Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ENGINE AND ENGINE COOLING - ENGINE
TSB-11-3-2203/15/201110040948Ford: there may be a leaking/stuck canister purge valve which can cause multiple driving systems. the malfunction light may be on with or without stored trouble codes. *rm09/14/2011
TSB-11-3-2203/15/201110040948Ready09/14/2011
TSB-10-19-109/17/201010037083Ready05/04/2011
TSB-10-19-109/17/201010037083Ford: on various 2009-2010 models there may be a malfunction light on with five possible fault codes. *rm05/04/2011
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - EMISSION CONTROL
TSB11-1-502/01/201110037561Ready05/25/2011
TSB11-1-502/01/201110037561Ford: vehicles may run rough, hard start after refueling, clicking noise under hood, and have trouble codes stored. *rm05/25/2011
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - MANIFOLD/HEADER/MUFFLER/TAIL PIPE
TSB-10-18-309/07/201010037097Ford: some hybrid vehicles may have a malfunction light on with two possible fault codes. *rm05/04/2011
TSB-10-18-309/07/201010037097Ready05/04/2011

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
ENGINE
PE13003Ford Motor Company02/21/2013Electronic Throttle Body Malfunction
 In a letter dated august 30, 2012, the north carolina consumers council (nccc) petitioned the national highway traffic safety administration (nhtsa) to initiate a defect investigation of alleged electronic throttle body failures resulting in engine stall or surge while driving in model year (my) 2005 through 2012 ford escape vehicles.on october 2, 2012 the office of defects investigation (odi) opened a defect petition dp12-006 to evaluate whether to grant or deny the petition. the petition is hereby granted on certain model years.the nccc letter cites two complaints of stall while driving in my 2009 ford escape vehicles that were diagnosed as failed throttle bodies with diagnostic trouble codes (dtc) p2111, throttle body stuck open, and p2112, throttle body stuck closed. the petitioner indicates that the owners of both vehicles reported experiencing repeated incidents of stalling and engine surging.according to ford, escape non-hybrid vehicles are equipped with electronic throttle body (etb) assemblies beginning with my 2009.vehicles manufactured between june 22, 2009 and october 15, 2009 may contain contaminated printed circuit boards (pcb) with plating variations. plating variations could lead to a lack of continuity in the throttle position sensor circuit where p2111 and/or other dtcs would be generated and stored.ford and its electronic throttle body supplier, delphi, modified the pcb manufacturing process and issued a technical service bulletin (tsb) 09-23-5.vehicles produced after october 15, 2009 incorporated etbs manufactured with a pcb process that resolved this condition.odi's analysis identified a total of 123 unique reports indicating allegations of reduced motive power or vehicle stall.depending on the condition of throttle control system malfunction, a driver may experience varying levels of reduced engine performance associated with three limp home modes.in two limp modes, reduced engine performance may maintain vehicle speeds above 20mph while the third is a limited limp home mode with engine speeds limited to approximately 900 rpm. allegations of stall appear to be related to the limited limp home mode.vehicles are not likely to unexpectedly stall as a result of this condition, but drivers may characterize the reduced functionality as a stall, even though their vehicle may still has motive capability.allegations of vehicle surge appear to be related to limp home mode operation.complaints alleging surge are most likely related to engine rpm fluctuations at low vehicle speeds or idle as the control system engages to prevent engine stall.in limited limp mode, rough-idle conditions may exist while the control system attempts to modulate engine rpms once the vehicle reaches a reduced speed to maintain approximately 900 rpm.separately, odi received 59 complaints alleging incidents of engine stall while driving in model year (my) 2010-2011 ford fusion vehicles.approximately 60 percent (36) of the incidents occurred at speeds of 40 miles per hour or more.eighty percent of complaints (47) were received beginning march 2012 and 14 complaints reported that the throttle body was replaced or dtcs associated with limp home modes. additionally, ford issued tsb 10-21-6 addressing dtcs associated with idle speed drops and limited limp home mode.the complaints show an apparent increasing trend.a preliminary evaluation has been opened to assess the scope, frequency and potential safety consequences associated with the alleged defect.see additional information for the voqs associated with the opening of this investigation.

Consumer Complaints


Fail datemilesoccurencesPurchase date
ENGINE
12/05/201259995
 After coming to a stop at a light or stop sign, as i accelerate my car jumps/jerks as if it's straining to switch to next gear. generally happens when accelerating between 10-40 miles. when it initially started it would happen 1-2 times a week. now it happens every day. i have an appointment schedule to have dealer look at vehicle.
ENGINE AND ENGINE COOLING
08/16/201120000
 The vehicle stalls randomly. i may be driving slowly or idling and the car stalls. this has happened at yield signs, red lights and going down hill. this is very dangerous. one time at a right signal arrow it stalled going up a slight incline and i almost got hit from the back. it is easily started again by putting the car in neutral and turning the key. i brought it to the dealer because the car wouldn't start and had to be jumped. they replace the battery and blamed the battery on the problem. it is still happening and i am bringing it again.
04/17/201116530
 Coming to red light one car in front of me. i pushed down on brake petal and it was hard to push down. engine revved up to over 5 rpm's and car wouldn't stop finally i put car in neutral and engine went back to idle position. almost rear ended car in front of me. took mariner to dealer who wasn't very helpful because he never heard of this before & wanted to know if i wanted to leave mariner there. also ask if i had my foot on the gas petal instead of the brake. dealer was unable to verify concern so they replaced canister purge valve. have also had transmission problems with this mariner that i believe still exist. filled out surveys and was told manager would call but no one ever contacted me. very unprofessional dealer.
09/10/2009173601
 Engine stalls and pick-up is wobbly. *tr