Peterbilt 367 2009
Model 367 made in 2009 by Peterbilt got 1 investigation there are 7 recalls as well as 2 service bulletins. Technical service bulletines regarding digital instrument panel, electrical system. The car had one investigation (power train). There were some recalls concerningengine and engine cooling, fuel system, gasoline and latches/locks/linkages.
Model 2009
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ENGINE AND ENGINE COOLING - ENGINE - DIESEL | ||||||||||||||||
09V348000 | PACCAR INCORPORATED | from 03/20/2007 to 07/07/2009 | V (Vehicle) | 135 | 10/01/2009 | MFR | PACCAR INCORPORATED | 09/03/2009 | 09/03/2009 | |||||||
Defect Summary | Paccar is recalling model year 2008-2010 kenworth t300, t270, and t370, model year 2009-2010 t800 and peterbilt model year 2008-2010 335, 340, and 367 vehicles built on cummins' diesel engine. the vehicles may be designed with a hard wired, dash-mounted switch that enables the vehicle operator to inhibit aftertreatment diesel particulate filter regeneration in environments where the operator believes it may be unsafe for elevated exhaust temperatures. due to an issue with the logic in the ecm software in these engines, the switch may not function correctly, leading the operator to believe that the switch is in inhibit mode when it is not. | |||||||||||||||
Consequence Summary | This condition will permit hot exhaust gases to exit the vehicle tailpipe, increasing the risk of melting or burning of nearby surfaces, or a fire. | |||||||||||||||
Corrective Summary | Paccar is working with cummins to repair the engines free of charge please see 09e-046. the safety recall began on october 1, 2009. owners may contact cummins at 1-800-diesels (1-800-343-7357). | |||||||||||||||
Notes | Kenworth recall no. 09kw9 & peterbilt recall no. 909-d.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov . | |||||||||||||||
08V487000 | PACCAR INCORPORATED | V (Vehicle) | 4883 | 09/18/2008 | MFR | PACCAR INCORPORATED | 09/23/2008 | 09/25/2008 | ||||||||
Defect Summary | Paccar is recalling 4,883 my 2006-2009 kenworth t600, t660, t800, w900, t2000 and my 2008-2009 peterbilt 365, 367, 379, 384, 386, 387, 388 and 389 trucks. inadequate stiffness of the diesel particulate filter (dpf) bracket could result in separation of the dpf from the chassis. | |||||||||||||||
Consequence Summary | A vehicle crash could occur if another vehicle strikes the dpf on the roadway. | |||||||||||||||
Corrective Summary | Paccar is working with caterpillar to repair these vehicles (please see 08e041). owners may contact caterpillar at 1-800-447-4986 or kenworth at 1-425-828-5440 or peterbilt at 1-940-591-4196. | |||||||||||||||
Notes | Kenworth recall no. 08kwd and peterbilt recall no. 908g.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov. | |||||||||||||||
FUEL SYSTEM, GASOLINE - STORAGE - TANK ASSEMBLY - FILLER PIPE AND CAP | ||||||||||||||||
11V127000 | PACCAR INCORPORATED | from 03/10/2008 to 02/23/2011 | V (Vehicle) | 5045 | MFR | PACCAR INCORPORATED | 02/23/2011 | 02/25/2011 | ||||||||
Defect Summary | Paccar is recalling certain model year 2008-2012 kenworth t2000, t660, t700, t800, and w900, as well as model year 2009-2012 peterbilt 365, 367, 384, 386, 387, 388, 389, and 587 trucks equipped with paccar mx engines. the oil module centrifugal spinner filter cap in the paccar mx engine may become loose, possibly allowing the cap to come off and engine oil to partially discharge from the oil module onto exhaust components. | |||||||||||||||
Consequence Summary | The discharge of engine oil onto exhaust components which are hot, such as when the engine is under significant load, may cause a fire. | |||||||||||||||
Corrective Summary | Dealers will re-torque the oil module filter cap and install a secondary retention device on the secondary centrifugal spinner filter cap. this service will be performed free of charge. the safety recall is expected to begin during march 2011. owners may contact kenworth at 425-828-5440 and peterbilt at 940-591-4196. | |||||||||||||||
