Pierce Enforcer 2002

Model Enforcer made in 2002 by Pierce got 2 investigations as well as 5 recalls. The car had one investigation (vehicle speed control). There were some recalls concerningfuel system, other and seats.

Model 2002

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
FUEL SYSTEM, OTHER
11V384000PIERCE MANUFACTURINGfrom 01/02/1995 to 01/21/2008V (Vehicle)680308/27/2011ODIPIERCE MANUFACTURING07/26/201107/28/2011
Defect SummaryPierce has decided that certain model year 1995-2008 arrow xt, dash, custom contender, lance, enforcer, pierce arrow, quantum, saber and commercial fire trucks manufactured from january 2, 1995, through january 21, 2008, contain a safety defect. these vehicles are equipped with fuel tank straps that may corrode due to winter road salt or liquid de-icing chemicals. if the fuel tank straps corrode sufficiently, the fuel tank supporting straps may fracture and the fuel tank may fall from the vehicle.
Consequence SummaryThe vehicles may lose power and stall. in addition, the fuel tank may rupture and spill diesel fuel on the roadway. either of these outcomes may cause a fire truck or surrounding vehicles to slip or slide on the roadway surface, increasing the risk of a crash.
Corrective SummaryFor fire trucks that are less than 10 years old, dealers will inspect the fuel tank straps and replace them if necessary with stainless steel straps free of charge. for vehicles that are older than 10 years, pierce is not offering a free remedy, but will offer for purchase replacement fuel tanks straps and provide instructions for installation. the safety recall began on august 27, 2011. owners may contact pierce at 1-920-832-3000.
NotesPierce safety recall no. 74b218.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov .
SEATS
05V351000PIERCE MANUFACTURINGfrom 06/01/1999 to 08/27/2004V (Vehicle)9008/19/2005MFRPIERCE MANUFACTURING08/10/200508/04/2005571207
Defect SummaryCertain fire trucks with command cabs fail to comply with the requirements of federal motor vehicle safety standard no. 207,seating systems. the rescue body offerings do not meet the pull test requirements. the pedestal seat was mounted by drilling and tapping the cab or body floor.
Consequence SummaryIn the event of a crash, the pedestal seat fasteners could fail to restrain the seat, increasing the risk of injury to the seat occupant.
Corrective SummaryDealers will inspect the seat pedestals. if the seat was mounted with tapped fasteners, the fasteners will be removed and a hole will be drilled to replace the mounting fasteners with 7/16 bolts and nuts. the recall began on august 19, 2005. owners may contact pierce at 920-832-3249.
NotesCustomers may also contact the national highway traffic safety administration
05V072000PIERCE MANUFACTURINGfrom 02/23/2001 to 02/07/2005V (Vehicle)160004/11/2005MFRPIERCE MANUFACTURING03/04/200503/03/2005571207
Defect SummaryCertain fire trucks fail to comply with the requirements of federal motor vehicle safety standard no. 207, 'seating systems.' the seat tether restrains the seat during pull testing as the suspension components are not designed to restrain the seat on their own. the suspension seat tethers are too long.
Consequence SummaryThe occupant will experience insufficient suspension seat restraint which could lead to personal injury or death in the event of a crash.
Corrective SummaryDealers will replace suspension seat tethers with shorter tethers. the recall began on april 11, 2005. owners may contact pierce at 1-888-974-3723.
NotesCustomers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.
STEERING
10V423000PIERCE MANUFACTURINGfrom 05/30/1998 to 11/25/2008V (Vehicle)265210/12/2010MFRPIERCE MANUFACTURING09/21/201009/22/2010
Defect SummaryPierce is recalling certain model year 1998 through 2008 arrow xt, lance, velocity, enforcer, impel, and dash custom fire apparatus vehicles manufactured from may 30, 1998 through november 25, 2008. the steering gear bracket may fracture and break. if this occurs the steering gear may detach from the vehicle.
Consequence SummaryDetachment of the steering gear will result in a loss of steering control that could cause a crash.
Corrective SummaryPierce will notify owners and dealers will install a new steering gear mounting bracket free of charge. the safety recall began on october 12, 2010. owners are being instructed to inspect the steering gear bracket prior to each trip. the remedy to repair this defect is expected to begin no earlier the january 31, 2011. owners may contact pierce at 1-888-974-3723.
NotesPierce safety recall no. 74b207.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov .
VEHICLE SPEED CONTROL - ACCELERATOR PEDAL
11V255000PIERCE MANUFACTURINGfrom 06/22/1999 to 05/12/2008V (Vehicle)4409MFRPIERCE MANUFACTURING04/26/201104/28/2011
Defect SummaryPierce is recalling certain model year 1999-2008 arrow xt, dash, lance, and enforcer fire apparatus manufactured from june 22, 1999, through may 12, 2008, and equipped with an electronic accelerator pedal. after repeated use with excessive force, the accelerator pedal arm may bend and cause the pedal to move closer to the floor. if the pedal arm bends far enough, the pedal may contact the cab floor without warning and stick in the full throttle position.
Consequence SummaryIf the accelerator pedal becomes stuck, the operator may lose control of the vehicle increasing the risk of a crash.
Corrective SummaryDealers will remove the existing accelerator arm and install a redesigned pedal arm free of charge. the safety recall is expected to begin on or about may 9, 2011. owners may contact pierce at 1-920-832-3000.
NotesPierce safety recall no. 74b215.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov .

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
VEHICLE SPEED CONTROL - ACCELERATOR PEDAL
EQ11003PIERCE MANUFACTURING05/12/201107/19/2011Williams Controls Accelerator Pedals
 On april 26, 2011, pierce manufacturing, inc. (pierce) notified the nhtsa that it had decided certain pierce fire trucks, manufactured between june 22, 1999, and may 12, 2008, contain a safety related defect. pierce stated that certain model year 1999 through 2008 arrow xt, dash, lance, and enforcer vehicles contain a williams controls, inc. (williams controls) suspended electronic accelerator pedal that may become bent after repeated use with excessive force. if the pedal arm bends far enough, the pedal may contact the cab floor without warning and stick in the full throttle position. if the accelerator pedal becomes stuck, the operator may lose control of the vehicle increasing the risk of a crash. this issue was assigned recall number 11v-255.on may 12, 2011, rmd mailed an information request (ir) letter to williams controls requesting a list of customers who purchased the same or similar defective accelerator pedals.williams controls responded to rmd's ir letter on june 9, 2011 with a list those companies who purchased the same accelerator pedal.the list was submitted to nhtsa's office of the chief counsel under a request for confidentiality.williams controls' response letter outlined several key points.first, it was noted that these pedals, item number 131507, are generic parts that are purchased by engineering staffs in accordance with their own specifications.according to williams controls, pierce modified their purchased pedals post-purchase and this modification reduced the strength of the accelerator pedal assembly.also, williams controls stated that it has, never had a warranty claim or other notice, other than by pierce on their modified pedal, due to lever arm permanent deformation for item number 131507.while williams controls submitted a list of companies that purchased item number 131507, it noted that it did not sell the same or similar defective pedal assemblies to any company as the subject pedals were modified by pierce.this equipment query is satisfied as, because of modifications not conducted by the pedal manufacturer, the same or similar pedals were not sold to other vehicle manufacturers and no other vehicles should be affected.however, rmd will continue to monitor recall activity to see if any similar issues are found in other manufacturers' vehicles.this eq is closed.
EQ11003PIERCE MANUFACTURING05/12/2011Williams Controls Accelerator Pedals
 On april 26, 2011, pierce manufacturing, inc. (pierce) notified the nhtsa that it had decided certain pierce fire trucks, manufactured between june 22, 1999, and may 12, 2008, contain a safety related defect. pierce stated that certain model year 1999 through 2008 arrow xt, dash, lance, and enforcer vehicles contain a williams controls, inc. (williams controls) suspended electronic accelerator pedal that may become bent after repeated use with excessive force.if the pedal arm bends far enough, the pedal may contact the cab floor without warning and stick in the full throttle position. if the accelerator pedal becomes stuck, the operator may lose control of the vehicle increasing the risk of a crash.this issue was assigned recall number 11v-255.the purpose of this eq is to write to any other companies that might have purchased this equipment, notify them of this defect in any vehicles they manufactured, and to ensure thorough safety realls are conducted where appropriate.