Strick Van 2002
Model Van made in 2002 by Strick got 6 investigations as well as 1 recall. The car had some investigations: suspension and wheels. There was one recall concerning wheels .
Model 2002
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
WHEELS - LUGS/NUTS/BOLTS | ||||||||||||||||
02V212000 | STRICK CORPORATION | from 04/01/1999 to 06/15/2002 | V (Vehicle) | 1970 | 06/18/2002 | MFR | STRICK CORPORATION | 08/12/2002 | 08/14/2002 | |||||||
Defect Summary | On certain dry freight vans equipped with stemco pro-torq axle nut system, it is possible that wheels can separate due to improper installation or failure of the lock ring provided with the pro-torq axle nut system. | |||||||||||||||
Consequence Summary | Wheels separating from the vehicle increases the risk of a crash. | |||||||||||||||
Corrective Summary | Owners/dealers will inspect the wheels. if snap lock ring is installed wrong, it will be removed and re-installed correctly. owner notification began june 18, 2002. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact strick at 1-260-692-6121. | |||||||||||||||
Notes | Also, customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236). |
Investigations
NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
---|---|---|---|---|---|---|
SUSPENSION - MULTIPLE AXLE | ||||||
PE03027 | STRICK CORPORATION | 06/30/2003 | 11/12/2003 | STRICK SEMI TRAILER HUB FAILURES | ||
Odi opened this investigation based on a fleet complaint where information was furnished indicating that wheel bearings were failing at an unusually high rate.in 29 cases these failures allegedly resulted in a wheel end fire or a wheel separation.during the investigation it was determined that the subject vehicles were built with low maintenance wheel ends.documents obtained by odi indicate that widespread confusion existed in this industry concerning maintenance requirements.the issues were:frequency of maintenance, amount of grease to be used, and proper method of inspection.several meetings were held involving the axle manufacturer, (arvinmeritor), lubrication manufacturer (mobil), several trailer manufacturers and fleets.currently odi has data which indicates that 255 trailers from a certain build period have wheel ends failing at a higher rate than peer trailers with the same wheel ends.odi is upgrading this investigation to determine why the one group is failing at a higher rate than others with the same wheel ends.in order to resolve this matter, odi will be contacting the axle manufacturer, the bearing and grease manufacturers, fleets and will further investigate the issue with strick directly. | ||||||
EA03022 | STRICK CORPORATION | 11/12/2003 | 01/25/2005 | STRICK WHEEL-END FAILURES | ||
The closing of this investigation does not constitute a finding by nhtsa that no safety-related defect existed or continues to exist.further use of agency resources does not appear to be warranted.the agency will continue to monitor this problem closely and reserves the right to take further action if warranted by the circumstances.see attached technical report for full details. | ||||||
SUSPENSION - REAR - AXLE - NON-POWERED AXLE ASSEMBLY | ||||||
EA03022 | STRICK CORPORATION | 11/12/2003 | 01/25/2005 | STRICK WHEEL-END FAILURES | ||
The closing of this investigation does not constitute a finding by nhtsa that no safety-related defect existed or continues to exist.further use of agency resources does not appear to be warranted.the agency will continue to monitor this problem closely and reserves the right to take further action if warranted by the circumstances.see attached technical report for full details. | ||||||
PE03027 | STRICK CORPORATION | 06/30/2003 | 11/12/2003 | STRICK SEMI TRAILER HUB FAILURES | ||
Odi opened this investigation based on a fleet complaint where information was furnished indicating that wheel bearings were failing at an unusually high rate.in 29 cases these failures allegedly resulted in a wheel end fire or a wheel separation.during the investigation it was determined that the subject vehicles were built with low maintenance wheel ends.documents obtained by odi indicate that widespread confusion existed in this industry concerning maintenance requirements.the issues were:frequency of maintenance, amount of grease to be used, and proper method of inspection.several meetings were held involving the axle manufacturer, (arvinmeritor), lubrication manufacturer (mobil), several trailer manufacturers and fleets.currently odi has data which indicates that 255 trailers from a certain build period have wheel ends failing at a higher rate than peer trailers with the same wheel ends.odi is upgrading this investigation to determine why the one group is failing at a higher rate than others with the same wheel ends.in order to resolve this matter, odi will be contacting the axle manufacturer, the bearing and grease manufacturers, fleets and will further investigate the issue with strick directly. | ||||||
WHEELS - CAP/COVER/HUB | ||||||
PE03027 | STRICK CORPORATION | 06/30/2003 | 11/12/2003 | STRICK SEMI TRAILER HUB FAILURES | ||
Odi opened this investigation based on a fleet complaint where information was furnished indicating that wheel bearings were failing at an unusually high rate.in 29 cases these failures allegedly resulted in a wheel end fire or a wheel separation.during the investigation it was determined that the subject vehicles were built with low maintenance wheel ends.documents obtained by odi indicate that widespread confusion existed in this industry concerning maintenance requirements.the issues were:frequency of maintenance, amount of grease to be used, and proper method of inspection.several meetings were held involving the axle manufacturer, (arvinmeritor), lubrication manufacturer (mobil), several trailer manufacturers and fleets.currently odi has data which indicates that 255 trailers from a certain build period have wheel ends failing at a higher rate than peer trailers with the same wheel ends.odi is upgrading this investigation to determine why the one group is failing at a higher rate than others with the same wheel ends.in order to resolve this matter, odi will be contacting the axle manufacturer, the bearing and grease manufacturers, fleets and will further investigate the issue with strick directly. | ||||||
EA03022 | STRICK CORPORATION | 11/12/2003 | 01/25/2005 | STRICK WHEEL-END FAILURES | ||
The closing of this investigation does not constitute a finding by nhtsa that no safety-related defect existed or continues to exist.further use of agency resources does not appear to be warranted.the agency will continue to monitor this problem closely and reserves the right to take further action if warranted by the circumstances.see attached technical report for full details. |