Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
SERVICE BRAKES, AIR - ANTILOCK - ABS WARNING LIGHT | |||||
3405 | 10017233 | Intermittent abs indicator light illuminating. *tt | 10/28/2005 | ||
SERVICE BRAKES, AIR - ANTILOCK - WHEEL SPEED SENSOR | |||||
3477 | 10014875 | Tech 2 displays asterisk for the left front wheel speed sensor. *tt | 05/11/2005 | ||
SERVICE BRAKES, HYDRAULIC | |||||
040523002 | 08/01/2005 | 040523002A | 10012633 | Brake rotor minimum allowable thickness after refinish specification correction. *tt | 03/09/2005 |
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC | |||||
010523011A | 02/01/2002 | 010523011 | 629418 | Concerns with rattle type noise coming from the front of the vehicle. *tt | 04/02/2002 |
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER | |||||
010523011 | 12/01/2001 | 628930 | Some customers may comment about a rattle type noise coming from the front of the vehicle under 30 mph and while driving over bumps. *tt | 03/25/2002 | |
010523006A | 06/01/2001 | 010523006 | 623403 | This bulletin is being issued to revise the fastener requirements for the front and rear brake caliper bracket replacement procedures in the disc-brake sub-section of brakes in the appropriate service manual. *tt | 10/29/2001 |
010523006 | 04/01/2001 | 619792 | Subject regarding revised fastener requirements for front and rear brake caliper bracket. *tt | 06/29/2001 | |
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR | |||||
04082004 | 04/08/2004 | 10009210 | The current brake rotor minimum allowable thickness after refinish, or minimum thickness specification, found in the past service manual applications are incorrect. please use correct information as follows. *tt | 09/17/2004 | |
SERVICE BRAKES, HYDRAULIC - POWER ASSIST - VACUUM | |||||
020522002 | 06/01/2002 | 634837 | This bulletin is being issued to revise the vacuum brake booster replacement procedure. *tt | 10/09/2002 |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
SERVICE BRAKES, AIR - ANTILOCK | |||
03/05/2004 | 0 | 07/14/2002 | |
Electrical system is malfunctioning. rear windows half open and will not close. front windows will open, but will not close. lights (internal and external) will flicker if i turn on the radio, windshield wipers, raise or lower windows. locks will engage and disengage on their own over and over again, even if the vehicle is at rest. brakes are constantly going bad. i have had to get the brakes fixed 4 times in the past 18 months. a/c is not working. no cold air comes out, only heat.*ak | |||
SERVICE BRAKES, HYDRAULIC | |||
06/30/2005 | 65163 | 2 | 08/17/2001 |
My original set of inner brake pads were 75% worn per dealer repair shop at 29,672 miles. the outer pads were fine. the rotors were approaching end of life. i had them replace the pads at this time. the dealer did not offer to cover them under warranty. at 30,945, 1273 miles later, i took the car back for another brake inspection. at this time they found that the rotors were rusted and pitted, not normal wear. they replaced the pads and the rotors under warranty (seems strange it wasn't warranty before?!?!?). now at 65k miles i took the car in for a brake inspection at a repair shop. they said the front pads and rotors were shot and they had about two weeks left of city driving left. my husband replaced both the pads and the rotors this weekend. the inner pads were worn down to the rivets that hold the pad to the mounting surface. the outer pads were hardly thinner than the brand new pads out of the box. so this leads me to believe that gm has an issue with the brake calipers not applying pressure evenly. i have seen complaints like this on this website referring to the same problem. *nm | |||
3060 | 1 | 03/01/2002 | |
Gas leaking under the driver seat and under the hood. also, gas was pouring out from the motor. *la the window failed to open, the consumer is currently waiting on a new motor. the rear brakes were leaking, the tie rods had to be replaced because they were loose, the left rear stuck became stuck, when the gear was taken out of park and placed into drive and the consumer proceeded to accelerate the vehicle jerked, the engine light illuminated, the dealer determined the emission system was dragging, the driver side mirror vibrated, the bumper cover was loose. when the consumer attempted to turn the key in the ignition, the vehicle did not start, the dealer was unable to duplicate the consumer's concern. the fuel pressure regulator was leaking and the fuel filter was replaced. the vehicle would not go over 10 mph, the vehicle shifted and then returned to normal speed. the plastic on the drivers seat was loose. *jb | |||
10/09/2003 | 45000 | 1 | 07/13/2001 |
While driving at 35 mph the consumer attempted to turn, but the vehicle went straight. the vehicle would not steer, the consumer lost control and went straight. the vehicle struck several trees, and sheared one off that landed on top of the vehicle. the consumer was wearing a seat belt and suffered a concussion. the vehicle was totaled in the accident. *ak *scc *jb | |||
01/28/2003 | |||
