Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
UNKNOWN OR OTHER
0030704/18/200710021610Availability of non-required tools. *kb06/11/2007
01010408/01/200410010040During assembly a lubricant used to ease the installation of the door weather-strip caused staining over the clear coat on the door sashes. special service program (ssp) 57. *nm11/03/2004
0813200408/13/200410009918Dealer notice - service bulletin release - 08/13/2004. *tt11/02/2004
03240403/24/200410007045Dealer notice - service bulletin release (03/24/04). mazda *tt05/25/2004

Consumer Complaints


Fail datemilesoccurencesPurchase date
UNKNOWN OR OTHER
02/17/2011102290
 On 17 feb 2011 i was driving my 2003 mazda 6s and while driving at a low speed of 25 mph all my lights on my dashboard turned on and my car immediately began to reduce speed almost to a stand still. luckily i was able to pull to the side of the road in time to avoid any accidents or possible damage to my vehicle. i restarted my car and was able to proceed in driving. however my engine light remained on. i researched this issue online and found that someone with the same model vehicle and year had the same issue almost verbatim. the referrenced a service bulletin from mazda bulletin no: 01-016/06 released in 2006 regarding throttle body replacement. i read the bulletin and sure enough it stated to inspect the letters on the throttle body. it showed aa,ab,ba markings = no good and bb marking = good. so i inspected my vehicles throttle body letter and sure enough it was aa. i will have to definately replace it, and of course i have no choice because you can imagine the ramifications of driving on a highway or freeway and something like this were to occur. accidents, or even death. it is pretty upsetting that something has not been done to correct these issues especially with the potential consequences of this defect!
06/01/201087000
 Clutch pedal assembly cracks causing it to be difficult to shift gears, clutch will stick and not spring back. eventually the car is unuseable due to the clutch. i did research to see there are many complaints on this problem concerning mazda3, mazda6 and the rx8. i had to buy a new clutch pedal assembly but seems the problem is happening again. mazda needs to make a stronger bracket to reinforce the pedal assembly.
08/21/20081
 My complaint is with the service center in medford ny mazda. they had my car for a total of 2 yrs. and could not fix there was no accident. *tr