Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS
99V244000DAIMLERCHRYSLER CORPORATIONfrom 06/01/1997 to 05/15/1999V (Vehicle)36650811/22/1999MFRCHRYSLER GROUP LLC09/15/199909/23/1999
Defect SummaryVehicle description: passenger vehicles. the right rear brake tube can contact the exhaust system clamp and wear a hole in it.
Consequence SummaryDaimlerchrysler recall no. 843. if this happens, the tube could leak, reducing the effectiveness of one-half of the diagonally split braking system, and resulting in longer stopping distances.
Corrective SummaryDealers will inspect the brake tubes for visible evidence of contact with the exhaust system clamp. if the tube shows evidence of contact, it will be replaced. if no evidence of contact exists, the tube will be fastened with a clip.
NotesOwner notification began november 22, 1999.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact daimlerchrysler at 1-800-992-1997. also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC
06/14/20061
 I have tried to resolve the numbers of recalls that are still pending on my car. the three pending recalls are 843, c45, and e23. i have been to the dealer and i was served and told that they were going to order the parts. the dealer never call to tell me about the status of the parts. i called to check and the parts never arrived. the dealer have not take any action to repair my car. *nm
01/01/19011
 The brake made a loud noise when wet or when air hit them. there was also a rattling noise under the steering wheel. *bf the vehicle was taken to the dealer twice and explained tha teh noise was normal. *nm
09/01/20041
 Vehicle involved in several accidents resulting from loss of control when brakes are applied.*mr the consumer received a recall notice (#04v021000) for power train: automatic transmission: lever and linkage:floor shift . the consumer was informed that the recall notice did not apply to the problem she was having. *tc
08/01/2004710001
 Problems with brake equipment on 1999 plymouth breeze. *mr rapid excessive wear had lowered the brake assembly which placed the upper brake pad close of slipping underneath it's upper locating point with a possible loss of control of total brake failure. the consumer also had questions about recall#04v021000. *sc *jb
SERVICE BRAKES, HYDRAULIC - ANTILOCK
06/26/2000812/01/1998
 I have had my front brakes, right or left rotor either resurfaced or replaced, every 2-3 months. i have 3 incidents of smelling something burning and nothing found. my alternator had to be replaced 2 months ago, the bolt to my alternator broke in two on 7/10/00.
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
06/26/2000812/01/1998
 I have had my front brakes, right or left rotor either resurfaced or replaced, every 2-3 months. i have 3 incidents of smelling something burning and nothing found. my alternator had to be replaced 2 months ago, the bolt to my alternator broke in two on 7/10/00.
03/15/2000312/01/1999
 We have had the car for 4 months & had the front brakes replaced 4 times now, an still sqeauling. the key falls out of the ignition while car is running. *ak
 When consumer first acquired vehicle he had to replace the front brakes. then two week later, he had to replace the rear brakes. also brakes made a grinding noise, like metal to metal rubbing noise. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
07/31/200690098101/05/1999
 Dt*: the contact stated while driving various speeds, the rear brake caliper failed without warning resulting in the loss of the rear brakes. an independent repair shop replaced the entire rear braking system. afterwards, the problem continued to persist. the manufacturer was not alerted.
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
 Noise occurs in the front end of vehicle when brake pads knock against brake calipers. there is no solution for this problem. please give any further details. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
04/17/19991
 I supposedly had a gasket put on my vehicle but i still have a water leak. i see there were recalls on heads or gaskets. i also had brakes and rotors put on my car which i still have problem with . i have paid over$400 to get that gasket put on. when i use my air conditioner the power of my engine weakens and i hear valves rattling. i do not know the owner of the vehicle every get these things fix when there were a recall for them or not. i also had to put a transmission sensor on the vehicle. it is one thing after another for this vehicle. i thought maybe because of the age of the car. but after looking at the recall of the vehicle. i basically have to restore the vehicle. the dealer where i took my car told me that i had a recall on my brakes but i do not think they did anything about. then i was also told that i needed work for the startling and power of my vehicle. when i purchased this vehicle after one week it was in the shop for the gasket. about a month later then i needed that transmission sensor. i do not believe my car never stopped dripping water. i do not know exact date. i still hear the roaring sound when i hit my brakes. *jb
01/08/200276000102/12/2000
 Radio expired before warranty july 2000--no replacement by chrysler transmission sensors at 52,000 april 2001-- no replacement or help of any kind from chrysler, head gasket now at 76,000, january 2003 no help or replacement from chrysler, was told not their problem since warranty expired. *jb
05/22/2000312/21/1998
 On several occaisons consumer has been experiencing problems with the front brake system in which the brake pedal would become very soft and the front end of the vehicle experienced pulsation when coming to a stop, the rotors were turned on the first occasion and the second time they were replaced due to them being out of round.*jb
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM
 When consumer first acquired vehicle he had to replace the front brakes. then two week later, he had to replace the rear brakes. also brakes made a grinding noise, like metal to metal rubbing noise. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
02/01/1999
 Master cylinder was leaking fluid. had to add fluid every month. while applying brakes pedal will go all the way down to the floor. dealership is aware of problem.*ak