Strick 0400cd 2002

Model 0400cd made in 2002 by Strick got 6 investigations as well as 1 recall. The car had some investigations: suspension and wheels. There was one recall concerning trailer hitches .

Model 2002

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
TRAILER HITCHES - FIFTH WHEEL ASSEMBLY
03V188000STRICK CORPORATIONfrom 09/03/1999 to 04/14/2003V (Vehicle)83904/15/2003MFRSTRICK CORPORATION05/15/200306/03/2003
Defect SummaryOn certain converter dollies equipped with jost international jsk 37u series fifth wheels, a fatigue crack can develop in the bracket pin weld under certain loading conditions.
Consequence SummaryIf left undetected or corrected it could lead to the separation of the fifth wheel top plate from its mounting structure, possibly resulting in a crash.
Corrective SummaryDealers will replace the bracket pins and repair instructions free of charge. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact jost international at 616-846-7700 or by email to recall@jostinternational.com or strick at 215-949-3600.
NotesAlso, customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SUSPENSION - MULTIPLE AXLE
EA03022STRICK CORPORATION11/12/200301/25/2005STRICK WHEEL-END FAILURES
 The closing of this investigation does not constitute a finding by nhtsa that no safety-related defect existed or continues to exist.further use of agency resources does not appear to be warranted.the agency will continue to monitor this problem closely and reserves the right to take further action if warranted by the circumstances.see attached technical report for full details.
PE03027STRICK CORPORATION06/30/200311/12/2003STRICK SEMI TRAILER HUB FAILURES
 Odi opened this investigation based on a fleet complaint where information was furnished indicating that wheel bearings were failing at an unusually high rate.in 29 cases these failures allegedly resulted in a wheel end fire or a wheel separation.during the investigation it was determined that the subject vehicles were built with low maintenance wheel ends.documents obtained by odi indicate that widespread confusion existed in this industry concerning maintenance requirements.the issues were:frequency of maintenance, amount of grease to be used, and proper method of inspection.several meetings were held involving the axle manufacturer, (arvinmeritor), lubrication manufacturer (mobil), several trailer manufacturers and fleets.currently odi has data which indicates that 255 trailers from a certain build period have wheel ends failing at a higher rate than peer trailers with the same wheel ends.odi is upgrading this investigation to determine why the one group is failing at a higher rate than others with the same wheel ends.in order to resolve this matter, odi will be contacting the axle manufacturer, the bearing and grease manufacturers, fleets and will further investigate the issue with strick directly.
SUSPENSION - REAR - AXLE - NON-POWERED AXLE ASSEMBLY
PE03027STRICK CORPORATION06/30/200311/12/2003STRICK SEMI TRAILER HUB FAILURES
 Odi opened this investigation based on a fleet complaint where information was furnished indicating that wheel bearings were failing at an unusually high rate.in 29 cases these failures allegedly resulted in a wheel end fire or a wheel separation.during the investigation it was determined that the subject vehicles were built with low maintenance wheel ends.documents obtained by odi indicate that widespread confusion existed in this industry concerning maintenance requirements.the issues were:frequency of maintenance, amount of grease to be used, and proper method of inspection.several meetings were held involving the axle manufacturer, (arvinmeritor), lubrication manufacturer (mobil), several trailer manufacturers and fleets.currently odi has data which indicates that 255 trailers from a certain build period have wheel ends failing at a higher rate than peer trailers with the same wheel ends.odi is upgrading this investigation to determine why the one group is failing at a higher rate than others with the same wheel ends.in order to resolve this matter, odi will be contacting the axle manufacturer, the bearing and grease manufacturers, fleets and will further investigate the issue with strick directly.
EA03022STRICK CORPORATION11/12/200301/25/2005STRICK WHEEL-END FAILURES
 The closing of this investigation does not constitute a finding by nhtsa that no safety-related defect existed or continues to exist.further use of agency resources does not appear to be warranted.the agency will continue to monitor this problem closely and reserves the right to take further action if warranted by the circumstances.see attached technical report for full details.
WHEELS - CAP/COVER/HUB
PE03027STRICK CORPORATION06/30/200311/12/2003STRICK SEMI TRAILER HUB FAILURES
 Odi opened this investigation based on a fleet complaint where information was furnished indicating that wheel bearings were failing at an unusually high rate.in 29 cases these failures allegedly resulted in a wheel end fire or a wheel separation.during the investigation it was determined that the subject vehicles were built with low maintenance wheel ends.documents obtained by odi indicate that widespread confusion existed in this industry concerning maintenance requirements.the issues were:frequency of maintenance, amount of grease to be used, and proper method of inspection.several meetings were held involving the axle manufacturer, (arvinmeritor), lubrication manufacturer (mobil), several trailer manufacturers and fleets.currently odi has data which indicates that 255 trailers from a certain build period have wheel ends failing at a higher rate than peer trailers with the same wheel ends.odi is upgrading this investigation to determine why the one group is failing at a higher rate than others with the same wheel ends.in order to resolve this matter, odi will be contacting the axle manufacturer, the bearing and grease manufacturers, fleets and will further investigate the issue with strick directly.
EA03022STRICK CORPORATION11/12/200301/25/2005STRICK WHEEL-END FAILURES
 The closing of this investigation does not constitute a finding by nhtsa that no safety-related defect existed or continues to exist.further use of agency resources does not appear to be warranted.the agency will continue to monitor this problem closely and reserves the right to take further action if warranted by the circumstances.see attached technical report for full details.