Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ENGINE AND ENGINE COOLING
9712280019712/28/199754134Vehicles may experience a thump noise from the heater core that may be accompanied by excessive temperature gauge fluctuation. *yc03/30/1998
008/97T05/19/199752500Temperature guage fluctuates or indicates high temperature. *tw08/14/1997
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE
0179905/28/1999606027Motor oil - sae viscosity grade recommendation. *tt08/05/1999
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM
0129811/04/1998F00296602676Experiencing a buzzing or rattling noise may be heard coming from the exhaust system during normal driving conditions or at idle. *yc01/06/1999

Consumer Complaints


Fail datemilesoccurencesPurchase date
ENGINE AND ENGINE COOLING - COOLING SYSTEM - RADIATOR ASSEMBLY
07/15/199806/01/1997
 While driving transmission would not shift into gear and would pop out. in addition, vehicle bounces or drifts to the right and emergency parking brake works intermittently/makes a popping noise when pushed in, and thermostat overheated while driving. dealer notified of all problems, some replacements were made, major problem still exists. *ak *ml
02/27/1995103/15/1994
 Radiator drain ring failed, causing leak.
ENGINE AND ENGINE COOLING - ENGINE
02/06/2001111/01/1996
 Pulley was defective and redesigned. owners should be notified that pulley can disentegrate causing belt to break resulting in loss of power steering, overheating, and battery charging. the company redesinged the pulley so they know they had a problem, but the consumer is at risk. it also cost $165.00 parts and labor to fix. if it was a design problem, i think i should be reimbursed for the failure. fortunately, i was stopped at the time the belt separated. i would hate to have lost my steering at 70 mph.*ak
12/08/1994103/15/1994
 Drive belt failed, causing noise.
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE - BELTS AND ASSOCIATED PULLEYS
02/06/2001
 Serpentine belt idler pulley is defective. when bearings went, it would cause belt to overheat and then snap. would lose power steering control. steering would go into a hard manual steering instead. *ak
1
 Drive belt makes noise.