Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, AIR - ANTILOCK
020525006A12/01/200202052500610000749Antilock brake (abs) activation at low speeds on various models including the 1995 and 1996 envoy. *tt03/28/2003
SERVICE BRAKES, HYDRAULIC - ANTILOCK
02052500601/01/2006020525006B10000062Antilock brake (abs) activation at low speeds. *tt02/10/2003
24069907/24/1999608382Subject regarding abs 3-sensor ebc4 - special policy. *tt11/24/1999

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SERVICE BRAKES, HYDRAULIC
EA94038GENERAL MOTORS CORP.10/31/199402/28/2000ABS BRAKING SYSTEM99V193000
 Consumers have alleged that the vehicles brakes intermittently fail
EA94038GENERAL MOTORS CORP.10/31/199402/28/2000ABS BRAKING SYSTEM99I006000
 Consumers have alleged that the vehicles brakes intermittently fail

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, AIR - ANTILOCK - CONTROL UNIT/MODULE
09/24/19991
 Defective abs module caused brake pedal to go to floor when applied brakes. the brake warning light came on and stayed on too. yh
SERVICE BRAKES, HYDRAULIC
1
 The vehicle experienced extended stopping distance.*jb
01/05/1998110/03/1996
 Brake indicator gave a warning sound.
10/01/199709/28/1996
 Multiple brake failures.
SERVICE BRAKES, HYDRAULIC - ANTILOCK
07/09/2002
 Pulling off from a stop consumer heard a loud pop. consumer proceeded to drive vehicle, heard another pop, and abs kicked in. while turning a curve right front passenger's tire flopped inward. please provide any further information.*ak
509/01/1996
 Abs system - in my opinion, the abs is too sensitive. on several occasions the abs activated causing my stopping distance to increase. twice on bumpy surfaces while hard braking i came close to a collision, and in my 20 years of driving experience i know that i would not have that scare with vehilces not equiped with abs. contacted manufacturer on best way to disconect, their only comment was, we don't recommend disconnecting the abs system. you have a case #ea94038 on abs. transmission - on 3 occasions i had my engine light come on and each time the code retrieved was p1870, transmission slippage. i spoke to a transmission repair shop and they gave me an estimate of $1,600.00 to repair of $2,300.00 to replace with gm 3 year/36,000 mile warranty. i found a service bulletin nhtsa# sb052584 with similar discussion. my truck is drivable for short distances so i have not committed to any repairs yet. ball joints - you have an action # ea99022 with similar discussion. i replaced both upper & lower ball joints on both sides earlier this year due to excessive play during routine inspection performed by myself. if a recall takes place, gm should be liable for at least the cost of the parts for those who already repaired their vehilces. thank you.*ak
06/01/1997201/01/1997
 Brake pedal is extremely hard to press, it goes low to the floor and causes extended stopping distance. problem gets better when they put new pads on. then 5,000 to 8,000 miles it happens all over again.*ak mechanic found rotors to be hard they were removed and cleaned and readjusted and also cleaned rear drums, also consumer states a light was on, oxygen sensor was replaced. *jb
 Anti-lock brake system engages when it is not needed, causing an increase in stoppnig distance. dealer has been contacted. *ak
04/05/2000109/01/1996
 No summary listed for above vehicle. *ak
12/21/19982
 Ea94-038/abs braking system: ongoing problem with abs brake failure. when applying brakes intermittently pedal would go to the floor. dealer notified, and informed consume rthat they were unable to duplicate the problem. vehicle was involved in two accidents because of abs failure. *ak
04/22/1998
 Brakes pulsate when brakes are applied. when this occurs, it causes the wheels to lock-up. vehicle been in dealer's shop on three occasions, and nothing could be found. but problem still reoccurring. *ak
11/01/1999802/01/1996
 On numerous occasions the brakes have failed to engage. this happens on wet, snow-covered, gravel, and other road conditions. i see that the nhtsa has investigated the sensors on these vehicles in the past, but has not recalled the oldsmobile. i have reported this to both my local dealer and the selling dealer, grand olds in grand rapids, mi. the local dealer, demaagd oldsmobile of battle creek, mi, has acknowledged several complaints of similar nature. grand olds says they have never heard of this. i consider this to be very dangerous, as i, and numerous other bravada owners have told me they have slid into many intersections. i have had numerous problems with this vehicle, i.e. oxygen sensors (3), antifreeze coolant (necessitating a 4-step, and costly, flush), as well as other problems. i am seriously considering selling it, however, because of the brake problem. i am very frightened to drive it through another winter. i do not understand why the oldsmobile was not recalled. it seems to be a sensor problem, as were the others. any information you can give me would be appreciated. *ak
