Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||
| 05/11/2004 | 1 | ||
| At any speed vehicle shut off. consumer had no brakes, and almost hit another vehicle. dealer said check engine sensor needed to be replaced. *ak | |||
| 02/28/2003 | 1 | 07/01/2000 | |
| The vehicle was involved in an accident, the air bags and abs did not perform as designed.*jb | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS | |||
| 12/14/2001 | 2 | 10/01/2000 | |
| Consumer states that when applying brakes, wheels lock up, on one occasion it caused a rear end collsion, and damaged vehicle, consumer states that the air bags did not deploy after rear end collision. *tt | |||
| 04/01/2002 | |||
| When pressing the brake pedal, pedal went to the floor and vehicle did not stop. cause is unkwown. please provide any further information.*ak | |||
| 12/14/2001 | 2 | 10/01/2000 | |
| Consumer states that when applying brakes, wheels lock up, on one occasion it caused a rear end collsion, and damaged vehicle, consumer states that the air bags did not deploy after rear end collision. *tt | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS | |||
| 05/13/2003 | 1 | ||
| The vehicles worn brake pads caused the vehicle to experience extended stopping distance. *nlm | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR | |||
| 12/20/2001 | 1 | 12/01/2001 | |
| 2000 nissan sentra experiencing problems with brake equipment, engine sensors and e.c.m. connector.*mr nhtsa recall campaign 01v357000 concerning crank position sensor. after having the crank position sensor replaced the problem recurred. while driving 40 mph check engine light appeared on the dashboard and remained on. vehicle was taken back to the dealer, and consumer was informed that the crank position sensor needed to be replaced again. the vehicle circuit cluster failed causing the odometer, fuel gauge and temp gauge to fail. the rotors warped causing pulsation while braking *nm | |||
| 03/02/2005 | 2 | 12/01/2000 | |
| Nhtsa recall campaign 01v357000 concerning crank position sensor. after having the crank position sensor replaced the problem recurred. while driving 40 mph check engine light appeared on the dashboard and remained on. vehicle was taken back to the dealer, and consumer was informed that the crank position sensor needed to be replaced again. *ak the vehicle circuit cluster failed causing the odometer, fuel gauge and temp gauge to fail. the rotors warped causing pulsation while braking. *nm | |||
| 04/27/2004 | 5 | 09/07/2000 | |
| While driving 55 mph vehicle stalled. the consumer was able to pull the vehicle off of the road. the dealer and manufacturer had been notified. *ak the service dealer couldn't find why the vehicle stalled so he concluded that the fuel pump was the problem. the vehicle still did not start even after a new fuel pump was installed. on another occasion the consumer was told that the ecm module was the problem. recall# 03v477000. the vehicle pulled to the right, the a/c, horn, and the third brake light was inoperative. recall# 01v174000 . the consumer also lost control of the vehicle and hit a guard rail. *sc the front rotors were warped. *jb | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM | |||
| 10/01/2001 | |||
| While driving on snow consumer slammed on brakes and rear brakes wer not braking properly. driver noticed this wheel imprints in snow. please provide any further information.*ak | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER | |||
| 1 | |||
| Consumer called complaining about problems with master air flood meter which caused the gas pedal to get stuck every time she tried to accelerate. manufacturer was contacted ,and stated that they were out of the piece , and that they didn't know when they were going to have it available.*ak | |||