Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
STRUCTURE - BODY - HATCHBACK/LIFTGATE | |||||
2305407 | 12/12/2007 | 10023645 | Water leak on load floor on right or let side or both at the liftgate header and/or the luggage rack channel seam area. *nj | 01/18/2008 |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
STRUCTURE | |||
04/05/2008 | 3000 | 1 | |
2008 jeep liberty 4x4 skyslider roof does not seal back down when closed and causes severe wind noise at freeway speeds. i've taken it back to the dealer twice. the first time they just adjusted it, the second they ordered in a new modulator. both times it solved the problem for a day or two and then back to the same problem. they have a serious problem with this sun roof. they have not sold alot of jeeps with the skyslider, so the complaints may be few, but i have talked to a couple owners and they have all had the same problem. *tr | |||
03/09/2009 | 10458 | 1 | |
Within the interior of the jeep there are stress points where the plastic was molded, and due to the cheap nature of the plastic where the stress points (plastic clip areas) are located there are discoloration spots forming in the plastic interior in several locations within the interior of the jeep. this is unacceptable and a complete failure of quality control. *tr | |||
10/20/2008 | 14418 | 1 | |
Sky slider roof does not stay tight to frame and also has serious wind noise. *tr | |||
06/01/2008 | 20 | 1 | |
The skyslider roof on truck make loud wind noise when driving above 60 mph so loud you can't hear car horns. i have been to dealer 5 times and it has not been fixed yet. *tr | |||
STRUCTURE - BODY | |||
07/03/2012 | 31525 | ||
Upon opening skyslider passanger side of top did not open, when finally starting to open got stuc at first frame. would not close properly. this needs to be recalled. consumer should not have this many problems. | |||
STRUCTURE - BODY - DOOR | |||
12/01/2008 | 8000 | 1 | |
Interior front and rear door handles plastics scratch very easily due to lack of oil used for plastic production. the plastic needs to be replaced due to the use of only cheap paint being painted over the handle areas. *tr |