Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
ENGINE AND ENGINE COOLING - ENGINE | |||||
9823005 | 08/06/1998 | 601488 | Diganosis and repair procedures to eliminate conditions regarding the mil illuminated and/or dtc p1715. 96-98 montero automatic transmissions models produced before 10-97 up to vin wj003864; 97-98 montero sport automatic transmissions mo | 08/06/1998 | |
TSB9711002 | 02/01/1997 | 52060 | New valve lash adjuster noise checking and troubleshooting procedures. *jd | 07/17/1997 |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
ENGINE AND ENGINE COOLING | |||
05/12/2009 | |||
Crankshaft pulley pin/bolt gets sheared off. dash lights come on and vehicle power steering stops working as the pump is not turning because the problem affect the entire pulley system. it also affects the timing gear/belt/harmonic balancer. this is the 3rd time in as many years this has happened. this is the 2nd mechanic who has told me that it's an engine defect because the pin/bolt is too short. there is no warning before it happens. it occurs under normal city driving conditions at low or no speed. | |||
06/15/2008 | 190000 | ||
Tl*the contact owns a 1997 mitsubishi montero. when the vehicle was started, the crankshaft pulley detached from the vehicle. the dealer stated that the contact would be responsible for the repair. the vehicle has not been driven since. the failure mileage was 190,000. | |||
06/25/2007 | 134990 | 1 | 12/03/1997 |
Started car, noticed 3 random lights illuminated on instrument cluster. then power steering was intermittent. then a/c went out and would not cool down. then power steering failed completely. car was driven to repair shop nearby, since no local mitsubishi dealer. mechanic found crankshaft bolt broken that led to power steering and a/c pulley not working. incident led to near loss of control during turning , as power steering would kick in at times during cornering and lead to oversteer. had to change crankshaft bolt, harmonic balancer, timing belt gear, and something else. *tr | |||
09/26/2005 | 92165 | 2 | 12/01/1997 |
Dt*: the contact stated the crankshaft pulley and bolt became disconnected. this occurred twice. | |||
05/25/2003 | 1 | ||
While driving at low speed and without warning the vehicle shut off. *tt | |||
ENGINE AND ENGINE COOLING - COOLING SYSTEM - FAN | |||
06/03/1999 | 1 | 06/01/1997 | |
Entire fan and clutch assembly. sheared off while i was traveling in inter city traffic, if this failure would have occurred while traveling on a highway this assembly could have damaged either the steering, fuel or electrical system. the local dealer and factory representatives have reviewed and come to the conclusion that this is just a failure due to mileage. if this is the case there potentially are many vehicles of this type that may experience the same failure. *ak | |||
ENGINE AND ENGINE COOLING - ENGINE | |||
04/16/2011 | 270000 | ||
1997 mitsubish montero 3.5 liter automatic- crank shaft bolt has come out on 5 seperate occasions and has cost over $3000 to have it replaced. the inside of the crankshaft where the bolt goes is completely stripped to the point i now have to replace the engine. this is not an isolted issue as this appears to be an inherent problem with all years of monteros. there should be a recall for this and mitsubishi should cover the cost for there neglegence. | |||
03/05/2008 | 156000 | ||
1997 mitsubishi montero crankshaft pully came loose three times which created no power steering and no charging of the battery purchased new crankshaft pully but did not help the third time installed a lock washer on the bolt and re torqued to spec last week | |||
08/11/2003 | 1 | ||
Consumer's vehicle had the same problem as stated in recall 00v311002 . the dealer would not repair the vehicle because the vehicle identification number was not included. *ak the crankshaft bolt loosened which resulted in a lost of power steering. *ts *ph *nlm | |||
11/19/2002 | |||
After vehicle crank shaft pulley was impacted and dealership indicated that it was okay. while driving the crank shaft pulley broke. the dealership is refusing to fix the vehicle. please provide more details ts | |||
1 | 06/01/2002 | ||
After driving the car for 49 days the oil plug came out, all the oil fellout of the car and engine locked, dealer says it is not covered my warranty*ak | |||
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE | |||
02/16/2001 | 4 | 06/01/1997 | |
Engine light stays illuminated and never goes off, on one occasion when the battery was failed, the light went off. *slc | |||
03/01/1999 | 12 | 04/01/1997 | |
My suv on numerous occasions has stalled when vehicle comes to stop. on one occasion, my wife was accelerating from a standstill-when the vehicle stalled. on each occasion, we were able to restart the vehicle without problems. however, with the vehicle stalling upon accelerating from standstill in the middle of an intersection could prove to be very dangeroul!!!!!!!!!!! | |||
07/01/1998 | 3 | 06/01/1997 | |
This car has been in the shop 17 times within a year. it was bought brand new. the major problems we have with it are the wheen bearing, airconditioning and the engine shutting down with no warning. when we take it in either they say they cant duplicate the problem. with the wheel bearing, they fixed it the first time. it started to leak again and they said that it wasnt the wheel bearing. | |||
On certain occasions when applying the brakes, engine stalls, and vehicle has to sit for a few minutes in order to be started again. dealer can't duplicate the problem. *ak | |||
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE - BELTS AND ASSOCIATED PULLEYS | |||
07/14/2004 | 1 | ||
While driving a loud clanking noise was heard from the front. all electrical lights flashed on the dashboard. steering column failed to move. consumer was able to maintain the control of the vehicle, and drove it to the dealer for inspection. mechanic determined that the main bolt to the pulley belt sheared off. *ak | |||
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM | |||
06/01/1998 | |||
Brakes/exhaust/crancase emission control devices and cup holder failed. |