Mercedes Benz 280 1994
Model 280 made in 1994 by Mercedes Benz got 28 consumer complains. Consumer complaints with reference, among others things, to air bags, electrical system and engine and engine cooling.
Model 1994
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| AIR BAGS | |||
| 04/16/1998 | |||
| While vehicle was in drive with foot on brake pedal, the vehicle surged foward, hit a wall in garage, causing passenger's side air bag to deploy, while driver's side air bag did not deploy. please provide details. *ak | |||
| 11/20/1994 | 2 | ||
| Other: airbag failed twice. *skd | |||
| AIR BAGS - FRONTAL | |||
| 04/16/1998 | |||
| While vehicle was in drive with foot on brake pedal, the vehicle surged foward, hit a wall in garage, causing passenger's side air bag to deploy, while driver's side air bag did not deploy. please provide details. *ak | |||
| ELECTRICAL SYSTEM | |||
| 07/01/2011 | 250000 | ||
| 1994 c280 mercedes caught fire after being driven for about 15 minutes. mercedes was destroyed and car next to it totalled as well. house damaged (cars were in driveway). fire inspector said fire started under hood, appears it was probably the wiring harness. firemen had to use special foam to put fire out because of magnesium parts on mercedes, can't use water because it will cause an explosion. it burned for over an hour and took the firemen at least half an hour to put it out. this needs to be addressed by mercedes benz. | |||
| 06/25/2010 | 154000 | ||
| Engine wiring harness has brittle insulation; has hundreds of cracks; insulation is falling off of wires; is short circuiting, motor is running rough; missing some; sounds like its not running on all cylinders. wiring harness is heating where it is short circuiting. i have seen some smoking; was on fire once so far. | |||
| 08/13/2008 | 94000 | 1 | |
| I have a 1994 mercedez benz c280 and was purchased in 2004 with approximately 94,000 miles. not long after having the car i start having erratic misfire codes showing up on the computer. i was told that it was possible a wiring harness problem which this make and year of car is having. now i find on the internet a report dated in 2007 of over 300 people with mercedez vehicles from 1991 to 1996 having similar problem. this site ask if i would add my car to the list.*tr | |||
| 08/01/2008 | 123000 | 1 | |
| 1994 c280 mercedes has engine wiring harness defect due to wires shearing and being exposed. from internet research it is clear that this is a design defect and that the insulation is not heat resistant. the car started to smoke due to exposed wires touching and shorted out a.c. the car cannot be driven now until wiring harness is replaced due to risk of fire. this car is a death trap - just glad i caught it when i did. *tr | |||
| ELECTRICAL SYSTEM - WIRING | |||
| 07/13/2006 | 173000 | 1 | 12/19/2005 |
| The engine wiring harness (that supplies 12 volts dc to the coils that convert it into high voltage for use in the spark plugs), had a critical failure in the wire insulation. over time the insulation will harden and crack to the point that wires short out. this failure is not limited to only this harness, in fact it has been found to cause electrical fires in other parts of the car. though my car has not had a fire, the harness did have this insulation failure, which caused cylinders 2 and 5 to misfire completely, on a permanent basis until i replaced the harness at a cost of $800 for the part alone. i replaced the part myself to save the cost of shop time. this was a critical safety issue because it severely impacted the power available in the car, and when entering a heavily traveled intersection from a stop sign, i was nearly t-boned by an oncoming car because it was so difficult to get the car up to speed. this is a known issue for model years 1994-1997. i know of a person who lives not far from me, who experienced an engine fire due to this failure. *jb | |||
| 03/31/2006 | 98000 | 1 | 03/18/2004 |
| Wiring harness insulation disintegration problem with a 1994 mercedes benz c280(vin #wdbha28e5rf074261). wiring harness insulation failure causing frequent hesitation of the vehicle . this problem has caused some safety concerns when pulling into traffic. to sum it up mercedes is all to aware of the problem but yet has offered limited assistance to the consumer. i am currently pursuing assistance from daimler benz to fix the problem with the car. i will follow up with the results of how mercedes handles this problem. *jb | |||
| 05/03/2002 | |||
| Wiring harness is bad on my c280 mercedes. they know about this problem and will not admit it. my car stalled going down a hill on the way to park city. i almost wrecked it. this information is all over the internet, but mercedes will not do a recall. *la | |||