Notes | Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov . | |||||||||||||||
LATCHES/LOCKS/LINKAGES - DOORS - LATCH | ||||||||||||||||
08V065000 | PACCAR INCORPORATED | from 10/11/2007 to 01/10/2008 | V (Vehicle) | 6169 | 03/14/2008 | MFR | PACCAR INCORPORATED | 02/07/2008 | 02/07/2008 | 571 | 206 | |||||
Defect Summary | Paccar is recalling 6,169 my 2008 kenworth t300, t660, t800, t2000, w900 and c500 vehicles and my 2008-2009 peterbilt models 365, 367, 384, 387, 388, 389 and 389 kits. certain door latch assemblies on these vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 206, 'door locks and door retention components. the rotor in some of these door latch assemblies did not receive the proper heat treatment and may be soft. | |||||||||||||||
Consequence Summary | In the event of a crash, force could cause the rotor to crack and the door would not have primary or secondary closing security which could possibly lead to injury of the vehicle occupant. | |||||||||||||||
Corrective Summary | Paccar is working with trimark and will inspect and replace the door latch if it is found to be defective. the recall began on march 14, 2008. owners may contact kenworth at 1-425-828-5440 or peterbilt at 1-940-591-4196. | |||||||||||||||
Notes | Kenworth recall no. 08kw1 and peterbilt recall no. 108a.customers may also contact the national highway traffic safety administration | |||||||||||||||
PARKING BRAKE - CONVENTIONAL - AIR | ||||||||||||||||
08V128000 | PACCAR INCORPORATED | from 01/17/2008 to 02/18/2008 | V (Vehicle) | 1043 | 04/14/2008 | MFR | PACCAR INCORPORATED | 03/21/2008 | 03/21/2008 | |||||||
Defect Summary | Paccar is recalling 1,043 my 2008-2009 kenworth c500, t2000,t660, t800 and w900 trucks equipped with bendix mv-3 dash control valves. the molded valve body has an incorrect core pin in the injection mold causing the valve body to be oversized in the double check valve area. this condition can allow the rubber double check valve to become lodged in the body opening under certain circumstances. | |||||||||||||||
Consequence Summary | If the double check valve becomes lodged, in the event of a primary reservoir failure, air pressure can leak past the lodged double check valve thereby depleting the secondary reservoir, causing reduced ability for modulating the service emergency brakes. in such an event, the operator should observe an air leak, indications of low air pressure via the primary and secondary air gauges, and audible and visual low air pressure warning alarms. a vehicle crash is possible if these warnings are not heeded. | |||||||||||||||
Corrective Summary | Dealers will replace the bendix mv-3 dash control valves free of charge. the recall began on april 14, 2008. owners may contact kenworth at 1-425-828-4196. | |||||||||||||||
Notes | Kenworth recall no. 08kw3 and peterbilt recall no. 308e.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov. | |||||||||||||||
STEERING | ||||||||||||||||
09V258000 | PACCAR INCORPORATED | from 04/21/2009 to 06/12/2009 | V (Vehicle) | 2096 | 07/31/2009 | MFR | PACCAR INCORPORATED | 07/08/2009 | 07/08/2009 | |||||||
Defect Summary | Paccar is recalling 2,096 my 2009 kenworth and peterbilt vehicles equipped with trw steering shafts. mislocation of a circumferential weld may allow the splined tube and non-splined tube to rotate relative to one another during a low speed, high torque turn, possibly resulting in a separation of the two tubes. | |||||||||||||||
Consequence Summary | A separation of the splined and non-splined tubes could cause a loss of steering control and increase the risk of a crash. | |||||||||||||||
Corrective Summary | Dealers will inspect the steering shaft using a weld placement gauge and miswelded steering shaft will be replaced free of charge. the recall began july 31, 2009. owners may contact kenworth at 1-425-828-5440 and peterbilt at 1-940-591-4196. | |||||||||||||||
Notes | Kenworth recall no. 09kw8 & peterbilt recall no. 609-c.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov . | |||||||||||||||
TRAILER HITCHES | ||||||||||||||||
