Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| VISIBILITY | |||
| 06/11/2010 | 44000 | ||
| Tl- the contact owns a 1994 oldsmobile cutlass. the contact stated that the vehicles windshield wipers do not work. a mechanic told the contact that there was recall on the wiring switch for the vehicle. the recall is campaign number 97v017000, dealing with visibility and switch wiring for the wipers. the manufacturer is no longer honoring the recall because it was issued february 4, 1997. the contact was never made aware that a recall existed on the vehicle. the vin was not available at the time of the complaint. the failure mileage was 44000 and the current mileage was 46000.rl | |||
| VISIBILITY - WINDSHIELD WIPER/WASHER | |||
| 10/12/2002 | |||
| Intermintently the windshield wipers inoperable obstructing the drivers view. a recall has been issued on this similar makes and models, however this vehicle is not due to vin# dealer and manufacturer has been notified. please provide further information. ts | |||
| 02/15/1996 | |||
| The windshield wipers are malfunctioning causing poor visibility which could result in a crash. vehicle has been to the dealer on six occaisions & dealer replaced the windshield wiper motor / hose three times. there is a recall(97v017000), but this vehicle was not included. *yc | |||
| VISIBILITY - WINDSHIELD WIPER/WASHER - MOTOR | |||
| 02/15/1996 | |||
| The windshield wipers are malfunctioning causing poor visibility which could result in a crash. vehicle has been to the dealer on six occaisions & dealer replaced the windshield wiper motor / hose three times. there is a recall(97v017000), but this vehicle was not included. *yc | |||
| VISIBILITY - WINDSHIELD WIPER/WASHER - SWITCH/WIRING | |||
| 05/27/2002 | 1 | 10/01/1993 | |
| Recall 97v017000o repairs concerning windshield wiper/washer switch were done in 1997. on 1 june 2002, windshield wipers stopped working. dealer replaced wiring mechanism.*ak consumer adds windshield wiper system failed again. mechanic replaced the switch assembly and an inspection of the failed part showed that it had the required nylon tie on the wires, except for one wire which was missing. the wire which broke over time, was the reason for the safety recall. *tt | |||