Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, AIR - ANTILOCK - ABS WARNING LIGHT
1721509/01/200310004076The amber anti-lock brake system (abs) warning light on with diagnostic trouble codes c1235, c1236/c1237 stored in memory. *tt11/17/2003
SERVICE BRAKES, HYDRAULIC
1692606/01/200310002637Stability assist (advancetrac/ivd) systems may not be recalibrated properly using wds. *tt09/09/2003
SERVICE BRAKES, HYDRAULIC - ANTILOCK - CONTROL UNIT/MODULE
0326307/05/200310008281Anti-lock brake system (abs) lamp illuminated and diagnostic trouble code (dtc) c1235, c1236, c1237 on vehicles with differential-mounted rar wheel speed sensor. *tt07/26/2004

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC
09/02/201140000
 The brake pedal and accelerator pedal are too close together and there is a tendancy for the foot to span the distance between brake pedal and accelerator pedal causing the vehicle to speed up when placed in gear forward or backwards, which can result in unavoidable accidents with persons, property or vehicles. the automatic adjuster for both pedals moves them in unison at the same distance from each other causing one to span the distance from one pedal to the other. with the amount of torque from the engine the brake pedal will not hold the vehicle should the foot unavoidably press the accelerator pedal. the distance between the two pedals should be increased to avoid the foot from spaning from the brake pedal to the accelerator pedal.
11/01/200421
 Multiple failures in 2003 lincoln aviator. difficulty turning , starting, jerk in steering wheel, vibration in tires, gear changer loose and ect. *bf the consumer purchased the vehicle with 18 inch rims but ford requires 17 inch rims to be legal (oem) equipment. the consumer felt that this was maliciously dishonest sale of an automobile. the side fender had a gauge on the inside, the rear storage section leather ripped, the tire monitor system kept coming on with a warning sign from the computer of a mechanical defect, difficulty starting the vehicle, jerking in the steering wheel, noise in the steering wheel, noise in heating/vent bubbling, passenger front windows were rattling, there was motor noise upon acceleration, front end noise, rear hatch rattled and was shaking, the wheels squealed and rubbed, the doors did not automattically lock when the vehcile was engaged into drive, and the engine knock as if it were running rough. when the service tech tried to shift the gear lever out of park, the entire gear lever had come apart in pieces. the consumer stated that the vehicle was worse than ever. currently when the brakes were applied the steering would go out of control, jerk left and right, shaked out of control and unable to steer. *sc
09/15/20037000
 1. i was sitting at a traffic light first thing in the morning when all my warning lights on the dash came on and my car died. it said low oil pressure. i was able to get the car restarted, and have not experienced the problem again. dealer indicated they could detect no problem. 2. paint in door jambs different color than rest of vehicle. dealer indicated in small crash, probably at time of unloading vehicle...damage repaired and repainted. i had them repaint to make car same color. 3. other - this is my most frustrating problem. when it gets hot out (90 degrees or more), the left side passenger door moulding expands and sticks to the driver door. i cannot open the back door without forcing it, which has chipped the paint on the inside of the front door. this has also happened on the passenger door, but not to the same extent as the driver side. all mouldings have been replaced once, but the problem continues. i have had it in about another six times since for the same problem...most of the time being told there is nothing they can do or there is no problem. they are now ordering some new moulding which will hopefully correct the problem. also, it took me three trips for them to finally fix the air conditioned seat on the passenger side which stopped working. the first time i was told the entire component was replaced...i drove off the lot, and again it wasn't working. i took it back and was pretty much told i was an idiot, it was working. i drove off the lot, it wasn't working. i took it back again, and they found a loose connection in the wiring, which they finally fixed. it now works. 4. the first time i mentioned the squealing brakes, they checked them out and said it was normal. i took the vehicle back again, because the squealing was worse, and they replaced the brakes and pads. obviously, there was a problem!
SERVICE BRAKES, HYDRAULIC - ANTILOCK
07/10/200742000103/31/2003
 I was unable to stop 2003 aviator and ran into a building. there was extensive damage. *ak
01/01/20048000309/28/2003
 Dt: the contact stated the abs and parking lights illuminated. when this occurred he took the vehicle to the dealership. they replaced the rear brake sensor three separate times. he stated there were no other problems. *ak updated 01/25/06. *jb
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
05/27/2004168641009/11/2003
 Dt*: the contact stated a whining noise was heard coming from the rear of the vehicle while driving 55 mph. the vehicle was taken to the sales/service dealer for repairs. the right rear axle and pinion were replaced as well as the c b shaft assembly and gear and pinion locking pin. this was the third time the rear end was replaced in a two year period. the manufacturer was notified and a technician was sent to inspect the vehicle.*ak the vehicle pulled to the left, the door lock switch was inoperative, the rear shock was leaking oil, the e power steering hose was replaced, there was a ticking sound coming from the engine compartment. the timing chain and gasket were replaced. the door ajar light came on after all the doors were closed. the consumer stated the shifting of the gears were harsh, the dealer replaced various componets in the transmission. the right rear brake light bulb was replaced, the master cylinder was replaced. the front seat climate control was not cooling. the battery was replaced, the accelerator cable was sticking. updated 12/05/06. *jb
09/11/200650000110/01/2003
 Dt*: the contact stated while applying brake pressure at any speed, there was an increased stopping distance. the vehicle was inspected by an independent repair shop and a dealer who both determined the master cylinder needed to be replaced. after the dealer replaced the master cylinder, the problem persisted. the vehicle was returned to the dealer who determined the master cylinder needed to be replaced again. the master cylinder part needed for repair was on back order and not available at any area dealerships. the manufacturer was alerted.