Navistar 5000 1998
Model 5000 made in 1998 by Navistar got 1 investigation there is 1 recall as well as 2 service bulletins. Technical service bulletines regarding steering. The car had one investigation (visibility). There was one recall concerning suspension .
Model 1998
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
SUSPENSION - FRONT - WHEEL BEARING | ||||||||||||||||
99V014002 | INTERNATIONAL TRUCK AND ENGINE | from 03/01/1998 to 10/16/1998 | V (Vehicle) | 4024 | 03/29/1999 | MFR | INTERNATIONAL TRUCK & ENGINE CORPORATION | 03/15/1999 | 03/17/1999 | |||||||
Defect Summary | Vehicle description: class 8 heavy duty truck chassis equipped with 16,000 lb., 18,000 lb., or 20,000 lb. heavy duty steering axles. the inner wheel bearing cone for the steering axle wheel hub assembly does not properly fit onto the navistar steering axle spindle assembly. improper fit of the bearing to the spindle increases the stress levels to the steering axle spindle which could cause spindle failure. | |||||||||||||||
Consequence Summary | If the spindle fails, a loss of driver control could occur, increasing the risk of a vehicle crash. | |||||||||||||||
Corrective Summary | Dealers will remove the left and right hub/drum assemblies from the steering axles and replace the inner wheel bearing cones and cups. | |||||||||||||||
Notes | Owner notification began march 29, 1999. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact naavistar at 1-800-448-7825.also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236). |
Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
STEERING | |||||
IK-0500038 | 08/19/2011 | 10041405 | Ready | 09/30/2011 | |
IK-0500038 | 08/19/2011 | 10041405 | Navistar: steering goes into a shimmy after hitting a bump. *rm | 09/30/2011 |
Investigations
NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
---|---|---|---|---|---|---|
VISIBILITY | ||||||
RQ99012 | INTERNATIONAL TRUCK & ENGINE CORPORATION | 06/08/1999 | 01/25/2002 | WINDSHEILD WIPER LINKAGES | 99V102000 | |
On april 26, 1999, navistar filed a defect information report received on for 4,553 model 5000, 9100, 9200, 9300, 9400, and 9900 series vehicles equipped with dana sprague windshield wiper assemblies and manufactured from october 26 through december 15, 1998.the welds between the knurled pivot shaft to the wiper arms and the linkage to the windshield wiper motor can fail rendering the affected wiper (driver or passenger) inoperative.dealers will inspect the wiper arm welds by performing a stall test on the wiper arm.navistar reports that the stall test will individually restrain each wiper to validate the integrity of the suspect weld.all wiper assemblies failing this test will be replaced.navistar's identification number for this recall is 99502.the purpose of this rq is to investigate the scope, cause , chronology, and the timeliness of navistar's actions. |