Spartan K2 2012

Model K2 made in 2012 by Spartan got 2 investigations as well as 3 recalls. The car had one investigation (service brakes, air). There were some recalls concerningengine and engine cooling and service brakes, air.

Model 2012

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
ENGINE AND ENGINE COOLING
11V425000SPARTAN CHASSIS, INC.from 09/29/2010 to 06/20/2011V (Vehicle)21210/10/2011MFRSPARTAN CHASSIS, INC.08/17/201108/18/2011
Defect SummarySpartan is recalling certain model year 2010, 2011, and 2012 recreational vehicles, models mm, k2, k3, bus, furion, gladiator, and metro star, manufactured from september 29, 2010, through june 20, 2011, equipped with a cummins isb, isc, isl, or isx diesel engine. the v-band clamp assembly, part numbers q187684, q187685, and q187686, used to connect the inlet and outlet cone sections to the diesel oxidation catalyst (doc)/diesel particulate filter (dpf) include a t-bolt which can fracture and fail when subjected to stress or load. a fracture or failure of the t-bolt may cause the clamp to loosen and the inlet or outlet sections attached to the doc/dpf housing to disconnect.
Consequence SummaryIf the inlet or outlet sections disconnect, hot exhaust gases can vent prior to exiting the tailpipe, creating the risk of combustion and a fire. if both clamps fail, there is a risk in some applications that the doc/dpf housing may detach completely, creating a road hazard.
Corrective SummarySpartan is working with cummins to identify and notify owners of the recall campaign. repairs will be performed by authorized cummins dealers free of charge. the safety recall began on october 10, 2011. owners may contact cummins at 1-812-377-5000 or spartan at 1-800-543-5008 - option 5.
NotesCummins recall campaign number is c1154.spartan's recall campaign number is 11022.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov .
SERVICE BRAKES, AIR
12V125000SPARTAN CHASSIS, INC.from 12/15/2011 to 01/31/2012V (Vehicle)13MFRSPARTAN CHASSIS, INC.03/23/201203/23/2012571121
Defect SummarySpartan is recalling certain model year 2012 k2 and mg chassis manufactured from december 15, 2011, through january 31, 2012, and equipped with 3030 brake chambers. these vehicles fail to comply with the requirements of federal motor vehicle safety standard number 121,
Consequence SummaryThe park brake may not hold the vehicle in place and if the vehicle moves, injury or property damage could occur without warning.
Corrective SummarySpartan will notify owners and install improved brake chambers, free of charge. the manufacturer has not yet provided a notification schedule for this campaign. owners may contact spartan at 1-517-543-6400.
NotesSpartan
11V587000SPARTAN CHASSIS, INC.from 09/30/2010 to 11/22/2011V (Vehicle)3503/12/2012MFRSPARTAN CHASSIS, INC.12/06/201112/15/2011571121
Defect SummarySpartan is recalling certain model year 2011-2012 k2 recreational vehicles manufactured from september 30, 2010, through november 22, 2011, rated at 52,000 lbs and equipped with 3030 brake chambers. these vehicles fail to comply with the requirements of federal motor vehicle safety standard number 121,
Consequence SummaryThe park brake may not hold the vehicle in place and if the vehicle moves, injury or property damage could occur without warning.
Corrective SummarySpartan will notify owners and install improved brake chambers, free of charge. the safety recall began on march 12, 2012. owners may contact spartan at 1-517-543-6400.
NotesSpartan

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SERVICE BRAKES, AIR
EQ12004SPARTAN CHASSIS, INC.04/02/201205/25/2012TSE Brakes, Inc. Hill Hold Requirements
 On march 22, 2012, spartan motors chassis, inc. (spartan) notified the nhtsa that it had decided a defect exists in certain model year 2012 k2 and mg chassis manufactured from december 15, 2011, through january 31, 2012, and equipped with 3030 brake chambers.these vehicles fail to comply with the requirements of federal motor vehicle safety standard (fmvss) number 121, air brake systems because they do not meet the park brake and draw bar requirements.the park brake may not hold the vehicle in place and if the vehicle moves, injury or property damage could occur without warning.nhtsa assigned recall number 12v-125 to this matter.spartan reported that the manufacturer of the noncompliant brake chambers was tse brakes, inc. (tse).on april 9, 2012, the recall management division (rmd) mailed an information request (ir) letter to tse requesting a list of purchasers who received the noncompliant brake chambers, and also inquiring if tse sold any affected brake chambers in the replacement market.in a letter dated april 20, 2012, tse responded to rmd
EQ12004SPARTAN CHASSIS, INC.04/02/2012TSE Brakes, Inc. Hill Hold Requirements
 On march 22, 2012, spartan motors chassis, inc. (spartan) notified the nhtsa that it had decided a defect exists in certain model year 2012 k2 and mg chassis manufactured from december 15, 2011, through january 31, 2012, and equipped with 3030 brake chambers.these vehicles fail to comply with the requirements of federal motor vehicle safety standard number 121, air brake systems because they do not meet the park brake and draw bar requirements.the park brake may not hold the vehicle in place and if the vehicle moves, injury or property damage could occur without warning.nhtsa assigned recall number 12v-125 to this matter.spartan reported that the manufacturer of the defective brake chambers was tse brakes, inc. (tse).rmd understands that other manufacturers might have used the same or similar product in their vehicles.rmd intends to write to tse to learn if this product was sold to any other vehicle manufacturer.the purpose of this eq is to write to any other companies that might have purchased this equipment, notify them of this defect in any vehicles they manufactured, and to ensure thorough safety recalls are conducted where appropriate.