Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
ENGINE AND ENGINE COOLING - ENGINE
00V311001MITSUBISHI AMERICAfrom 03/01/1996 to 02/28/1999V (Vehicle)21000010/31/2000ODIMITSUBISHI MOTORS NORTH AMERICA, INC.10/02/200010/24/2000
Defect SummaryVehicle description: passenger vehicles: mirage model vehicles equipped with 1.5l engines; montero sport models equipped with 3.0l engines; and montero models equipped with 3.0l engines. the bolt securing the crankshaft pulley can become loose and the pulley could fall off the vehicle.
Consequence SummaryThe condition can result in a loss of power steering assist, increasing the risk of a crash.
Corrective SummaryOn the mirage vehicles, the dealers will install a new, improved crankshaft pulley bolt on the older engines. on new engines which already have the improved bolt, the dealer will tighten the crankshaft pulley bolt to the correct torque specification. on the montero models, dealers will tighten the crankshaft pulley bolt to the correct torque specifications. if the bolt is damaged, it will be replaced.
NotesOwner notification will be performed in five separate owner mailings, with the first mailing beginning october 31, 2000.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact mitsubishi at 1-800-222-0037. also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ENGINE AND ENGINE COOLING - ENGINE
021100509/01/2002021100510000093Crankshaft bolt tightening - service manual revision. *tt02/12/2003
SR0000710/20/2000618271Mitsubishi motor sales of america, inc. (mmsa) is voluntarily recalling affected vehicles for a possible loose crankshaft pulley bolt. *tt04/11/2001
TSB001100811/01/2000615993This bulletin contains proper camshaft and camshaft oil seal procedures. *tt02/07/2001
981300908/01/1998609764Code no. p0340 camshaft position sensor circuit malfunction, troubleshooting procedures volume 1 service manuals. yd04/10/2000
TSB981100205/01/1998TSB9811002601482Service manual revision on crankshaft pulley bolt torque. *yc08/05/1998
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE
991300710/01/19996088733Vehicles may experience engine surge at 45-50 mph and / or engine sag during cold start. *tt01/06/2000

Consumer Complaints


Fail datemilesoccurencesPurchase date
ENGINE AND ENGINE COOLING - ENGINE
03/05/200202/01/2000
 My camshaft broke in half due to the fact that it was a maufactureres defect before the vehicle was sold. *ak
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE
03/01/20010
 Engine stalls when driving. also, transmission gets stuck into gears. dealership is aware of problems. *ak
07/01/1998107/01/1998
 Engine hesitating continually causing poor driving conditions.
 Check engine light comes after vehicle is started. also engine stalls while driving and would not restart. *ak
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE - BELTS AND ASSOCIATED PULLEYS
11/14/200030562
 While driving at 30 mph the crank shaft pulley bolt recall 00 v 311 001 defect occurred. prior to the incident the dealership had check the crank shaft pulley and indicated that everything was fine, and didn't need replacement.