Consumer Complaints


Fail datemilesoccurencesPurchase date
ENGINE AND ENGINE COOLING
03/21/2012147210
 While driving on the interstate and preparing to exit, vehicle would not slow down or decelerate. i tried to apply the brakes in attempt to stop.shifted into neutral in order to gain control.rpm's immediatly shot up to 3000 and fluctuated between 3000 - 4000.pulling to the side and looking under the hood to see if there was any obstruction in the accelerator linkage,there was not.i attempted to start the vehicle again 3 times with the same results.i let the vehicle cool for 1/2 hour ( temperature was in proper range ), normal operation was obtained. this the first ( and only episode ) i hope to experience. i am an experienced driver and was able to think quickly. some others may not be so lucky. there is obviously a trend and problem here that chrysler should deal with. after all i'm sure they dont want us to start buying other makes of vehicles.
10/04/200570000709/09/1999
 Have had brakes on this vehicle worked on 7 times since purchased new. only has approximately 70k miles. all seemed to be the result of warped rotors. latest incident check engine light went on, had head gasket replaced, serpentine belt replaced and t-stat. *jb