Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
STRUCTURE - FRAME AND MEMBERS
98V323000FORD MOTOR COMPANYfrom 11/04/1987 to 11/18/1994V (Vehicle)269700001/18/1999ODIFORD MOTOR COMPANY12/16/199812/18/1998
Defect SummaryVehicle description: passenger vehicles originally sold or currently registered in connecticut, delaware, district of columbia, illinois, indiana, iowa, kansas, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, nebraska, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, virginia, west virgnia, and wisconsin. the rear lower subframe mount plate nut can experience stress corrosion cracking if subjected to long term exposure to road salts. this can result in fracture and loss of the structural integrity of the subframe mount attachment. detachment of the body mounts at the rear corners of the subframe, which supports the engine and transmission, allows the rear corners of the subframe to drop.
Consequence SummaryIf both rear corners drop, steering would become suddenly very difficult, affecting vehicle control and increasing the risk of a crash.
Corrective SummaryDealers will install subframe rear mount bolts, reinforcement plates, and plate nuts.
NotesNote:this recall campaign supercedes recall campaign 93v-106.owner notification is expected to begin january 18, 1999.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford at 1-800-392-3673.also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

Consumer Complaints


Fail datemilesoccurencesPurchase date
STRUCTURE
109/10/1996
 The welded washer to the frame for the strut bar mounting failed. *slc
STRUCTURE - BODY - DOOR
06/08/20011
 When the electrical components got wet in a flood, system malfunctioned. vehicle has power windows and doors. consumer was unable to exit vehicle from inside, and doors failed to open from outside. *ak once the electrical system failes, it is impossible to open doors and windows with keys from inside and outside of the vehicle. *yh
1
 Driver's side inside door handle broke. mjs
1
 Driver's side door pulling away from frame, causing air noise. mjs
09/02/199508/01/1995
 The door locks would not always automatically lock when the car was put into drive when i purchased it. i took it back in several times and had it checked but they could never repair the problem. now the doors will not lock at all unless it is done manually. the remote and keyless entry will not work either. the automatic leveling system makes an awful whirring noise now that the dealer says is normal. it wasn't normal when the car was new because it did not make that noise. *ak
03/01/1998209/11/1995
 Inside/outside door handle broke off.
STRUCTURE - BODY - DOOR - HINGE AND ATTACHMENTS
11/06/1996110/03/1995
 Door ajar alarm light illuminates when vehicle is driven over rough terrain.
STRUCTURE - FRAME AND MEMBERS
09/13/20042230001
 While driving 20 mph engine and transmission fell out of the vehicle. as a result the steering failed. dealer stated sub frame corroded. recall 98v323000 was issued for the lower cradle bolts. however, a different part of the cradle bolts failed so the consumer has to pay for the repairs. *ak
1600001
 Recall 98v323000 concerning sub frame corrosion. defect occurred after recall repairs were performed. replacement parts didn't correct the problem.*ak
1407/25/1997
 The consumer has experienced the following: recall head mount , subframe, air bag suspension system, air shock, rear stabilizer and rear shock sensors-bouncing/bobbing in the front of the vehicle, right rear tire, left rear air strut-was blown and was dragging down in back, a conversion of suspension was done to convert to coil springs and replace all 4 struts and hardware, recall brake & motor mount-brake grinding, head gasket, and inner tie rod. (recall #'s 94v129000 & 97v019000) scc
12/19/20011
 Consumer stated intermittently the vehicle will locked up, while driving on a off ramp at 30-35mph, the vehicle shut down, manufacturer referred consumer to a dealer that would diagnose the problem.*ak. consumer stated the problem is a manufacturers defect and the orignial owner was notified, but the consumer was not, therfore the problem will not be covered.*yh
 When driving between 5-10 mph and coming out a parking lot steering wheel locked up, causing loss of control. also, recall 98v323000/ manufacturer's 98s36/ subframe corrosion was issued. however, this vehicle was not included in the recall due to vin. please provide any further details. *ak
04/03/2000
 Received a list of manufacturer's recalls that were not done before purchase or resale of vehicle. consumer would like to know what his recourse is in this matter. one of the recalls involved rear subframe mounts. *ak
12/01/1998208/01/1996
 Took vehicle in for recall #98s36 and was informed that right front and right rear motor mounts were defective and would require replacement at $341.00. i only have 87,000 miles on the vehicle and feel that is low mileage for a motor mount to fail. *ak