Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, HYDRAULIC - ANTILOCK
02120A11/02/200502120D10002224Antilock braking system (abs) light on and / or diagnostic trouble code for abs wheel speed sensor. *tt08/15/2003
0212012/05/200210000022Antilock braking system (abs) light on and / or diagnostic trouble code for abs wheel speed sensor. *tt02/07/2003

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC
10/28/2009800001
 2001 nissan frontier xe abs failure. when stopping on semi wet level surface abs engaged followed by complete brake system failure. no brake warning lamp or abs warning lamp was on. could repeat this failure mode in nearby parking lot. abs lamp came on after second failure. now brakes work in non abs mode (can apply full braking pressure to the point of locking the wheels when abs warning lamp is on.) *tr
SERVICE BRAKES, HYDRAULIC - ANTILOCK
11/22/2003440001
 The abs sensor was leaking fluid onto the axle, which caused the wheel to be non-responsive. will be taking vehicle to dealership to have mechanic check out the leakage. the consumer was concerned for his safety. please provide additional information. *jb
06/10/200320000111/22/2000
 Failure of the braking system caused brake pedal to drop half way to the floor (approximately level with gas pedal) and inability to slow or stop the vehicle. none of multiple attempts to apply the service brakes resulted in any braking effect and engine surge was detected in at least one braking attempt. driver resorted to emergency brake, but too late to avoid collision in intersection, two vehicles destroyed, four people where injured. *la
05/01/2001
 Brake pedal goes to floor makes difficult stop. *ak
08/06/20011009/01/2000
 Being a former mechanic and owning a 1995 nissan previously i am appalled at the performance of the braking system.numerous times when braking i can feel the pedal pulsate and the system only had minimal braking force although i applied extreme pressure to the pedal.i am certain there is a design flaw,for i would never had this accident in my 1995 nissan pick-up and i'm certain someone is going to lose their life.
301/01/2001
 Vehicle sometimes does not have the hydraulic pressure to stop the vehicle in a resonable amount of space and time. *ak
SERVICE BRAKES, HYDRAULIC - ANTILOCK - ABS WARNING LIGHT
09/15/2007107800109/10/2007
 Tl*the contact owns a 2001 nissan frontier. while driving 40 mph, the vehicle failed to completely stop when the brakes were applied. the contact could not estimate the length of time the vehicle took to stop. he stated that the abs warning indicator light illuminated. the road conditions were dry. the current and failure mileages were 107,800.
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
01/13/2002
 Consumer was driving about 40mph on highway and another motorist collided with her on highway. she applied brakes and vehicle didn't stop. dealership was aware of problem.*ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
06/05/2003325002
 I have a 2001 nissan frontier that the right inner pad is worn to the sensor. the disc pad is wearing at noticeable angle from leading edge to trailing edge. the other pads are wearing normally. the truck also has a severe brake pull to the right. the pull is worse when hot. the car is undriveable at this time. the car will swith lanes when the brakes are applied. as an ase certified auto technician i believe the cause is the use of phenolic caliper pistons. phenolic pistons are known to cause brake pulls, locked up brakes and uneven pad wear.*ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
06/05/2003325002
 I have a 2001 nissan frontier that the right inner pad is worn to the sensor. the disc pad is wearing at noticeable angle from leading edge to trailing edge. the other pads are wearing normally. the truck also has a severe brake pull to the right. the pull is worse when hot. the car is undriveable at this time. the car will swith lanes when the brakes are applied. as an ase certified auto technician i believe the cause is the use of phenolic caliper pistons. phenolic pistons are known to cause brake pulls, locked up brakes and uneven pad wear.*ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
06/05/2003325002
 I have a 2001 nissan frontier that the right inner pad is worn to the sensor. the disc pad is wearing at noticeable angle from leading edge to trailing edge. the other pads are wearing normally. the truck also has a severe brake pull to the right. the pull is worse when hot. the car is undriveable at this time. the car will swith lanes when the brakes are applied. as an ase certified auto technician i believe the cause is the use of phenolic caliper pistons. phenolic pistons are known to cause brake pulls, locked up brakes and uneven pad wear.*ak
209/01/2000
 This is one of two 2001 frontiers i own. both have had premature wear on the passenger side inside front brake pad. all other pads were fine on both trucks. it sems the pad bcomes lodged in the caliper and does not retract when the brake is released.*ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS
03/02/200733472111/30/2000
 Check brake light came on and stayed on. brake line corroded to the extent that brake fluid leaked out and emptied the master cylinder. could only stop if the master cylinder was constantly refilled. master cylinder would empty as soon as the brake pedal was pushed. *jb
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
07/09/200543251409/28/2000
 While driving at 4:30 am on july 9th, 2005, my wife experienced a momentary brake faluire while exiting a frewway ramp at anthem way in anthem, az wjile traveling about 65 mph. the brakes restored themselves prior to a stoplight at the off-ramp of anthem way and i-17. i have experienced this on a few occaions, but thought it was just my imagination. i have not sought recourse from the dealer, even though the vehicle is under an extended warranty, as i realize that they have to reproduce the problem, which does not manifest itself that often. i believe having been in fleet mangement for 25+ years, that it may be a faulty brake valve. also i am a member of nafa. there was not any accident.
SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES
03/01/20021
 While at a complete stop, with foot on the brake peddle, the peddle began to move in a tapping motion against consumers foot, making a loud noise with each tap, consumer no longer owns the vehicle. *jg