08V104000 | PACCAR INCORPORATED | from 06/01/2006 to 01/31/2008 | V (Vehicle) | 318 | 04/18/2008 | MFR | PACCAR INCORPORATED | 03/10/2008 | 03/10/2008 | |||||||
Defect Summary | Paccar is recalling 318 my 2007-2009 kenworth t800, w900, and peterbilt 357, 365, 367, 378, 379, 384, 385, 386,388, and 389 trucks equipped with premier trailer hitch assemblies. the pintle hitch assemblies may have been manufactured in a manner resulting in a reduction of fatigue strength of the pivot pins. | |||||||||||||||
Consequence Summary | This reduction of fatigue strength could cause the pivot pin to crack and eventually break, causing the trailer to detach from the truck while in motion, which could cause a crash that could result in personal injury or death. | |||||||||||||||
Corrective Summary | Dealers will replace the potentially defective pivot pin free of charge. the recall began on april 18, 2008. owners may contact kenworth at 1-425-828-5440 or peterbilt at 1-940-591-4196. | |||||||||||||||
Notes | Kenworth recall no. 08kw4 and peterbilt recall no.208d.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov. |
Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
DIGITAL INSTRUMENT PANEL | |||||
RN-810-1 | 10/22/2010 | 10034709 | Peterbuilt: certain vehicles built between 12/4/09-8/17/10 were manufactured with defective intrumentation software. the software defect may intermittently result in an odometer that does not advance while the vehicle travels. new softwa | 01/05/2011 | |
ELECTRICAL SYSTEM - SOFTWARE | |||||
RN-810-1 | 10/22/2010 | 10034709 | Peterbuilt: certain vehicles built between 12/4/09-8/17/10 were manufactured with defective intrumentation software. the software defect may intermittently result in an odometer that does not advance while the vehicle travels. new softwa | 01/05/2011 |
Investigations
NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
---|---|---|---|---|---|---|
POWER TRAIN - DRIVELINE - DRIVESHAFT | ||||||
PE10029 | PACCAR INCORPORATED | 08/02/2010 | 12/23/2010 | Driveshaft separates from tractor | 10V634000 | |
Summaryon july 13, 2010, the office of defects investigations (odi) opened an investigation on model year (my) 2007-2009 peterbilt tractors equipped with the (spl170xl extended lube inter-axle driveline).odi opened this investigation based on one vehicle owners questionnaire (voq) and certain peterbilt field reports.during the course of the investigation, odi reviewed paccar's ir (october 22, 2010) response with associated data related to warranty and complaint information, mined field data, interviewed customers and visited local dealers within the washington metropolitan area.paccarconducted testing regarding torsional loading and identified various causative factors contributed to this safety defect finding.the defect is a consequence of the bearing surfaces of the spl170xl extended lube universal joint that attaches the inter-axle driveline to the drive axle becoming prematurely worn due to a breakdown of lubrication and/or excessive heat.prematurely worn bearing surfaces may result in the u-joint becoming loose and/or binding.this condition may result in universal joint failure, allowing the inter-axle driveline to detach from the axle, which may cause the drive axle to separate from the vehicle, increasing the risk of personal injury or property damage hazard.odi learned that the affected population of the alleged defect extended to peer models within paccar.in summary, the following vehicles are being recalled: my 2007 and 2008 kenworth trucks, models t600, t660, t2000, t800 and w900 and my 2007/2008 peterbilt trucks, models357, 378, 379, 385, 386, 387, 388, and 389 allequipped with extended lube inter-axle drivelines manufactured by dana corporation.the recall affects vehicles manufactured between february 2, 2006 and april 30, 2007.at this time paccar has not yet identified a fix for the inner-axle safety defect and is currently conducting testing with the intent to provide a solution to the failure.odi will monitor the development of paccars testing and ensure a timely repair for the consumer.this investigation is closed. |