Terex Tc

Model Tc made by Terex got 4 recalls. There was one recall concerning equipment .

Model 9999

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
EQUIPMENT
08E009000TEREX TELELECT, INC. E (Equipment)116702/07/2008MFRTEREX TELELECT, INC.01/25/200801/25/2008
Defect SummaryTerex is recalling 1,167 tc series aerial devices equipped with check valve, p/n 443847, installed from september 2001 until march 2007. the valve is located on the lower boom lift cylinder. failure can occur only when the vehicle is parked and the aerial device is in operation. the check valve is used in retiming of the boom when the platform is out of level. the flow through the check valve can cause the snap ring to fail if the retiming flow is abnormally high. the check valve components will flow into the lift cylinder if the snap ring fails.
Consequence SummaryDebris may scratch the cylinder wall or get into holding valves and cause the platform to drift down slowly, which could possibly result in serious injury or death to the platform user.
Corrective SummaryTerex will notify owners and replace the defective check valves free of charge. the recall began on february 7, 2008. owners may contact terex utilities warranty department by calling 1-605-882-4000.
NotesTerex recall no. cb579.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.
07E001000TEREX TELELECT, INC. E (Equipment)209903/22/2007MFRTEREX TELELECT, INC.01/04/200701/04/2007
Defect SummaryCertain terex telelect digger derricks and aerial devices equipped with check valves with p/nos engraved on the valve of; 1904f, 1908f, 1910f, and 1910r. these valves can fail which can cause the parts to move through the hydraulic system or will allow a vacuum to form in hydraulic lines if the pump flow should stop. these devices are installed on trucks to transport the aerial device or digger derrick to the work site to facilitate working on electrical power lines and communication lines or to trim trees.
Consequence SummaryFailure of the check valve can result in unexpected boom platform movement after the control lever is returned to the neutral position, or allow vacuum to form in hydraulic lines to the boom tip and could cause potential dielectric failure, possibly resulting in death or serious injury.
Corrective SummaryTerex utilities will notify owners and replace the check valves free of charge. the recall began on march 22, 2007. owners may contact terex utilities service department at 1-605-882-4000.
NotesTerex utilities recall no. cb 572.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.
08E008000TEREX TELELECT, INC. E (Equipment)406002/07/2008MFRTEREX TELELECT, INC.01/25/200801/25/2008
Defect SummaryTerex is recalling 4,060 tc, tcx, xm, rm, rmx, om, tm, ha, 6-series, and fc series aerial devices equipped with hydraulic rotary selector valves, p/nos 68698, 459713, 463130, 476618, and 9118243, manufactured between january 1996 and january 1, 2008. the valve is used on closed center, hydraulic system, aerial devices. failure can occur when the vehicle is parked and the aerial device is operating. the aerial devices are installed on trucks to transport the aerial device to the work site to facilitate working on electrical power lines and communication lines.
Consequence SummaryFailure of the valve may cause loss of oil, the handle being expelled at high speed, and the machine will be inoperable, which may result in serious injury or death to the operator.
Corrective SummaryTerex will notify owners and replace the defective hydraulic rotary select valve free of charge. the recall began on february 7, 2008. owners may contact terex utilities warranty department by calling 1-605-882-4000.
NotesTerex recall no. cb578.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.
07E028000TEREX TELELECT, INC.from 07/16/1996 to 02/01/2004E (Equipment)44606/01/2007MFRTEREX TELELECT, INC.04/27/200704/27/2007
Defect SummaryCertain terex aerial devices p/no. tc manufactured between july 16, 1996, and february 1, 2004, installed on trucks to transport the aerial device to the work site. tc model aerial units, with the end mount platform, have a leveling sprocket at the lower boom that can develop cracks in the arm which controls platform position. where the leveling cylinder attaches to the arm, it can crack near the counter sunk grease fitting and over time fatigue and fail.
Consequence SummaryIf the arm fails, the platform movement is not controlled and may dump the platform occupants.
Corrective SummaryTerex telelect will notify owners and repair the aerial units free of charge. the recall began on june 1, 2007. owners can contact terex at 1-605-882-4000.
NotesTerex recall no. cb 573.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.