Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, AIR - ANTILOCK
06/01/200010/01/1999
 The car has major loss of power when accelerating, the transmission skips gears when you start going ,the brakes are bad after only 7,000 miles
SERVICE BRAKES, HYDRAULIC - ANTILOCK
02/24/2003211/05/2001
 Faulty brakes-in dec,2002, had to hit brakes when vehicle pulled in front of me. i immediately lost control of vehicle-no steering- and car spun several times. appeared brakes locked up even though i have abs system. *jb 2/2003-same thing. was couple lengths behind vehicle when car in front suddenly pulled to left lane because a veh had almost stopped in road. when i pushed on brakes, they again locked up with no steering control causing me to hit vehicle in front of me even though i was trying to steer vehicle off into emer lane. was going about 55 and air bags did not even deploy. had problems with brakes/tires squeaking in 12/2001 & took in for repair. was told it was a transmission problem & was repaired under warranty but car still clicked during turns.
08/25/200007/01/1999
 Brakes make a high-pitched squeaking sound when i brake. the car requires alot of braking time & distance to stop - it doesn't stop quickly. the car has died on 4 occasions. three times were at red lights, the fourth i was going about 35 miles an hour. i notifed the nearest dealer (in norco california). the manager of the repair shop had me bring the car in (an hour drive) & then said he was too busy to look at my car when i arrived. i asked if i could leave it & take a replacement or rental car until he had time to inspect the car. he said no, i should just bring it back another day.*ak
01/01/2001402/01/2000
 While driving could step on the brakes pedal and noticed a lack of braking. had taken vehicle four times to dealer for brakes pads to be replaced, but problem still occurs. *ak *jb
05/16/20003
 Brake problems; 3 accidents due to not being able to stop when applying brakes. while pulling into garage brakes did not work, vehicle went straight through back of garage. *ak
12/05/2000
 While pulling in a parking space car speeded up and took off. cosumer's foot was on brake and pushed it to floorboard, crashed into sears wall, and none of airbags deployed. *ak
03/01/2000
 Braking system malfunctioned, causing calipers to break which caused extended stopping distance , and may result in a crash. please provide further information. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
08/23/20002
 Was driving 35mph & applied brakes which were going up & down. they failed to stop vehicle. would shimmy or shake when making turns. was going down hill, and went into a skid. crossed double line to the left while trying to go right. steering was uncontrollable. another vehicle t boned the vehicle on passenger side. air bags deployed. vehicle was only 34 days old.
03/30/2000405/14/1999
 When applying brakes the pedal goes to the floor, causing extended stopping distance. cause unknown. *ak vehicle steered to the right because of steering problem. *yh
10/14/1999
 While driving on highwaywy suddenly approached a red light, applied brakes and the vehicle kept going on a flat surface. brake pedal went straight to the floor. went to a local mechanic and the brake boot was burned. they told consumer a chip flew out,and possibly started the fire. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
07/01/2000
 Brake pads have been replaced every two months since july 2000. at every incident dealer changed brake pads and rotated rotors. *ak
08/23/20002
 Was driving 35mph & applied brakes which were going up & down. they failed to stop vehicle. would shimmy or shake when making turns. was going down hill, and went into a skid. crossed double line to the left while trying to go right. steering was uncontrollable. another vehicle t boned the vehicle on passenger side. air bags deployed. vehicle was only 34 days old.
01/01/1999
 I had a after market accessory added to the car. however when problem occurred i had the accessory disconnected so we could find the true problem. dealer did replace the actuator and that temporily fixed the problem. my brakes squeak and the dealer said that they build up a thin layer of rust when the car sits even for a short time. thus causing the squeaks. if this is true why don't you hear every car squeak as they stop at a light? *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
03/01/2000
 Braking system malfunctioned, causing calipers to break which caused extended stopping distance , and may result in a crash. please provide further information. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
05/28/2004203/15/1999
 Braking produces squeaking and rubbing sounds even after rotors were turned & replaced. multiple pad replacements over the course of the last 3 years. the repeated rubbing and squeaking sounds occur even after brake service after less than 1500 miles. *ak transmission: car is slow to accelerate and sometimes stales upon acceleration attempts from 0 to 40 miles/hour. engine check light keeps coming on....o2 sensor(s) replaced.....catalytic converter problem??????? the car passed its emmission control inspection.
04/01/2000
 Replacing brake pads every 2 months..constant squeaking on front brakes. *ak
01/01/2001402/01/2000
 While driving could step on the brakes pedal and noticed a lack of braking. had taken vehicle four times to dealer for brakes pads to be replaced, but problem still occurs. *ak *jb
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
05/28/2004203/15/1999
 Braking produces squeaking and rubbing sounds even after rotors were turned & replaced. multiple pad replacements over the course of the last 3 years. the repeated rubbing and squeaking sounds occur even after brake service after less than 1500 miles. *ak transmission: car is slow to accelerate and sometimes stales upon acceleration attempts from 0 to 40 miles/hour. engine check light keeps coming on....o2 sensor(s) replaced.....catalytic converter problem??????? the car passed its emmission control inspection.