Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
ELECTRICAL SYSTEM - BATTERY | |||||
TSB9716001 | 03/01/1997 | 52083 | Battery discharge during idling. *jd | 07/17/1997 | |
ELECTRICAL SYSTEM - FUSES AND CIRCUIT BREAKERS | |||||
97090154011 | 09/01/1997 | 54300 | Multi-purpose fuse capacity is incorrectly specified in the affected service manual pages. *yc | 03/30/1998 |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
ELECTRICAL SYSTEM | |||
06/22/2000 | 2 | 06/04/2000 | |
Dealer informed consumer that the mileage on vehicle which read 053086 was not the original mileage and that the previous owner had replaced the speedometer at 35992 miles because the vehicle had experienced electrical problems and the odometer was inoperative, dealer could not repair vehicle under warranty due to mileage. *tt | |||
7 | |||
Electrical system failed causing the windows to go down after the vehicle is shut off and the key is out of the ignition. | |||
ELECTRICAL SYSTEM - ALTERNATOR/GENERATOR/REGULATOR | |||
06/01/1996 | 1 | 04/07/1996 | |
Alternator failed. | |||
ELECTRICAL SYSTEM - BATTERY | |||
11/01/1996 | 1 | 06/01/1996 | |
Battery failed. | |||
ELECTRICAL SYSTEM - WIRING - INTERIOR/UNDER DASH | |||
04/05/2004 | 98600 | 1 | 03/17/1997 |
Took in my 1996 mitsubishi galant es for it's yearly inspection. vechicle failed due to obd readiness monitor saying my check engine light was on. the light was noton and in fact wokred perfectly as tested by turning on the engine, the light would come on for a few seconds as part of the start up then turn off. i had two shops read the ecm with a snap on tools computer to see if there were any codes in the computer. there were none, but it did say that the check engine light was on, even though it wasn't. i took it into the salt lake coutny emission control and they performed the same tests yielding the same results. everyone was baffled. the salt lake country emission control thinks the entire ecm is faulty and will need to be replaced.*ak |