Sunnybrook Travel Trailer 2006

Model Travel Trailer made in 2006 by Sunnybrook got 1 consumer complain as well as 1 recall. Consumer complaints with reference to service brakes, electric. . There was one recall concerning equipment .

Model 2006

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
EQUIPMENT - RECREATIONAL VEHICLE
08V556000SUNNYBROOK RV INC.from 08/31/2004 to 03/30/2007V (Vehicle)958111/20/2008ODISUNNYBROOK RV INC.10/20/200810/23/2008
Defect SummarySunnybrook rv is recalling 9,581 my 2005-2007 fifth wheel and travel trailers equipped with a two-door refrigerator manufactured by the dometic corporation. the refrigerator may have a defect in the boiler tube. pressurized coolant solution could be released into an area where an ignition source (gas flame) is present.
Consequence SummaryRelease of coolant under certain conditions could ignite and result in a fire.
Corrective SummarySunnybrook rv will be working with dometic in order to repair these refrigerators (please see 08e032). dometic will repair these refrigerators by installing a secondary burn housing, a thermal fuse, and a melt fuse free of charge. dometic has retained stericycle inc. to manage this campaign. stericycle will assist the owner in locating dealerships or service centers and will provide assistance with scheduling of appointments. owners may contact dometic/stericycle at 1-888-446-5157 or sunnybrook rv at 1-574-825-7127.
NotesCustomers may also contact the national highway traffic safety administration

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, ELECTRIC
04/10/200920001
 I purchased a sunnybrook sunset creek #268 34 months ago. several days ago, i noticed some electric brake wires dangling under the trailer. upon inspection, i found that the plate that holds the brake assembly in place had come loose from the axle. all bolts were either broken or gone. i found 4 nuts in the casing. the brake plate was badly damaged from rotating on the axle spindle. then i noticed the brake plate on the axle in front of the bad axle plate was loose. after further inspection, i realized that this was a manufacturing defect, because someone did not tighten all the bolts to specs. this can be a very dangerous situation. #1 metal to metal friction can start a fire while going down the road. #2 brakes will not work under this circumstance. luckily, i caught this before something serious happened. even though this unit has a 2 year warranty, sunnybrook or the company supplying the axle or framework should repair this particular problem. it should be entered as a recall, because of the severity of the problem. i will check with my dealer tomorrow and see if i can get results. remember, this could have resulted in an accident or fire!!! *tr