Consumer states the vehicle was parked in the driveway when the vehicle started to roll into the street. | |||
SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||
05/18/2009 | 101756 | ||
Tl*the contact owns a 2001 pontiac montana. the contact stated that the abs, or ecu, constantly failed. the brake light remains illuminated and does not dim. the contact stated that the brake pads were changed last year, but the failure has recently recurred. the vin was unknown. the failure mileage was 101,756. | |||
09/24/2007 | 114701 | 3 | 04/08/2006 |
Tl*the contact owns a 2001 pontiac montana. when the brake pedal was depressed, the contact heard the abs lock up and the vehicle continued to roll forward. she stated that the vehicle would stop regularly, but would continue to roll forward when driving between 5 and 10 mph. on september 24, 2007, the failure resulted in the contact rear ending another vehicle. the other vehicle was not damaged. the contact's vehicle sustained damages to the driver and passenger side headlights and the hood. the vehicle was taken to the dealer in april and june of 2007 regarding this failure. on both occasions, she was informed that nothing was wrong with the vehicle, however, she and her husband believed that there was brake failure. the powertrain was unknown. the current and failure mileages were 114,701. | |||
09/05/2005 | 87800 | 1 | 12/05/2001 |
Dt: the consumer stated that 2001 pontiac montana was having the abs brakes engage at low speeds of 10-15 mph. the instrument panel was showing the abs and service traction needed lights on the dashboard. the consumer will take the vehicle to dealer for service. the consumer specifically stated that this just started happening last week. the dealer has not been contacted, but the consumer contacted pontiac and filed a complaint with them. *ak | |||
40000 | 1 | 03/01/2001 | |
While braking the abs failed. as a result the driver rear ended another vehicle. the driver stated that the manufacturer refused to accept responsibility for the failure. a police report was taken and there were no injuries. *nm *mr | |||
04/10/2001 | 1 | 02/01/2001 | |
Abs system failed when applied on wet pavement.*ak | |||
SERVICE BRAKES, HYDRAULIC - ANTILOCK - CONTROL UNIT/MODULE | |||
11/01/2004 | 28000 | 2 | 01/01/2001 |
Tl*the contact owns a 2001 pontiac montana. the vehicle was purchased brand new. in november of 2004, the abs light illuminated and displayed track off in the message center of the service tracker control system. the contact attempted to take the vehicle to the dealer, but it would not start. the vehicle was towed to the dealer and they stated that the abs shorted out. the contact had to replace a brake module and a valve kit. the shortage fried the battery and it had to be replaced. after the replacement, the vehicle operated normally until february of 2008 when the failure recurred. he took the vehicle to the dealer and was informed that the brake module and valve kit failed again. the vehicle is currently at the dealer. the failure mileage was 28,000 and current mileage was 56,500. updated 03-18-08 *bf | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER | |||
10/21/2003 | 3 | 11/10/2001 | |
Front tie rods, brakes and rotors completely worn out and require all new replacement as well as new tires. think originally that tie rod and calipers were defective. bought vehicle brand new. have 28,800 miles on it. gm refused to look at calipers saying it was my fault because tires weren't rotated. doesn't explain how outside brake linings and tie rods wore out.*ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS | |||
04/05/2003 | 58000 | 3 | 10/20/2000 |
The brakes on my 2001 pontiac montana wear out prematurely. i had to replace the front pads 3 times in 2 years. in each case the inboard pad had excessive wear and the outboard pad did not. i have been informed the wear indicators are on the outboard pads, this presents a lack of warning to the driver that the brakes are in need of service. the calipers have been replaced once and this did not solve the problem.*jb | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR | |||
10/21/2003 | 3 | 11/10/2001 | |
Front tie rods, brakes and rotors completely worn out and require all new replacement as well as new tires. think originally that tie rod and calipers were defective. bought vehicle brand new. have 28,800 miles on it. gm refused to look at calipers saying it was my fault because tires weren't rotated. doesn't explain how outside brake linings and tie rods wore out.*ak | |||
06/19/2003 | 27000 | 2 | 08/17/2001 |
Premature wear of front brake rotors. only 30k miles on car. *nlm | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS | |||
08/09/2007 | 100322 | 1 | 09/11/2001 |
2001 pontiac montana brake system failure. customer states that her brake system failed unexpectedly. she wants general motors to reimburse her for fixing the vehicle. *kb the consumer stated the brake line leaked onto the electronic brake control module which caused an electrical short. the intake manifold gasket had to be replaced previously on the vehicle. *jb updated 12/12/2007 *bf updated 12/12/07 *tr |