06/01/19961003/01/1996
 The brakes, when applied on any uneven surface (gravel, small pothole, wet surface, etc.) fail to engage. it feels as though you have no brakes for a few seconds. the brakes eventually do operate, but usually after you are into the intersection. i have asked the local dealer (demaagd oldsmobile, in battle creek, mi) about this repeatedly, and they say that they know that there is a defect, but that no recall has been done. they even offered to disconnect the abs to make it safer. i am very afraid to be approaching the winter months with these brakes. *ak
01/01/1997
 While driving at any speed and apply brakes there was squeaking noise, and the abs kicked in and didn't stop the vehicle. when making a right turn there was a loud noise coming from the front. *ak
 There is excessive brake wear. manufacturer has been notified. *ak
08/25/1999
 Vehicle have been experiencing intermittent problem with erratic braking. whenever brake are applied in an emergency situation, vehicle would have a delayed stopping distance. during normal conditions, brake pedal feels spongy when applied. can nhtsa help in this matter before a potential accident may occur. *ak
04/01/19992
 The abs failure caused accident twice. yh
07/26/1999
 While driving through a drive through, applied brakes and pedal went to floorboard, causing extended stopping distance. dealer contacted and repairwork to be done at owners expense. problem still exist. provided further information. *ak
02/10/1999908/01/1996
 Abs sensors sending false input to abs computer/ car is fine on dry road, but under panic stop on wet road car dives to right and pedal goes to floor. at speeds of 15mph same situation on snow & ice. dealer will not correct problem. six tries. refused to pick car up from dealers lot. *ak
08/30/1996108/11/1996
 Extended stoppimg distance of anti lock brakes resulted in a collision.
11/12/1997101/11/1997
 Abs brakes failed. also replaced front brake rotors/calipers and engine fan belt. *ak
08/22/1997210/25/1996
 Complete abs brake failure. also replaced front brake pads and deglazed rotors. *ak
09/26/1997306/01/1996
 Multiple occasions if applying brakes pedal will go to the floor, not responding to pedal application which resulted in a rear collision. failure is intermittent, making difficult to duplicate. *ak consumer states that brakes simply do not apply, no matter what amount of pressure is applied to the brake pedal, consumer also states that it feels as though vehicle is skidding on ice, one person was injured in the accidnt mentioned above. *slc
06/12/1997
 When it is hot outside the brakes seem to fail. the truck will not always stop when it is hot outside. the brakes fade which result in loss of brakes. *ak
SERVICE BRAKES, HYDRAULIC - ANTILOCK - CONTROL UNIT/MODULE
04/27/200488746109/28/1999
 Abs sensors failed causing brake pulsation and failure. rear wiper motor failed (still on vehicle). *nm
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
207/01/1996
 Brakes failed.
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
06/25/199801/22/1997
 Front disc brake pads wore out prematurely.
11/12/1997101/11/1997
 Abs brakes failed. also replaced front brake rotors/calipers and engine fan belt. *ak
08/22/1997210/25/1996
 Complete abs brake failure. also replaced front brake pads and deglazed rotors. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
 The brakes have worn excessively due to the fact that the calipers are uneven. dealer has to adjust the calipers. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
 There is excessive brake wear. manufacturer has been notified. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM
06/01/1997201/01/1997
 Brake pedal is extremely hard to press, it goes low to the floor and causes extended stopping distance. problem gets better when they put new pads on. then 5,000 to 8,000 miles it happens all over again.*ak mechanic found rotors to be hard they were removed and cleaned and readjusted and also cleaned rear drums, also consumer states a light was on, oxygen sensor was replaced. *jb
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS
09/28/2000109/21/1996
 Due to location of the battery, acid leaked onto brake line, causing brake line to rupture, and resulting in loss of all brake fluid which caused complete brake failure when driving. consumer has contacted the dealer. *ak
07/02/1998105/01/1996
 Battery case cracked and leaked acid onto brake line routed directly below battery. line was damaged by acid and failed causing loss of braking. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
02/19/2003110/04/1996
 The master cylinder leaked fluid, which caused brakes to fail.*jb