| ELECTRICAL SYSTEM - WIRING - FRONT UNDERHOOD | |||
| 02/06/2007 | 89000 | 6 | 01/12/2007 |
| Tl*the contact owns a 1994 mercedes benz 280. immediately after the vehicle was purchased, it began hesitating and surging on several occasions. the failure was noticed while driving 40 mph. the vehicle was taken to a dealer on six separate occasions and they stated that the wiring harness failed. the current mileage was 90,000 and failure mileage was 89,000. | |||
| 02/25/2004 | 1 | 11/15/2000 | |
| Wire harness on car factory installed by merecedes becomes brittle and cracks exposing wiring creating problems with electrical system. *ak | |||
| 10/24/2002 | 1 | 04/01/2094 | |
| This vehicle was diagnosed with a leaking head gasket and failed engine wiring harness. the oil leak had begun over three years ago, but was minor and i was lead to believe that it was a minor seal or gasket. upon contacting other owners of the same type of vehicle, i found out that it was generally known by many owners of c280's that the head gaskets leak oil and the engine wiring harnesses go bad. the term most used was it is not a question of if it will fail but when it will fail. upon learning this information i inspected the wiring in the car and in areas where the wires were not wrapped together, i could see the insulation cracking and where the wiring looked fine, all i had to do is lightly move the wires and a new crack would develop. where the cracks existed you could see the wire strands below. i strongly believe that the wiring harness failure can lead to equipment failure and potentially an engine fire. in my opinion an engine wiring harness should last the life of the car, definitely longer than 50k miles as should a head gasket that hasn't been stressed in an over heat situation. it is also my understanding that the headgasket has been revised in later versions. dt | |||
| ENGINE AND ENGINE COOLING | |||
| 09/01/2007 | 70000 | 1 | |
| My 1994 mercedes benz would stop in traffic for no reason. *tr | |||
| ENGINE AND ENGINE COOLING - ENGINE - GASOLINE | |||
| 10/24/2002 | 1 | 04/01/2094 | |
| This vehicle was diagnosed with a leaking head gasket and failed engine wiring harness. the oil leak had begun over three years ago, but was minor and i was lead to believe that it was a minor seal or gasket. upon contacting other owners of the same type of vehicle, i found out that it was generally known by many owners of c280's that the head gaskets leak oil and the engine wiring harnesses go bad. the term most used was it is not a question of if it will fail but when it will fail. upon learning this information i inspected the wiring in the car and in areas where the wires were not wrapped together, i could see the insulation cracking and where the wiring looked fine, all i had to do is lightly move the wires and a new crack would develop. where the cracks existed you could see the wire strands below. i strongly believe that the wiring harness failure can lead to equipment failure and potentially an engine fire. in my opinion an engine wiring harness should last the life of the car, definitely longer than 50k miles as should a head gasket that hasn't been stressed in an over heat situation. it is also my understanding that the headgasket has been revised in later versions. dt | |||
| SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||
| While driving experienced abs failure, upon braking pedal went to floor, brakes seemed ineffective in stopping, causing extended stopping distance.*ak | |||
| 02/01/1996 | |||
| Abs brakes; failure on the brake system caused the consumer to have an accident, electrical short or shock. *ak | |||
| STRUCTURE - BODY | |||
| 03/01/1994 | 1 | ||
| Problem with roof. *ak | |||
| SUSPENSION - FRONT | |||
| 01/16/1995 | 6 | ||
| Vehicle shimmeys. *sd | |||
| VEHICLE SPEED CONTROL | |||
| 1 | 06/01/1994 | ||
| Cruise control failed. | |||
| 08/11/1998 | 1 | 07/01/1994 | |
| This is an intermittent problem that happens when slowing down for a stop light and applying pressure to the brake pedal, the vehicle will suddenly accelerate forward for a second. driver has to press harder on the brake pedal for vehicle to stop. *ak | |||
| 04/16/1998 | |||
| While vehicle was in drive with foot on brake pedal, the vehicle surged foward, hit a wall in garage, causing passenger's side air bag to deploy, while driver's side air bag did not deploy. please provide details. *ak | |||
| VISIBILITY - WINDSHIELD | |||
| 1 | |||
| Trouble seeing through windshield when raining at night. | |||
| VISIBILITY - WINDSHIELD WIPER/WASHER | |||
| 1 | 06/01/1994 | ||
| Windshield wiper is inadequate causing poor visibility. | |||
Car dealers selling
| State | City | Zip | Name | Phone |
|---|---|---|---|---|
| UT | SALT LAKE CITY | KEN GARFF MERCEDES |