Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| EXTERIOR LIGHTING | |||||
| SB-09-057-10 | 12/23/2010 | 10037655 | Mazda: there is condensation and fog in the front and rear combination lights. *rm | 06/01/2011 | |
| SB-09-057-10 | 12/23/2010 | 10037655 | Ready | 06/01/2011 | |
| EXTERIOR LIGHTING - HEADLIGHTS | |||||
| 09-005-11 | 02/07/2011 | 10037949 | Mazda: there is possible excessive condensation or water inside the headlamp unit on many mazda models. *rm | 06/08/2011 | |
| 09-005-11 | 02/07/2011 | 10037949 | Ready | 06/08/2011 | |
| 09-010/11 | 03/01/2011 | 10037519 | Ready | 05/25/2011 | |
| 09-010/11 | 03/01/2011 | 10037519 | Mazda: some vehicles may have a low beam headlight malfunction. moisture may get into the unit and cause it to short. *rm | 05/25/2011 | |
| EXTERIOR LIGHTING - HEADLIGHTS - CONCEALMENT DEVICES | |||||
| SB-09-057-10 | 12/23/2010 | 10037655 | Ready | 06/01/2011 | |
| SB-09-057-10 | 12/23/2010 | 10037655 | Mazda: there is condensation and fog in the front and rear combination lights. *rm | 06/01/2011 | |
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| EXTERIOR LIGHTING | |||
| 11/04/2010 | 69700 | 4 | 01/01/2010 |
| 2007 mazda cx-7. consumer experienced several problems with vehicle *tgw the consumer stated shortly after she purchased the vehicle, she noticed the headlights pointing toward the ground and it took 3-5 trips to the dealer before it was properly fixed. in june 2010, the check engine light illuminated. the dealer diagnosed the problem as an evap system leak which cost $461.80. in october 2010, during a routine inspection, it was discovered that the vehicle needed an outer tie rod end, in addition to that an alignment was also needed. one week later, the ac compressor failed. *jb | |||
| 01/01/2008 | 16000 | 1 | |
| Algae forms between the rear taillight clear lens and moulded gray inner housing. because the 2 pieces are glued together a person cannot get to the algae to clean it . the algae forms where there is missing adhesive to bond the 2 pieces together. *tr | |||