Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
SUSPENSION - FRONT - CONTROL ARM - LOWER BALL JOINT | ||||||||||||||||
97V201000 | CHRYSLER CORPORATION | from 07/31/1994 to 07/10/1997 | V (Vehicle) | 599000 | 12/15/1997 | ODI | CHRYSLER GROUP LLC | 11/13/1997 | 11/20/1997 | |||||||
Defect Summary | Vehicle description: passenger vehicles. the lower control arm ball joint can separate due to loss of lubrication. | |||||||||||||||
Consequence Summary | Separation of the ball joint could cause a loss of steering control increasing the risk of a vehicle crash. | |||||||||||||||
Corrective Summary | Dealers will inspect the ball joint end housing cover seal for leakage with a high pressure air tester and the rubber boot will be visually inspected for damage. if the cover seal leaks or the boot is damaged, the lower control arm will be replaced. | |||||||||||||||
Notes | Owner notification began december 15, 1997.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chrysler at 1-800-992-1997.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393. | |||||||||||||||
09E056000 | QUALIS AUTOMOTIVE LLC | E (Equipment) | 5787 | 11/09/2009 | MFR | CHRYSLER GROUP LLC | 10/09/2009 | 10/13/2009 | ||||||||
Defect Summary | Qualis automotive is recalling certain aftermarket ball joints sold for use on certain passenger vehicles. the socket may have been excessively hardened which could cause it to crack near the retaining ring groove allowing the ball stud to separate under impact load. the subject ball joints were sold as four part numbers, d10945, d10946, g10945, and g10946. the affected control arms, d10945 and d10946, are stamped with the following dates on the ball joints: 134308, 135708, 100109, 102709, 104109, 105509, 107609, 108909, 110309, 113209, and 116609. the g10945 and g10946 are the same part as the d10945 and d10946 respectively. they are labeled differently depending on the aftermarket customer. | |||||||||||||||
Consequence Summary | Separation of the ball stud from the socket of the ball joint housing would allow the control arm to collapse and the wheel to fold in causing loss of steering control, possibly resulting in a crash. | |||||||||||||||
Corrective Summary | Qualis automotive will replace the ball joints free of charge. the safety recall began on november 9, 2009. | |||||||||||||||
Notes | This recall only pertains to aftermarket ball joints and has no relation to any original equipment installed on vehicles produced by chrysler.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov . |
Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
SUSPENSION | |||||
020598 | 05/29/1998 | 601679 | Intermittent popping sound coming from the front of the vehicle may be heard from either side. *yc | 11/09/1999 |