Navistar 9000i

Model 9000i made by Navistar got 1 recall as well as 3 service bulletins. Technical service bulletines regarding (pws) and steering. There was one recall concerning visibility .

Model 1999


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
99V264000INTERNATIONAL TRUCK AND ENGINEfrom 06/12/1999 to 08/09/1999V (Vehicle)99009/24/1999MFRINTERNATIONAL TRUCK & ENGINE CORPORATION09/20/199910/18/1999
Defect SummaryVehicle description: heavy duty trucks built with code 16xwd (sunshade option code). some wires in the sunshade wire harness had insulation that did not meet temperature specifications. some harnesses have been found to have enough melted insulation to create an electrical short.
Consequence SummaryIf the wire insulation is melted enough to create a short, the potential for a fire exists. this short can also open the circuit that controls all the marker and tail lights. if the tail and marker lights go out, the vehicle could cause a crash.
Corrective SummaryDealers will replace the sunshade wire harness.
NotesInternational recall no. 99510.owner notification began september 24, 1999. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact navistar at 1-800-448-7825.also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
IK-040008806/04/201210044291International: procedure information to resolve issue of overheating and smoking of low mileage, single wheel end brake. *pe06/06/2012
IK-050003808/19/201110041405Navistar: steering goes into a shimmy after hitting a bump. *rm09/30/2011