Kenworth T400 1989
Model T400 made in 1989 by Kenworth got 3 recalls. There were some recalls concerningelectrical system, suspension and visibility.
Model 1989
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ELECTRICAL SYSTEM - WIRING | ||||||||||||||||
89V036000 | PACCAR, INCORPORATED | from 05/01/1988 to 01/01/1989 | V (Vehicle) | 650 | 06/20/1989 | MFR | PACCAR INCORPORATED | 03/10/1989 | 03/21/1989 | |||||||
Defect Summary | Trailer wiring harness connector could cause intermittent or total failure of trailer brake lights or all of the trailer lights. | |||||||||||||||
Consequence Summary | This would affect other drivers ability to see thetrailer and could result in an accident. | |||||||||||||||
Corrective Summary | Replace trailer wiring harness connector. | |||||||||||||||
Notes | System: trailer wiring harness connector.vehicle description: heavy duty trucks. | |||||||||||||||
SUSPENSION - REAR | ||||||||||||||||
91V044000 | PACCAR, INCORPORATED | from 05/01/1989 to 10/01/1989 | V (Vehicle) | 5623 | 06/03/1991 | MFR | PACCAR INCORPORATED | 03/14/1991 | 03/21/1991 | |||||||
Defect Summary | Rear axle stabilizer (sway) bar may not have been properly heat treated. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | Replace the stabilizer bar. | |||||||||||||||
Notes | System: rear axle stabilizer (sway) bar.vehicle description: trucks with airglide 100 rear axle suspension.consequnce of defect: stabilizer bars with insufficient hardness may fail,causing loss of vehicle control that could result in an accident. | |||||||||||||||
VISIBILITY - WINDSHIELD WIPER/WASHER - LINKAGES | ||||||||||||||||
91V090000 | PACCAR, INCORPORATED | from 05/01/1988 to 08/01/1990 | V (Vehicle) | 15000 | 09/30/1991 | MFR | PACCAR INCORPORATED | 06/10/1991 | 06/20/1991 | |||||||
Defect Summary | Sprague wiper assembly pivot can seize due to galvanic corrosion between the zinc-plated steel shaft and the bronze bushings. | |||||||||||||||
Consequence Summary | This corrosion can cause wiper arm/blade assembly to stopwiping windshield, this could affect driver visibility and result in anaccident. | |||||||||||||||
Corrective Summary | Replace sprague wiper assembly pivot with an assembly not susceptible to galvanic corrosion. | |||||||||||||||
Notes | System: wiper assembly pivot.veehicle description: heavy trucks equipped with sprague wiper assembly pivot. |