Victory Vision 2008-2013

Model Vision made by Victory got 27 consumer complains there are 3 recalls as well as 6 service bulletins. Consumer complaints with reference, among others things, to brakes, engine and engine cooling and fuel system, gasoline. Technical service bulletines regarding electrical system, equipment and service brakes, hydraulic. There was one recall concerning electrical system .

Car model


Name Recalls Bulletins Consumer Complaints
Victory Vision 2008 3 6 27
Victory Vision 2009 0 3 20
Victory Vision 2010 0 0 2
Victory Vision 2011 0 0 11
Victory Vision 2012 1 0 0
Victory Vision 2013 1 0 0

Model 2008

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
ELECTRICAL SYSTEM - ALTERNATOR/GENERATOR/REGULATOR
07V510000POLARIS INDUSTRIES, INC.from 05/14/2007 to 10/01/2007V (Vehicle)32611/05/2007MFRPOLARIS INDUSTRIES, INC.11/01/200711/02/2007
Defect SummaryOn certain motorcycles, the voltage regulator/rectifier assembly may have an overcharging condition. an overcharging situation in conjunction with the loose battery connection could cause a stalling condition.
Consequence SummaryAn unexpected loss of engine power could cause a loss of control of the motorcycle increasing the risk of a crash.
Corrective SummaryDealers will replace the voltage regulator/rectifier and inspect both battery cables for tightness. the recall began on november 5, 2007. owners may contact polaris/victory at 1-888-704-5290.
NotesPolaris/victory recall no. v-07-01.customers may also contact the national highway traffic safety administration
ELECTRICAL SYSTEM - FUSES AND CIRCUIT BREAKERS
08V446000POLARIS INDUSTRIES, INC.from 05/14/2007 to 05/07/2008V (Vehicle)244409/23/2008MFRVICTORY MOTORCYCLE DIVISION09/03/200809/03/2008
Defect SummaryPolaris is recalling 2,444 my 2008 victory vision motorcycles. the terminal nuts that secure the main power supply wires could be loose at the circuit breaker, which can cause an unexpected loss of electrical power to the motorcycle. also the current fuel ignition map pre-programmed into the electronic control module (ecm) can cause engine stalling.
Consequence SummaryEither condition could cause the engine to stall, increasing the risk of a loss of control and a crash.
Corrective SummaryDealers will inspect and tighten the circuit breaker terminal nuts and re-program the ecm free of charge. the recall began on september 23, 2008. owners may contact polaris/victory at 1-888-704-5290.
NotesPolaris/victory recall no. v-08-03.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.
ELECTRICAL SYSTEM - IGNITION - SWITCH
08V131000POLARIS INDUSTRIES, INC.from 05/14/2007 to 03/03/2008V (Vehicle)158504/02/2008MFRPOLARIS INDUSTRIES, INC.03/20/200803/24/2008
Defect SummaryPolaris is recalling 1,585 my 2008 victory vision motorcycles. the electrical contact plate on the ignition switch base may not be properly secured to the ignition switch body, which can cause an unexpected loss of electrical power to the vehicle.
Consequence SummaryA loss of electrical power could cause the vehicle to stall, increasing the risk of a loss of control and a vehicle crash.
Corrective SummaryDealers will fully secure the ignition switch base to the switch body. the recall began on april 2, 2008. owners may contact polaris/victory at 1-888-704-5290.
NotesPolaris/victory recall no. v-08-01.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ELECTRICAL SYSTEM - BATTERY
V-07-0111/06/200710026228Victory motorcycles: regulator/rectifier replacement and battery cable bolt torque. a defect may exist in the regulator rectifier assembly which may cause an overcharging condition on affective motorcycles (vision street and tour).10/08/2008
ELECTRICAL SYSTEM - BATTERY - CABLES
V-07-0111/06/200710026228Victory motorcycles: regulator/rectifier replacement and battery cable bolt torque. a defect may exist in the regulator rectifier assembly which may cause an overcharging condition on affective motorcycles (vision street and tour).10/08/2008
ELECTRICAL SYSTEM - FUSES AND CIRCUIT BREAKERS
V-08-0309/22/200810026221Victory motorcycle: loose circuit breaker terminal nuts and ecm reprogramming for 2008 victory vision street and tour motorcycles. two possible defects exist on affected motorcycles that could cause the engine to stall. *pe10/08/2008
ELECTRICAL SYSTEM - WIRING - REAR COMPARTMENT/TRUNK
V-08-04-0104/29/200110026443Victory motorcycle: trunk light switch could cause battery discharge. *pe10/29/2008
EQUIPMENT - OTHER - LABELS
V-08-0209/25/200810026223Victory motorcycles: veci decal replacement: the veci decal on some 2008 model victory motorcycles has the wrong spark plug type listed. *pe10/08/2008
SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES
V-07-10-0110/17/200710026243Victory motorcycle: inadequate free play or other system problems. rear brake free play adjustment is accomplished by measuring the amount of clearance between the brake pedal and the foot rest support bracket. *pe10/09/2008

