Mg Midget 1976
Model Midget made in 1976 by Mg got 2 recalls. There were some recalls concerningfuel system, gasoline, service brakes, hydraulic.
Model 1976
Recalls
| Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| FUEL SYSTEM, GASOLINE - DELIVERY - HOSES, LINES/PIPING, AND FITTINGS | ||||||||||||||||
| 78V080000 | JAGUAR CARS | from 08/01/1974 to 09/01/1976 | V (Vehicle) | 25000 | 08/16/1978 | ODI | JAGUAR ROVER TRIUMPH INC. | 04/13/1978 | 10/12/1979 | |||||||
| Defect Summary | The fuel pipe brackets mounted in the cylinder head rear stud have been misaligned on the involved vehicles. as a result, the nylon fuel feed pipe may sustain chafing and feed pipe damage. | |||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | The dealer will inspect and, if necessary, correct the alignment of the fuel pipe bracket. if damaged, the fuel pipe will also be replaced. | |||||||||||||||
| Notes | Vehicle description: passenger vehicles.system: fuel; pipe bracket.consequences of defect: continued operation of the vehicle in this conditioncould result in fuel leakage, thereby creating a potential risk of fire. in theevent of a fire, personal injury could occur.note: should there be any fuel leakage in the engine compartment, the vehicleshould not be operated. | |||||||||||||||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DIFFERENTIAL PROPORTIONAL VALVE | ||||||||||||||||
| 76V090000 | JAGUAR CARS | V (Vehicle) | 9299 | 07/14/1976 | MFR | JAGUAR ROVER TRIUMPH INC. | 06/24/1976 | 10/12/1979 | ||||||||
| Defect Summary | ||||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | ||||||||||||||||
| Notes | Mg campaign no b031.possibility that the copper washer, which is fitted underthe end plug in the brake pressure differential warning unit has not beenproperly annealed.if this condition exists, it could result in loss of brakefluid and possible reduction in braking ability.(correct by inspecting andreplacing copper washer to brake pressure differential switch). | |||||||||||||||