Jeep J10 1980
Model J10 made in 1980 by Jeep got 1 investigation as well as 1 recall. The car had one investigation (engine and engine cooling). There was one recall concerning power train .
Model 1980
Recalls
| Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| POWER TRAIN - AXLE ASSEMBLY - AXLE SHAFT | ||||||||||||||||
| 80V023000 | CHRYSLER CORPORATION | from 06/01/1979 to 10/01/1979 | V (Vehicle) | 10891 | MFR | CHRYSLER GROUP LLC | 03/05/1980 | 04/04/1980 | ||||||||
| Defect Summary | The right and left rear wheel bearings may have been damaged during assembly. a damaged bearing could result in axle and wheel disengagement from the vehicle while in motion. | |||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | The dealer will replace both rear wheel bearings along with seals, retainer rings and plates at no charge to owner. | |||||||||||||||
| Notes | Vehicle description: multipurpose passenger vehicles and trucks.system: suspension; wheel bearings.consequences of defect: this condition could cause loss of vehicle control,without prior warning, and an accident.note: the damage to the rear wheel bearing may be preceded by a noise evidentto the vehicle driver. high speed driving, hard cornering and heavy loadingshould be avoided until axle service has been performed. | |||||||||||||||
Investigations
| NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
|---|---|---|---|---|---|---|
| ENGINE AND ENGINE COOLING - ENGINE | ||||||
| EA88009 | CHRYSLER GROUP LLC | 11/16/1987 | 01/09/1990 | ENGINE COMPARTMENT FIRES | 88V132000 | |
| There is no summary currently available | ||||||