Consumer Complaints


Fail datemilesoccurencesPurchase date
BRAKES
06/02/2012
 In may 2011, i was contemplated riding my motorcycle after sitting for the winter (nov through may). as i checked the bike, i noticed that the brake pedal for the rear brakes had no pressure. i realized my motorcycle had no rear brakes. i called the dealer and was advised to bring the bike in and they would check it, and as a result, they had to bleed the brakes. afterwards, i didn't incur any problems with the bike for the remainder of the summer. during the winter months, again the bike was not used. last month, (may 2012) i took my bike for a ride, again, i experienced problem with the rear brakes. i called the victory dealer again and advised them of the same problem. once again, i was told to bring the bike in and they would bleed the brakes. the technician checked the brakes and then advised me that the master cylinder is bad.the bike has 11,300 miles. there is no leak coming from the brakes or brake lines. i feel that the braking system on these bikes are flawed, and hope that your agency can look into this matter before someone is injured. i implore you to investigate this matter after finding similar problems (during my research) with the master cylinder. i believe there is a defect with the master cylinder part and i would like to be contacted.
ENGINE AND ENGINE COOLING
05/25/200848501
 1. the events leading up to the failure: we were leaving a parking lot (private property) on a 2008 victory vision motorcycle. we had traveled about four feet when i attempted to increase the throttle. the throttle failed to open with the normal amount of torque. the parking lot was sloping to the left, that is, we were traveling across a slope. the loss of the needed increased forward momentum immediately caused a reduction in the stability of the motorcycle. the distance to the ground on the left side of the motorcycle was greater than the right , due to the slope. the loss of forward momentum reduced greatly the stability of the motorcycle. the motorcycle fell to the left. i was able to partially brace the fall with my left foot. neither my wife nor i suffered any injuries. i sprained my left ankle, and my wife hit her arm on the trunk. injuries did not require medical attention. my wife is a registered nurse. the design of the motorcycle caused very little damage and prevented my leg from being pinned beneath the motorcycle. 2. the failure, how often it occurs, its consequences: this is about the seventh or eight time it has occurred. it was first noticed and brought to the attention of the dealer following his replacement of a failed cylinder head. the consequences are a loss of forward momentum, endangering the stability of the motorcycle. it occurs on when attempting to open a closed throttle. a marked increase in the torque required to provide a given increase in engine speed is noticed. if caught off guard, it can require the operator to increase greatly the torque applied to the throttle, and require quick reaction. 3. what was done to correct the failure: it was returned to the dealer on three occasions. the dealer was unable to find the trouble. after the most recent attempt he said he tried, along with the manufacturer to find the problem. no parts were replaced or repaired. please refer to number 1. *tr
FUEL SYSTEM, GASOLINE
05/28/20101500
 Extreme fuel odor, especially after filling up with fuel. many have reported similar situation on various blog sites. gas cap seal may not seal tight.
POWER TRAIN - DRIVELINE
05/16/200823001
 Belt drive for 2008 victory vision motorcycle secondary sprocket does not stay tensioned. numerous complaints from many customers have been noted at dealerships. this issue will eventually lead to injury/damage if gone unchecked. my new motorcycle has been adjusted twice due to this issue and needs to be done again after only 1500 miles. symptoms include rear, right hand side squealing and/or chirping when the drive train is under load. similar reports have been made to several victory dealerships. professional victory technicians admit they have seen the problems but victory will not agree to replacement of defective sprockets. i am parking my motorcycle until this is resolved. recommend a bulletin that others do the same. thank you very much. *tr
SERVICE BRAKES
08/02/2012410001
 After bike sits awhile @2-3weeks there isn't any rear brakes,pedal goes to floor . i was able to pump them but they just go back to nothing just air.after bleeding brakes they seemed to work good but for how long i'm unsure ..after reading several complaints on line in reference to the same problem victory needs to take responsibility and recall this bike and correct the issue. ## vin passed ## victory vision premier tour model 2008 ## *tr
SERVICE BRAKES, HYDRAULIC
02/01/20116200
