigation is to determine the scope and the remedy effectiveness of the safety recall, 98v-005. | ||||||
| PE96053 | CHRYSLER GROUP LLC | 09/05/1996 | 01/13/1997 | BRAKE DISC/HUB SEPARATION | ||
| Consumer complaints indicate that corrosion of hte brake rotors have caused separation of the brake disc from its hub, resulting in brake failure. | ||||||
| EA99014 | CHRYSLER GROUP LLC | 06/28/1999 | 03/28/2000 | BRAKE ROTER DISC/HUD SEPARATION | 00V136000 | |
| Daimlerchrysler conducted a safety recall, 98v-005, on january 5, 1998 involving approximately 225,000 1993 grand cherokee, 1990-91 cherokee, wrangler and comanche, and 1989-91 eagle premier and dodge monaco.the front disc brake rotors of these vehicles may experience severe corrosion if operated for an extensive period in the salt belt states.owners in connecticut, illinois, indiana, maine, massachusetts, maryland, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, wisconsin, and the district of columbia will receive replacement rotors that are coated with a different corrosion protection coating, inorganic 531.chrysler began owner notification onmarch 9, 1998.the purpose of the investigation is to determine the scope and the remedy effectiveness of the safety recall, 98v-005. | ||||||
| EA97001 | CHRYSLER GROUP LLC | 01/13/1997 | 01/09/1998 | BRAKE DISC/HUB SEPARATION | 98V005000 | |
| Consumer complaints indicate that corrosion of the brake rotors have caused separation of the brake disc from its hub, resulting in brake failure. | ||||||
| SUSPENSION | ||||||
| PE95049 | CHRYSLER GROUP LLC | 08/17/1995 | 01/26/1996 | REAR AXLE SHAFT SEPARATION | ||
| This investigation was opened to examine the failure mode and the risk to motor vehicle safety posed by allegations of rear axle separations.the rear axle shaft and housing design is typical of those in which the weight of the vehicle is carried on the axle housing.the left and right axle shafts, supported by roller bearings, are situated inside the axle housing.the inboard splined end of the axle shaft receives power transmitted from the differential assembly, providing torque to the rear wheels.the allegations are that the axle shaft fails, resulting in the separation of a wheel and axle hub assembly or the entire axle shaft and wheel assembly, depending on the location of the axle shaft failure.as identified by chrysler, the subject rear axles are dana 35c and 35cm models, which have been used on the subject vehicles since the 1990 model year.a safety defect trend with respect to the subject axle shafts has not been identified.see hard copy resume for full text of summary. | ||||||
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| AIR BAGS | |||
| 04/01/2011 | 1400 | ||
| Air bag light comes on and off. an investigation found it is probably coil spring located in steering column and if an impact occurs air bag will not deploy. | |||
| ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - MANIFOLD/HEADER/MUFFLER/TAIL PIPE | |||
| 12/11/2002 | 1 | ||
| Consumer called complaining about having problems with the intake manifold. also stated that dealer was contacted and stated that the intake manifold was broken and that they are aware of the problem with the model and year but at the same time there is nothing they can do about it because there is no recalls. *nlm | |||
| 12/11/2002 | |||
| Consumer called complaining about the manifold intake been broken. also stated that dealer was contacted and stated that it is a common problem with the model of vehicle and also said that will only charging the consumer for it because there is no recalls or warranty for the vehicle. ts | |||
| POWER TRAIN - AUTOMATIC TRANSMISSION | |||
| 05/06/2001 | 0 | ||
| Vehicle was sitting in driveway when motor started to accelerate. then, vehicle jumped out of gear and went into reverse. vehicle jumped a fense, and hit a wall. consumer has yet to contact dealer. please provide any further information.*ak | |||
| VEHICLE SPEED CONTROL | |||
| 05/06/2001 | 0 | ||
| Vehicle was sitting in driveway when motor started to accelerate. then, vehicle jumped out of gear and went into reverse. vehicle jumped a fense, and hit a wall. consumer has yet to contact dealer. please provide any further information.*ak | |||