 After the bike sat for the winter, i found i had no rear brakes. the dealer bled the brakes and they worked fine for about 6 weeks and then went out again; they bled them again. when i rode the other day i noticed the rear brake pedal is going down again. i hate to think what would happen at 70 mph if someone pulled out in front of me and i had to stop quickly.
04/27/201156205
 Tl* the contact owns a 2008 victory vision. the contact stated that the rear brakes failed on numerous occasions. the air flow was entering through the brake line and causing the brakes to fail. the dealer was contacted who bled the brakes system and replaced the master cylinder to repair the failure. the manufacturer was not contacted. the failure mileage was 56,205.
04/27/201156205
 Tl-the contact owns a 2008 victory vision. the contact stated the rear brakes has failed on numerous occasions. the air flow was coming through the brake line causing the brake to fail. the dealer was contacted who bled the brakes system and replaced the master cylinder. the brake is now working fine. the manufacturer was not contacted. the failure mileage was 56,205...mw
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS
07/05/20093800
 Tl* the contact owns a 2008 victory vision motorcycle. while approaching a stop at 30 mph the brakes failed. the vehicle was taken to an authorized dealer for inspection on two separate occasions for the identical failures. the failures were contributed to air bubbles in the brake line. the vehicle was repaired for the malfunctions. the failure occurred after the service repair. the manufacturer was aware of the continuous failures; which there were no permanent repair. the failure mileage was 3,800. the current mileage was 4,8000.
STEERING
09/13/20118000
 Tl - the contact owns a 2008 victory vision motorcycle. the contact stated that while driving the vehicle at approximately 85 mph the front fender of the bike in rear portion vibrated and brake on the bender. this issue had happen previously and was repaired. in addition the front fender has a molding around and the plastic dislodges which does not allow the vehicle to turn left or right. the vehicle was taken to the dealer for diagnostic testing and the technician stated the rear fender would have to be replaced. also for the fender space, washers were placed temporaraly. the bike was not repaired. the approximate failure mileage was 8,000 and the current mileage was 47,238. dr
07/06/201136000
 Tl-the contact owns a 2008 victory vision motorcycle. while driving approximately 30 mph, there was a complete loss of steering power due to the partially detached front wheel support bolt. the vehicle was coasted to the side of the road. the rear fender was disabled and removed in order for the vehicle to be driven. the vehicle was taken to an authorized dealer who stated the front fender would need to be replaced. in addition, a new hardware mounting kit required installment. the similar failure occurred one year ago and the front fender mounting bolts were replaced. the vehicle had not been repaired because the part would not be available until november of 2012. the manufacturer was notified of the problem. the approximate mileage was 36,000. the vin was unavailable. kmj
07/06/201136000
 Tl-the contact owns a 2008 victory vision motorcycle. while driving approximately 30 mph, there was a complete loss of steering power due to the partially detached front wheel support bolt. the vehicle was coasted to the side of the road. the rear fender was disabled and removed in order for the vehicle to be driven. the vehicle was taken to an authorized dealer who stated the front fender would need to be replaced. in addition, a new hardware mounting kit required installment. the similar failure occurred one year ago and the front fender mounting bolts were replaced. the vehicle had not been repaired because the part would not be available until november of 2012. the manufacturer was notified of the problem. the approximate mileage was 36,000. the vin was unavailable. js
STRUCTURE - BODY
06/03/2011500001
 Riding 2 up at 25mph when steering locked up. it was determined the plastic rear portion of the front fender broke of and lodged into the engine cowl locking up the front tire. victory had no recall in place so i had to buy another fender. i later had a steel fender made after reading of other incidents of the same nature. *tr
06/03/201150000
 Riding 2 up at 25mph when steering locked up. it was determined the plastic rear portion of the front fender broke of and lodged into the engine cowl locking up the front tire. victory had no recall in place so i had to buy another fender. i later had a steel fender made after reading of other incidents of the same nature.
VISIBILITY
07/22/20086031
 Reflected sunlight off dash of vechile impedes andd obstructs clear vision of roadway thruogh windshield. *tr

Car dealers selling


StateCityZipNamePhone
FLFREEPORT32439DISTINCTIVE CYCLES850-835-5400